结果表明：实验和数值模拟的误差率为3。
Results show that the error rates between the numerical simulation and the experiments are 3.
利用室内实验和数值模拟研究火烧油层采油过程中的燃烧及传热机理。
With laboratory experiment and numerical simulation, the mechanisms of combustion and heat transfer during oil production of in-situ combustion are studied.
从实验和数值模拟两方面对爆炸载荷对水泥试样的损伤破坏进行了研究。
The cement samples damage and fracture by exploding load was studied by experiment and numerical simulation method.
本文用实验和数值模拟的方法，比较了不同重力下有限空间内热薄材料表面的逆风传播火焰。
In present paper, opposed-flow flame spread over a thin solid material in narrow channels in different gravity was compared experimentally and numerically.
本文从实验和数值模拟两方面，对静止和旋转增程固体火箭发动机补燃室燃烧流场进行了研究。
The combustion flow field in secondary combustion chamber for static and spinning extended solid rocket ramjet were studied experimentally and numerically in detail.
采用全尺寸实验和数值模拟两种方法对大空间火灾单侧不对称补气条件下的机械排烟进行了分析。
Full-scale burning test and numerical simulation were carried out to investigate the mechanical exhaust in large space fire with one-side unsymmetrical air supply.
本文对工字型GFRP梁进行室内实验和数值模拟，对GFRP梁的受力性能和破坏形态进行了研究。
This paper conducted indoor experiment and numerical simulation to H-shaped GFRP beam, and studied the mechanical properties and failure form.
本文通过采用实验和数值模拟的方法，研究了喷动流化床内气体混合特性以及床内气固两相的流动特性。
The dissertation studies the characteristics of gas mixing and the gas-solid two phases flow in spouted-fluidization bed with experiment and numerical simulation methods.
首次通过实验和数值模拟方法研究了具有冷却壁面条件时的下送风通风空调系统的气流流动特性及其影响。
Through experimental and numerical simulation researches on the influence of cooling wall on the ventilation characteristics and the air flow characteristics of UFAD system firstly.
本文从实验和数值模拟两方面对温压炸药的爆炸特性进行了研究，重点研究了有限空间内爆炸冲击波参数。
The explosion effects of thermobaric explosives, especially the parameters of the blast wave in a confined space, are studied both experimentally and numerically.
板料成形过程中工艺辅助面对成形件质量有着重要意义，但其设计非常费时并且需要根据实验和数值模拟结果不断修正。
The addendum surfaces are very important for the product quality in sheet forming process, but their design is very time-consuming and requires tedious trial-error corrections.
利用室内岩心实验和数值模拟方法，研究了可动凝胶体系的成胶行为、渗流机理和影响因素，给出了矿场试验设计方案。
The formation behavior, flow mechanism and influence factors of the flowing gel system were experimentally investigated, by means of core test and numerical simulation method.
通过长岩心驱替实验和数值模拟研究，对葡北油田在注水、水气交替、气水交替、注气驱替方式下的开发效果进行了对比研究。
By long core displacement experiment and numerical simulation, has made comparative analysis of development effect for injection water, WAG, GAW, and injection gas in PuBei oil field.
国内外对喷嘴喷雾的实验和数值模拟已经开展了相当多的研究，但喷嘴在横向流流场中雾化的影响因素还是一个较新的研究课题。
Both at home and abroad, many researches have been carried out to study the spray field, but the influencing factor of atomizer in cross flow is still a relatively new research topic.
为了进一步研究吸能器的机理，采用实验和数值模拟相结合的方法，对冲击载荷作用下6060t 5铝圆环列系统的动力学行为进行了研究。
The dynamic behavior of 6060t5 aluminum ring systems subjected to impact loading was experimentally and numerically studied to confirm the energy absorption mechanism of ring systems.
对一种轴对称形式的高超声速飞行器全流道开展了风洞实验和数值模拟研究，分析了不同来流总压、飞行攻角全流道的流场结构和气动力特性。
This paper presents a numerical simulation of separated flow over an airfoil at large attack angles with oscillating excitations to study separation flow control over an airfoil.
通过理论分析、实验测量和数值模拟，研究高超声速粘性相互作用对实验段自由流静压测量的影响。
Hypersonic viscous interaction effects on measurement of free stream pressure in test section are studied through theoretical analysis, experiment measurement and numerical simulation.
通过实验测量和数值模拟研究了大容量锅炉的炉内流场特性。
The in furnace flow field characteristics of a large sized boiler were studied by way of experimental measurements and numerical simulation.
最后，本文进行了实验研究，验证了链条滚子精密成形工艺方案的可行性和数值模拟的可靠性。
Finally, in thesis, practical research has also been done, which demonstrate the feasibility in plan of the precise forming technology of chain roller and the reliability of numerical simulation.
本文通过室内实验和数值计算，对层状土中降雨补给浅层地下水问题进行模拟。
The problems of water infiltration into layered soil and groundwater recharge are simulated through laboratory experiments and numerical method.
研究方法有风洞实验、理论分析和数值模拟。
It is concerned in wind tunnel test, analytical analysis and numerical simulation.
目前自然通风主要有三种研究方法：简单的理论分析法、实验法和数值模拟法。
There are three main research methods in natural ventilation: simple theory analyse method, experimental method and numerical simulation method.
采用实验研究和数值模拟的方法，分析了工件预加工孔径和孔型参数对厚壁筒体翻孔工艺的影响。
Influence of the workpieces pre-hole diameters and passes on thick-wall cylinders hole flanging is investigated by experiment and numerical simulation.
实验结果和数值模拟结果有助于掌握和利用这一先进的柔性加工工艺。
The results of the experiment and the numerical simulation are conducive to master and use this advanced flexible process.
本文在实验测试和数值模拟的基础上研究了溶液再生式蒸发冷凝器对制冷系统性能的影响。
In this paper, there will be research on the performance of refrigeration system on the impact of evaporative condenser with solution based on experimental testing and numerical simulation.
基于实验数据和数值模拟结果，研究了外界反压和底部二次流对塞式喷管底部的影响。
Based on experimental data and numerical simulation results, effects of ambient pressure and base bleed on aerospike nozzle base behaviour are investigated.
通过实验数据和数值模拟结果的对比，研究了泰勒杆实验在材料动态本构关系参数确认和优化方面的应用。
By comparing the results of Taylor test and computational simulation, a validating and optimizing method on dynamic constitutive model material constants was proposed.
本文对水平矩形槽道内湍流对流换热与发汗冷却进行了实验研究和数值模拟。
The turbulent convection heat transfer of transpiration cooling in a horizontal rectangular channel was investigated experimentally and numerically.
本文对水平矩形槽道内湍流对流换热与发汗冷却进行了实验研究和数值模拟。
The turbulent convection heat transfer of transpiration cooling in a horizontal rectangular channel was investigated experimentally and numerically.
应用推荐