在计算中用一维、定比热容方法分析了相关参数对燃烧室模态转变、性能的影响和隔离段与燃烧室的相互作用。
One dimensional constant specific heat model was taken to analyze the influence of the related parameters on the combustion mode transition and the combustor performance.
得出物料的初始含水率、物料形状、比热容与盐含量等对微波干燥影响有一定的相关性。
It is obtained that initial water ratio, material figuration, specific heat and salt content are somewhat relative with microwave drying.
实践证明，对不同煤质，一定负荷下的比热量几乎是相同的，可以使汽温控制得更好。
It has been found that for different coals, the specific heat capacity is nearly the same for a certain load, which can make steam temperature control more precision.
实验结果揭示出，在含水量一定的情况下，导热系数和比热容随密度增大而增大；在密度相同的情况下，导热系数和比热容亦随含水量的增大而增大。
The test data show that for loess with constant water content, if the density is increased, the coefficient of thermal conductivity and specific volume heat both are increased.
结果表明，同一材料的分形介质定容比热恒小于均匀介质的定容比热。
The results show that the specific heat capacity at constant volume in a fractal medium is always less than that in a homogenous medium.
利用MATLAB的数值回归分析功能，得到了几种常见理想气体定容比热容与温度的线性回归公式，数理统计分析的结果证明了这些回归公式的合理性，回归公式的最大相对误差低于5%。
Several linear regression equations of the specific heat at constant volume for ideal gas based on MATLAB were proposed and proved by mathematical statistics, with maximum relative error less than 5%.
利用MATLAB的数值回归分析功能，得到了几种常见理想气体定容比热容与温度的线性回归公式，数理统计分析的结果证明了这些回归公式的合理性，回归公式的最大相对误差低于5%。
Several linear regression equations of the specific heat at constant volume for ideal gas based on MATLAB were proposed and proved by mathematical statistics, with maximum relative error less than 5%.
应用推荐