根据度量值计算出平均值和标准偏差。
From the measurements, compute the mean and standard deviation.
对于每一个变量，平均值和标准偏差的结果。
For each variable, the mean and standard deviation results are presented.
那么，如果重复执行度量过程，平均值和标准偏差会有多大变化？
Then how different would the mean and standard deviation be if the procedure were repeated?
那么，如何用平均值和标准偏差判断两个任务中哪一个更快呢？
So, how can the mean and standard deviation be used to determine which of two tasks is faster?
使用平均值和标准偏差，您可以说明，68%的尝试是在 0.2秒到 1.3 秒之间。
Using the average and the standard deviation, you can interpret that 68% of the attempts were between .2 and 1.3 seconds.
几乎不用怀疑平均值和标准偏差会收到异常值存在的影响，而中间值和IQR所受到的影响则较小。
There is no doubt that both the mean and standard deviation are effected by the presence of outliers, while the median and IQR are much less impacted.
面板和三维介绍了发达国家市场，巴西和德国的描述性统计。对于每一个变量，平均值和标准偏差的结果。
Whereas Egypt and Germany show higher growth rates for non-family firms, Thailand and Brazil show higher growth rates for family firms.
样品测量：单样品自动测量，测量次数2、3、5、10、50次任意设定，测量结束给出平均值和标准偏差。
Measurement of sample: single sample automatic measuring, measuring the number of times 2, 3, 5, 10, 50 set, measured at the end gives the average value and standard deviation.
可能是正态分布，也就是高斯分布，只要有平均值和标准偏差值，你就可以进行调用，大部分的值都是集中在平均值附近的。
It could be normal, everything, that would be a Gaussian, where if you recall there was a mean, and a standard deviation, and most values were going to be close to the mean.
然后我在这里再写一个高斯分布的函数，它的浮动值的平均值和，标准偏差值都除了2。
And then I could also do a Gaussian one here, with the mean of and the standard deviation of volatility divided by 2.
开发的算平均值，残差，标准偏差，和总不确定度。
C development numerical average, residuals, standard deviation, and the total uncertainty.
这些工具完成对属性数据的频次、平均值、最小值、最大值和标准偏差的分析，并将结果存于一个新的表格中。
They perform frequency, mean, minimum, maximum, and standard deviation analysis on attribute data and save the results in a new table.
这些工具完成对属性数据的频次、平均值、最小值、最大值和标准偏差的分析，并将结果存于一个新的表格中。
This tool contains the following statistics types: sum, mean, minimum, maximum, standard deviation, range, first, and last. Available with any ArcGIS license.
这些工具完成对属性数据的频次、平均值、最小值、最大值和标准偏差的分析，并将结果存于一个新的表格中。
This tool contains the following statistics types: sum, mean, minimum, maximum, standard deviation, range, first, and last. Available with any ArcGIS license.
应用推荐