通过外部电路就可以利用这一点来导通电流。
That can be used to drive a current through an external circuit.
对雷达产生浪涌信号的一个典型电路进行仿真，得出模拟电路产生浪涌的一个重要原因是晶体管的瞬间导通电流过大。
Based on the simulation research of the typical radar analog circuit, it is shown that the main reason of the emerging surge signal is the high transient current conducted in the transistor.
晶闸管逆变弧焊电源具有单管导通电流大、耐压高、正向压降低、过载能力强等特点，但在使用过程中会出现各种故障。
Thyristor inverter welding power source with single-conduction high current, high breakdown voltage, low positive voltage drop and the high over load etc.
同时对无位置传感器的全导通电流斩波方案在开关磁阻发电系统中的应用进行了分析与研究。最后针对上述控制方案进行了较全面的实验验证。
Finally, two novel control schemes, exciting voltage control and full conducted current chopping control, are discussed in detailed and proved by tests of SRG prototype system.
高效发电机。一种发电机系统包括三相ac电机和应用低导通电阻MOSFET开关的有源整流器电桥，用于将来自电机的AC电流转换为DC电流。
A generator system that includes a three-phase ac machine and an active rectifier bridge employing low on-resistance MOSFET switches for converting the ac current from the machine to a DC current.
特点：采用PLC程控，配置日本米亚基ct- 110焊接控制器，三段通电方式，具有电流缓升缓降功能。采用焊接变压器次级反馈控制电流及导通角控制。
Features: PLC programming, equip with Japan Miyachi CT-110 welding control device, three segments electrification method, with current slow increasing and slow dropping function.
特点：采用PLC程控，配置日本米亚基ct- 110焊接控制器，三段通电方式，具有电流缓升缓降功能。采用焊接变压器次级反馈控制电流及导通角控制。
Features: PLC programming, equip with Japan Miyachi CT-110 welding control device, three segments electrification method, with current slow increasing and slow dropping function.
应用推荐