这些试样连同初始结果的平均值应不低于所要求的平均值。
The average value of these specimens together with the initial results shall not be lower than the required average.
当刹车比压和能载增加时，经过不同温度处理的四种试样干态及湿态平均动摩擦系数均相应下降。
The average dynamic FC of four kinds of samples treated under different temperatures was reduced in dry and damp condition as brake pressure and energy were raised.
研究结果表明：弱面的倾角、厚度及是否贯通等对试样的纵波速度、平均模量和强度具有显著的影响。
All studies show that weak plane inclination, thickness and whether be run through or not have a significant impact on longitudinal wave velocity, average modulus and strength of specimens.
裂纹传播平均速度由黏接在试样上的一系列裂缝计测量得到。
The average fracture propagation velocity is estimated with a series of crack gauges glued on the specimen.
金相显微组织分析表明，不同磁场退火处理后试样晶粒平均大小变化不大，而晶粒间不均匀程度增加。
Optical microstructure pictures show that the magnetic field have few effects on the mean grain sizes of samples through magnetic annealing, and the grain sizes vary drastically.
针对铝合金腐蚀平均速率与瞬时速率的差异，根据腐蚀过程中试样横截面的变化与欧姆电阻的对应关系，建立了新的腐蚀速率计算方法。
Based on the relationship between cross section variety and resistance of sample, a new formula was put forward to calculate the instantaneous corrosion rate of aluminum alloy.
对于测试样本低于25以下时，几何平均值比中位数能更好的报告最佳任务完成时间中间值。
The Geometric Mean works better than the median for reporting the best middle task time for sample sizes less than 25.
利用该曲线计算出了纳米不锈钢粉末烧结试样的平均晶粒度。
The mean grain size of stainless steel sintered from nano-sized powder was measured using these calibration curves.
CFD模拟结果表明，直管试样入口处局部流速比平均流速高约24%，表面剪切力大，与实验结果一致。
CFD simulation results show that the entrance velocity is about 24% higher than the local flow velocity, resulting into large surface shear force, is consistent with the experimental results.
针对铝合金腐蚀平均速率与瞬时速率的差异，根据腐蚀过程中试样横截面的变化与欧姆电阻的对应关系，建立了新的腐蚀速率计算方法。
WT5BZ Based on the relationship between cross section variety and resistance of sample, a new formula was put forward to calculate the instantaneous corrosion rate of aluminum alloy.
试样的平均直径随着有效围压的增长而单调减小。在此，有效围压被定义为围压和孔隙水压之差。
The average diameter decreases monotonically with increasing effective confining pressure, which is defined as the difference between confining pressure and pore water pressure.
试样表面的平均硬度及耐腐蚀性能均高于镁合金母材。
The surface has better properties including hardness and corrosion resistance than that of AZ31B.
试样表面的平均硬度及耐腐蚀性能均高于镁合金母材。
The surface has better properties including hardness and corrosion resistance than that of AZ31B.
应用推荐