在过去的50年一副的尺寸变化很大。
The sizing of clothing has changed drastically over the last 50 years.
这些尺寸变化是受法则约束最小。
These dimensional changes are subject to the law of the smallest constraint.
印刷滚筒大小可更换以达到印刷尺寸变化。
Printing cylinder size can be changed to achieve printing size change.
根据采用砂轮的磨削工艺,这些尺寸变化很大。
These dimensions vary widely, depending upon the grinding process for which the wheel is to be used.
用于毛织物、织物面料经汽蒸后尺寸变化的试验。
Used for testing the size change of wool fabric and woven fabric after steam.
讨论了晶粒尺寸变化和大晶粒形成的原因和机制。
The size inerease of particles and forming mechanism of large diamond particles were discussed.
智能电感测微仪是测量微小尺寸变化的精密测量仪器。
The intelligent inductive micrometer is a new type of micrometer with high accuracy for measuring micro size.
图片定义的区域在图片尺寸变化的时候可以被拉伸或重复。
Defined areas of an image can be stretched or repeated when an image dimension changes.
女人的大脑(平均要比男人的大脑小一些)也经历着同样的尺寸变化。
Women's brains, which are smaller on average than those of men, have experienced an equivalent drop in size.
介绍球铁冷却、凝固过程中的体积变化以及型腔尺寸变化。
An introduction was made to volumetric changes of castings and dimension changes of mold cavity occurring during liquid cooling and solidification of nodular iron castings.
基于虚拟原点概念推导了运动过程中射流径向尺寸变化规律。
The radius variation of the jet in the motion process is deduced based on the virtual origin concept.
在消失模铸造过程中,模样尺寸变化直接影响铸件的尺寸精度。
The changes of pattern size directly affect the dimensional accuracy of casting in the EPC process.
为防止水洗尺寸变化进行预缩处理,从而获得了理想的染色效果。
Preshrunk process should be carried out for dimensional stability, so ideal dyeing results are available.
葡萄果实尺寸变化能用来评价葡萄生长及诊断植株水分亏损状况。
Fruit size variations could be used to describe grape growth and detect water deficit stress.
允许的尺寸变化量是考虑到了最大和最小平均直径公差的测量平面。
The permissible diameter variation (Vdmp, VDmp) is the tolerance for the maximum and minimum mean diameters of one measuring plane.
它是指感光材料由于湿度和温度的变化以及冲洗和老化引起的尺寸变化。
It fingers light sensitive materials because of humidity and temperature changes as well as swash and aging caused the size changes.
分别计算3块试件纵向或横向的尺寸变化率的平均值作为纵向或横向试验结果。
Take the mean value of dimensional change rate of the 3 test pieces in longitudinal or transverse directions as the test result.
请注意轴承尺寸变化也将影响式(9)中的寿命比,以及相应的式(10)中的。
Note that bearing size variation will also affect the life ratio of equation (9) and the corresponding of equation (10).
探讨宏观尺寸变化的根本原因,为改善人工林杉木木材尺寸稳定性提供理论依据。
Eventually, the cause of wood dimension unstability was investigated to provide substantial data for improving dimensional stability of wood.
低成本的粘结剂处理预混粉其尺寸变化、稳定性和力学性能与扩散粘结混合粉相同。
The binder treated premixes reproduced the dimensional changes, consistency and mechanical properties of the diffusion bonded blends at lower costs.
从电合成实验和纳米热力学两方面,考察二氧化钛热处理时的相态和尺寸变化规律。
From both electro-synthesis experiments and nanothermodynamics, the phase states and size changes of heat-treated titanium dioxide powders, synthesized by direct electrolysis, are investigated.
不是说他们设计的不好,而是因为这些精心设计的网页难以适应显示器的尺寸变化。
The design was well done but it just didn 't seem to fit the screen.
陶瓷坯体具有尺寸变化率小,密度较高且均匀,足够的脱模强度,表面质量好等特点。
The ceramic green body is characterized by little dimensional change rate, high green body density, high homogeneity, sufficient strength for demoulding and good green body surface quality.
坯体具有足够的脱模强度、较高的密度均匀性和合适的孔隙率以及尺寸变化率小等特点。
The composite green body is characterized by sufficient strength for demoulding, high density homogeneity, appropriate porosity and little dimensional change rate.
同时利用单拐曲轴的计算方便,计算量小的特征,分析了曲轴的结构尺寸变化对应力的影响。
Meanwhile analyze affection to stress from different structure and size. This take advantage that it is convenient to calculate with single-throw crankshaft and have a little work of calculation.
根据轴向体积流动规律导出了法兰环件轧制尺寸变化规律和其各种轧制用毛坯的体积分配规律。
The volume flow amount is also calculated. The dimension variation law for rolling flange ring and the volume distribution law for its rolling blank are derived from the axial volume flow.
因此,在粉末冶金工艺中,对尺寸变化尤其是对模具尺寸的设计进行控制与预测是非常重要的。
Accordingly it is very important to control and forecast the dimension change and the geometric shape variation of the final product in the powder metallurgy process, especially the design of mould.
测定了矫直前后钢轨外形尺寸变化(包括轨头宽度、轨高、钢轨长度),分析了轨高减少的原因。
The contour size changes of rail before and after straightening, involving width of rail head, rail height and rail length, were measured. The causes of rail height decrease were analyzed.
通过两个包括亮度和尺寸变化以及目标的严重突变运动的红外序列,验证了提出的跟踪算法的有效性。
The proposed tracking method is demonstrated through two real infrared image sequences, which include the changes of luminance and size, and the drastic abrupt motions of the target.
通过两个包括亮度和尺寸变化以及目标的严重突变运动的红外序列,验证了提出的跟踪算法的有效性。
The proposed tracking method is demonstrated through two real infrared image sequences, which include the changes of luminance and size, and the drastic abrupt motions of the target.
应用推荐