这些蒸汽工况对汽轮机涡轮喷气发动机提出了新的要求。
These steam conditions put new requirements on the steam turbine turbojet.
对汽轮机基座的安全性作了分析。
Also, the safety of the turbine generator foundation is analysed.
固体颗粒磨蚀对汽轮机的危害不可忽视。
汽缸的热应力，对汽轮机的运行安全很重要。
Thermal stresses in a turbine casing are important for safety operation.
这种新的蒸汽工况对汽轮机组提出了新的要求。
This steam conditions put new requirements on the steam turbine turboset.
蒸汽湿度对汽轮机的安全性和经济性有着重要的影响。
Steam wetness has great influence on safety and efficiency for steam turbine.
根据生产实践，对汽轮机叶片用钢标准进行了分析和探讨。
Based on the production practice, the standard of blade steel for steam turbine has been analyzed and discussed.
论述了对汽轮机、发电机转子和定子的理论计算和改造方案。
The theoretic calculation and retrofit scheme for turbine, rotator and stator of generator are discussed.
介绍用蒙特卡洛法对汽轮机调节系统的静特性进行计算和分析。
Calculating the static characteristic of turbine governing system with the Monte Carlo method is introducing.
对汽轮机断裂叶片进行了金相组织观察、断口扫描及能谱分析。
Metallographic observation, fracture scanning and energy dispersion spectrum analysis on the fractured turbine blade were carried out.
轴位移保护的故障对汽轮机机组安全稳定的运行具有很大的危害。
Failure of axis displacement safeguard, bring about harmfulness for safety and stable operation of the steam-turbine suit.
本文推论并总结了对汽轮机高压转子进行低周疲劳计算的方法和步骤。
The method and step of the calculation of the low cycle fatigue for the high pressure rotor of a steam turbine are introduced and summarized.
从汽轮机能量平衡的角度出发，对汽轮机相对内效率两种定义方法进行了分析。
Firstly, two defining methods of relative internal efficiency for steam turbine are analyzed from energy equilibrium.
本文通过设计制作1：10模型对汽轮机发电机组弹簧隔振基础进行试验研究。
Through building a 1:10 model of spring vibration isolated turbine-generator foundation, this paper study it by modal test.
为了对汽轮机同步器的精确、可靠的控制。改变了传统的磁放大器连续调节思路。
In order to control the synchronizer of turbine exactly and reliably, it must be changed the continuous adjustment used magnetic amplifier in conventional idea.
通过对汽轮机快冷系统的分析，针对所存在的问题提出了对快冷系统的改进措施。
Through analysis of the fast-cooling system of steam turbines, directing against some existing problems, an improving method for the fast-cooling system has been put forward.
本文对汽轮机组事故发生频率最高之一的进水事故危害、发生原因及预防进行了阐述。
This paper introduced harm, cause and preventing of accidents of feeding water at the turbine.
提出对汽轮机及其辅助系统进行设备初步划分的原则，并给出分系统级设备划分的示例；
The principle to divide steam turbine and its assisting equipment & systems has been put forward. At the same time an example has been given to demonstrate the principle. The method using availabi…
凝结水中氧的质量浓度高低是显示凝结水水质的重要指标，对汽轮机的热力循环影响很大。
The mass concentration of oxygen in condensate is an important indicator to show the condensate quality, and it has great influence on thermal circulation of steam turbines.
针对汽轮机的本身特点和安全评价内容，提出了两种安全评价方法对汽轮机进行安全评价。
According to the structure characteristics and safety assessment contents, two kinds of safety assessment methods are put forward.
本文对汽轮机能损分析中的对比工况、计算方法以及动态工况等问题提出看法和改进意见。
Some problems are discussed in this paper about energy loss analytic system, where the standard working status, the calculating method of energy loss and calculating of dynamic process are included.
从汽轮机组和凝汽器的热平衡入手，对汽轮机性能老化后低压缸排汽点变动方向进行了研究。
Starting with the heat balance of steam turbine unit and condenser, the study is carried out on changed direction of exhaust steam point after turbine performance aging.
为对汽轮机热力性能评估，本文给出了汽轮机预期性能的计算及对汽轮机运行性能的评价方法。
An expected performance calculation and assessment method of running steam turbine was also proposed in the paper.
在湿空气平面叶栅缝隙抽吸试验装置上，对汽轮机空心静叶抽吸缝隙的去水性能进行了试验研究。
On the slot suction test rig of a humid-air plane-cascade, an experimental study was conducted of the water removal performance of the suction slots on hollow stationary blades of a steam turbine.
固体颗粒磨蚀对汽轮机的危害不可忽视。减少颗粒、防磨镀层和将颗粒引向旁路是目前采用的三种解决方法。
Solid particle erosion may damage the turbogenerator sets. Minimizing particles, wear-proof covered layer and by pass are three effective approaches for Minimizing solid particle erosion.
本文通过对汽轮机转子进行离线的有限元分析，建立了转子应力监测与寿命管理系统，研制开发了在线运行软件。
Based on the off-line finite element analysis of turbine rotors, the rotor stress monitor and life management system is built up and on-line application software developed.
通过对汽轮机通流部分改造过程介绍和改造后的经济性分析，提出进一步提高125 MW机组经济性的看法和建议。
This article introduces the retrofitting process the economics of retrofitted steam turbine and finally puts forward the views and proposals for further improving the economics of 125 MW unit.
通过对汽轮机通流部分改造过程介绍和改造后的经济性分析，提出进一步提高125 MW机组经济性的看法和建议。
This article introduces the retrofitting process the economics of retrofitted steam turbine and finally puts forward the views and proposals for further improving the economics of 125 MW unit.
应用推荐