建立了该钢的高温屈服应力模型。
The high temperature yield stress model of the steel has been set up.
不同屈服应力定义对强化规律的影响；
The effect of the definition of yield stress on hardening rules.
剪切屈服应力被定义为Y轴上的交会点。
Shear yield stress was defined as the intercept point on the Y-axis.
磁流变液的屈服应力对温度具有很好的稳定性。
The yield stress of our MR fluid is of good thermal stability.
选用旋转流变仪测定了锂基润滑脂的屈服应力。
Rotated rheometer was used to determine the yield stress of lithium lubricating grease.
同时，溶液表现出明显的屈服应力和良好的剪切稀释性。
At the same time, the HAWP solutions appeared strong flow stress and obvious shear thinning phenomenon.
不同屈服应力定义对初始屈服曲面的后继屈服曲面的影响；
The effect of the definition of yield stress on the initial and subsequent yield surfaces.
一定条件下溶液同时表现出粘弹性质，但无屈服应力的存在。
The solution showed viscoelastic behavior in dynamic conditions and no yield stress was observed.
变形速度对材料流动、初始屈服应力、流动应力影响不明显。
Deformation velocity has no obvious effect on the flow of material, initial yield stress and flow stress.
其应力分布非常复杂，而且有超过材料屈服应力的应力峰值。
The stress is very complex and may reach to a peak value exceeding the yield stress of the material.
含钒钢因相变开始温度低，其屈服应力快速增加的温度较低。
The yield strength of vanadium bearing steel improves at lower temperature because of low phase transformation starting temperature.
粘弹性与胶凝温度、胶凝强度、屈服应力和触变性等参数有关。
Viscoelasticity is related to some properties such as gel point, gel strength, yield stress and thixotropy.
该研究改变了材料的屈服应力和延伸率只能凭实验确定的局面。
The research will change the phenomenon that yield stress and elongation are only decided on the basis of experimental result.
与单轴压缩相比较，双轴压缩的弹性模量和屈服应力有明显的提高。
Comparing with the uniaxial compression, the Young's modulus and the yield stress of the biaxial compression increase obviously.
容器爆破压力是容器屈服应力和最大事件(爆炸)压力之间的平均数。
Vessel burst pressure is the mean between maximum event (explosion) pressure and the yield stress of the vessel.
分析结果可作为进一步讨论电流变液屈服应力以及临界电场强度的基础。
The result can be used in further study about the yield-stress and critical electric field strength.
更为主要的是该模型还可以用于解释泡沫压裂液的屈服应力和壁面滑移现象。
Especially, this model can also explain the yield stress and wall slip phenomena for foam fracturing fluid.
文中用带屈服应力的假塑性流体描述驱替液性质，用宾汉流体描述原油性质。
The displacing fluid of power law fluid with yield stress and displaced fluid of Bingham are used to illustrate these effects.
剪切屈服应力是磁流变流体固化强度的重要指标之一，具有重要的工程意义。
The magnitude of the yield stress of magnetorheological fluids is important for engineering applications.
介绍了动屈服应力在含蜡原油低温输送和含蜡原油停输后再启动过程中的应用。
Introduced arc the applications of dynamic yield stress in low temperature transportation as well as in the course of restart after shutdown of the waxy crude oil transport system.
根据锂基润滑脂的流变性质，采用稳态、瞬态和动态实验等方法测定了屈服应力值。
Based on the rheological behaviour of lithium lubricating grease, the steady-state, transient-state and dynamic-state flow experiments were selected to obtain yield stress value.
应用有限元方法建立了可考虑屈服应力温度相关效应的粗糙表面热弹塑性接触模型。
A thermal elastoplastic contact model which can take into account the effects of temperature-dependent yield strength was developed by using finite element method.
如果土体应力超过其屈服应力，则土障将出现不可恢复的塑性应变，甚至导致破坏。
The irreversible inelastic strains will occur as the stresses reach to critical yield surface, even result in the failure of the clay barrier.
结果表明，随筛板孔距的增加，其拉伸强度、拉伸屈服应力及拉伸断裂应力均提高；
The results showed that tensile strength, tensile yield stress and tensile breaking stress were increased with the increase of bore distance;
结果表明，（1）PS能提高未增韧PVC体系的冲击强度，但导致屈服应力下降；
The result showed(1)The impact strength of untoughened PVC could be improved by PS, but resulting in a decrease of tensile strength at break.
提出了修正后的金属体积分数理论，准确预测了材料的弹性模量、屈服应力及拉伸强度。
A modified theory of metal volume fraction is put forward to precisely predict tensile properties including elastic modulus, yield stress and tensile strength.
本文对表面微观屈服应力的测量与计算方法及表面变形的应力应变曲线进行了分析研究。
The calculation of micro-yield stress in surface layer and the stress-strain curves of surface layer deformation were studied.
试验结果表明，桥面板试件的屈服应力小于材料的材料屈服强度，设计中应该加以考虑。
The results of the tests show that the yielding stress of the tested panel is less than the yielding strength of the material, which should be appropriately considered in the design.
电流变液屈服应力方程中，参数以2.0为界，和时，离合器动力学特性具有显著区别。
The demarcation point of, which is the parameter in ERF's yield stress equation, is 2.0. For, the dynamic characteristics of the clutch are remarkably different from those for.
结果显示，微珠含量及其直径对复合物的拉伸屈服应力和屈服发生时的应变影响不太明显。
The results show that the influences of the glass beads content and its diameter on the tensile yield stress and strain at yield are not significant.
应用推荐