峰值速率的最大突发长度和最大数据单元大小不能超过65535。
Max burst length at peak rate and Max data unit size can not exceed 65535.
在实际环境中由于影响前向容量因素很多，实际中达不到前向峰值速率。
In real environment, forward throughput can not receive peak rate because many factors affect throughput.
文中使用峰值速率和突发时间长度来描述业务源特性，并据此动态地调节令牌速率。
The token rate is modified dynamically according to the peak rate and the burst time which characterize the source behavior.
输入为同峰值速率突发信源的突发级损失系统是AT M网络资源分配和呼叫允许控制研究中的一种重要排队模型。
Burst-level loss system input by bursty bursty with the same peak rate is an important queueing model in the study of resources allocation and call admission control in ATM networks.
它所预期处理的消息量是每天1,000,000条消息(后文将讨论峰值速率)，消息平均大小为3.5K(含消息描述符——MQMD)。
Its anticipated message volume is 1,000,000 messages per day (peak rates are discussed later), with an average message size of 3.5k including the message descriptor (MQMD).
当评估队列深度要求时，消息处理速率和峰值消息量同样重要。
When you evaluate queue depth requirements, message processing rates are just as important as peak message volumes.
在2006年，使用Panasas早期并行文件系统的Roadrunner的传输速率峰值是1.6 GB每秒。
In 2006, Roadrunner demonstrated a peak 1.6 gigabytes-per-second transfer rate using an early version of Panasas's parallel file system.
弱势粒直链淀粉、支链淀粉、总淀粉积累速率均在花后20～25天达到峰值。
The accumulation rate of amylose amylopectin total starch in weak grains all reached peaks on20-25th daa .
随施磷量增加，氨挥发速率峰值增高。
The peak of ammonia volatilization rate increased with the increase of phosphorus fertilizer application.
脉冲电压峰值和放电频率与臭氧生成速率均几乎有线性关系。
The ozone formation rate increased linearly with increasing pulsed peak voltage and discharge frequency.
在实验升温速率增大情况下，该峰值将向高温区移动。
The thermoluminescence peak moves to the high temperature when the heating speed increasing.
弱势粒直链淀粉、支链淀粉、总淀粉积累速率均在花后20～25天达到峰值。
The accumulation rate of amylose, amylopectin, total starch in weak grains all reached peaks on 20-25th DAA.
应变速率对峰值应力的影响与变形温度有关。
Effect of strain rates on peak flow stress is relate to deformation temperature.
随着冷却速率的提高，达到析出量峰值的时间越短，析出量和析出粒子的平均直径均减小。
The faster the cooling rate and the shorter the time to reach the precipitation amount peak value, the smaller are the precipitation amount and the mean diameter of particles.
实验结果表明，在一定范围内增大衍射延迟速率可以缩短脉冲建立时间，缩短脉冲宽度，增加峰值功率。
The experimental results show that a bigger diffraction efficiency delay rate can make the establishing time of the laser pulse and the pulse width shorter, and make the peak power higher.
总数据速率峰值极限必须大于或等于每一数据流数据速率峰值极限。
Total peak data rate limit must be greater than or equal to per flow peak data rate limit.
DSC曲线的峰值温度也随升温速率的增加而增加。
The temperatures of peak on the DSC curves increase with the increase of heating rate.
每一数据流数据速率峰值极限必须大于或等于每一数据流数据速率极限。
Per flow peak data rate limit must be greater than or equal to per flow data rate limit.
随升温速率的提高，生物质的最大热解速度提高，对应的峰值温度升高，最终失重率呈下降趋势。
With the rise of heating rate, the maximum decompose rate and its corresponding temperatures of biomass increases, but the final agravic quotient decreases.
总数据速率峰值极限必须大于或等于总数据速率极限。
Total peak data rate limit must be greater than or equal to total data rate limit.
对应于磁阻抗峰值的频率随快淬速率的增加而趋于高频，这归因于薄带厚度减小的缘故。
The frequency where maximum magnetoimpedance occurs shifts to high frequencies with an increase of quenching speed, which is attributed to the drop of ribbon thickness.
随着冷却速率的提高，达到析出量峰值的时间越短，析出量和析出粒子的平均直径均减小。
The faster the cooling rate and the shorter the time to reach the precipitation amount peak value, the smaller…
结果表明：实验条件下，流变应力及峰值应变随变形温度的降低和应变速率的提高而增大。
The results show that the flow stress and peak strain increase with increasing strain rate or decreasing deformation temperature.
试验结果表明，流变应力和峰值应变随变形温度的降低和应变速率的提高而增大。
The results show that the flow stress and peak strain increase with either increasing strain rate or decreasing deformation temperature.
血氨与运动强度关系密切，相对运动强度越大，血氨峰值越高，血氨的肌血弥散速率越快，恢复亦越快。
The blood ammonia has a close relation with exercise intensity. The greater of relative exercise intensity is, the higher of blood ammonia peak, the faster of dispersion speed in mu…
神经网络可以预测不同应变下的相应的流变应力，但是本构方程只可以根据不同的应变速率和温度来预测峰值应力。
And ANN model could predict the corresponding flow stress at different strain, but constitutive equations could only predict the peak stress depending on different strain rates and temperatures.
在此基础上，根据本文提出的曲线叠加法采用计算机就可以容易地得到发生火灾时室内总的热释放速率曲线和热释放速率峰值。
In this foundation, the method of curve superposition proposed by this article may easily obtain the total HRR curve and peak value of HRR by computer when a fire occurs in the room.
在此基础上，根据本文提出的曲线叠加法采用计算机就可以容易地得到发生火灾时室内总的热释放速率曲线和热释放速率峰值。
In this foundation, the method of curve superposition proposed by this article may easily obtain the total HRR curve and peak value of HRR by computer when a fire occurs in the room.
应用推荐