实验测量系统证明了结论的正确性。
The conclusion is proved with and experiment measurement system.
并给出了驱动电流的稳定度实验测量。
We also give an experiment measurement of output current stability.
最后给出了损耗钮扣的实验测量结果。
Finally, the experimental results for measuring the loss button are given.
那是我们通过实验测量的。
计算结果得到了激光实验测量结果的验证。
The calculated results are verified by the measured results of laser experiments.
实验测量表明单个同轴探针与圆波导匹配良好。
Experimental measurements present that single coaxial line probe matches with circular waveguide very well.
微管实验测量了粘附频率对接触时间的依赖关系。
The dependence of binding frequency on contact duration was measured.
对电流谐波进行理论分析和实验测量，二者结果吻合。
Theoretical analysis and experimental measurement for current harmonics, the results are agreement.
根据脉象信号的实验测量数据对模型参数进行了估计。
The model parameters are estimated with the clinical data of the human pulse condition signals.
在模拟矿井提升的工况下，实验测量闸瓦的动摩擦系数。
Experimental testing is used to measure the dynamic frictional coefficient of the brake-tile on the working condition of simulated promotion.
模拟结果和实验测量结果表明该方法是可行的和有效的。
The results of computer simulation and experiment both show that the method is feasible.
实验测量了在设计转速下该风机全工作范围的性能参数。
The performance parameters at the design speed are measured in the experiments.
中子小角散射实验测量和原始数据的处理方法相对较复杂。
The process of SANS measurement, and the raw data reduction, is relatively complicated.
理论计算出的几个光电流峰位置与实验测量的结果符合较好。
The calculated positions of several photocurrent peaks are in good agreement with the experimental results.
本工作涉及充气飞行时间探测器的工作原理和实验测量结果。
The paper concerns in the principle and the experimental results of gas-filled time-of-flight detector.
本工作涉及充气飞行时间探测器的工作原理和实验测量结果。
The paper concerns in the principle and the experimental results of gas-filled time-of-flight(GF-TOF) detector.
相同条件下爆炸超压峰值的计算结果与实验测量结果符合较好。
The computational results of explosion overpressure are in good agreement with experimental results on the same conditions.
通过实验测量同温度下饱和戊二酸酯的密度、粘度、折光率、闪点。
The density, viscosity, refractive index and flash point of glutarate were measured at the same temperature.
结果表明：实验测量得出的轻质麦秸复合墙体传热阻比理论计算值大；
The results indicate that the heat-transfer resistance of experiment is bigger than theory.
设计单波长准直光透射实验并通过实验测量组织模拟样品的总衰减系数；
Single wavelength collimation transmittance experiment is designed and conducted, with total effective attenuation coefficient of tissue phantoms being obtained.
最后进行了模拟试验，并对排水管模拟实验测量结果进行了分析和讨论。
Finally has carried on the analysis and the discussion to the discharge pipe modelling measurement result.
通过对照带结构计算和超声实验测量，我们检验了这种计算方法的有效性。
The validity of this method is checked by both band structure calculations and transmission measurement of ultrasonic experiment.
并用拉压传感器对电动斥力进行了实验测量表明计算方法和结果是正确的。
Measuring the repulsion force with a quartz force transducer, it demonstrates and verifies that the calculation method and results are reliable.
同时将小斜率近似与考虑遮蔽效应的基尔霍夫近似和有关实验测量结果作了比较。
The results by the small slope approximation are also compared with that of the Kirchhoffapproximation with shadowing effect considered and the experimental data.
同时将小斜率近似与考虑遮蔽效应的基尔霍夫近似和有关实验测量结果作了比较。
The results by the small slope approximation are also compared with those of the Kirchhoff approximation with.
使用有限元法计算穿孔管消声器的传递损失，并与实验测量结果进行了比较，二者吻合良好。
The predicted transmission loss of perforated tube silencers using the finite element method and experimental results are compared and showed good agreement.
文中通过实验测量和模拟计算，得到了不同气压湿度下的正直流电晕起始电压和电晕离子电流。
It was obtained through experiment and simulation that positive DC corona inception voltage and corona ion current under different air pressure and humidity conditions.
计算结果与实验测量结果的比较分析可以证明这种计算方法是合理的，能够获得十分准确的结果。
The calculational results and the experimental are well conformed. It proves that this method above is reasonable and accurate results can be got.
分析了电梯能耗的组成及其特点，提出了一种新的基于实验测量和理论推算的计算电梯能耗的方法。
The paper analyzes composition and characteristics of elevator energy consumption, and proposes a new energy consumption calculation method based on test measurement and theoretical calculation.
分析了电梯能耗的组成及其特点，提出了一种新的基于实验测量和理论推算的计算电梯能耗的方法。
The paper analyzes composition and characteristics of elevator energy consumption, and proposes a new energy consumption calculation method based on test measurement and theoretical calculation.
应用推荐