介绍了由单片机控制的可控硅电路，该电路运用外部中断获得同步信号，用定时器做导通角控制，并给出实用程。
The controllable silicon circuit controlled by monolithic microcomputer is introduced, which adopts external interrupt to obtain sync signals and controls conducting angel with a timer.
系统利用单片机定时控制，实现语音信号的红外无线传输，满足现代交互式教学需求。
Single chip machine is used for timing control in the system, infrared wireless transmission of voice signals is realized, and the demand in modern interactive teaching is satisfied.
控制器的输入信号为电磁阀升程，控制量是气门开启定时和开启持续时间。
Input signal of controller is solenoid valve lift. Control parameters are valve opening timing and valve open duration.
现场装定飞行模式航迹数据，实时修正飞行轨迹，定时发送遥测、控制信号。
Flight path data was loaded on spot, and the flight orbit was revised in real time, remote measurement and control signal was sent out.
应用英飞凌单片机的定时器模块模拟计算出更多的位置信号，从而实现在低成本、高速运行情况下电机的空间矢量控制。
The timer module of Infineon was used to calculate more position signals, helping PMSMs run with high speed and lower cost.
针对这一特点，介绍了一种采用实时模糊和定时控制对单交叉口多相位信号进行动态控制的系统，并提出了一种改进的单交叉口多相位信号实时配时模型。
According to the characteristics, one kind of system was described that used real-time fuzzy and the timed control to carry out the dynamic control of the multiphase signal of isolated intersection.
仿真实验的结果表明，基于Q -学习的信号控制方法优于定时控制、感应式控制和基于遗传算法的信号控制方法。
The result of simulation illustrates that the signal control method based on Q-Learning is better than fixed-time control, actuated control and signal control based on genetic algorithms.
但现有的交通信号灯控制系统都是单一的固定时序控制，不能够根据实际交通状况进行调节控制。
But all the traffic light control systems are working in standing sequence, and are unable to make adjustment with different traffic flow.
正常状态时由金属探测器检测铁件，发出信号控制电磁除铁器短时工作一定时间(约20秒)。
Measure iron piece by mental detector at the normal condition; make out signal to control separator working certain time in short-term (about 20 seconds).
提出三种脉冲混沌同步的新方案，第一种是基于定时周期抽样耦合，并在接收端通过滤波恢复出同步控制信号。
Based on the ideas that the bond waves of chaotic attractor play an important role in chaotic synchronization, three synchronization schemes with simulation results are presented in this paper.
第二调谐器根据外来的控制信号，以预定时间间隔依次调谐多个频道。
A second tuner sequentially tunes plural channels at a predetermined time interval according to a control signal from external.
频率估计装置57、定时估计装置58分别将频率偏移量和定时偏移量通过控制信道从移动台接收的信号中检测出来。
Frequency and timing estimating units (57, 58) measure frequency and timing offsets, respectively, from a signal received from a mobile station via a control channel.
本文介绍了一种基于电子工作台(ewb)软件设计交通信号灯自动定时控制系统的方法，说明了计算机仿真软件在电子实验中的效用。它改变了传统的设计方法。
The paper presents a method of simulation on auto-timing system of traffic lights based on EWB, which has changed the traditional design method, and illustrates the method of design and simulation.
在工业控制领域中，我们需要比较精确的定时信号。
In the industry control domain, we need an accurate source of particular signals.
在工业控制领域中，我们需要比较精确的定时信号。
In the industry control domain, we need an accurate source of particular signals.
应用推荐