电机是由定子和转子两部分构成的。
定子和转子都是由铁磁材料构成。
根据产品使用特点及定子和转子的类型确定流量。
Depending on the characteristics of products used and on the type of stators and rotors.
用它可代替硅钢片制做小型电机中的定子和转子。
It may replace silicon steel sheet as the stator and rotator of small mo-tor.
专为风力发电行业而设计，适用于塔筒内定子和转子的输出回路。
Specifically design for wind power industry, applying for output loop between stator and rotator in cylinder.
提出了一种直接测量行波超声马达定子和转子接触状态的方法—电接触法。
An electric contact method to measure contact state of stator and rotor in traveling wave type ultrasonic motor (TWUSM) is presented.
机组变频起动过程，实际上是电动机依靠定子和转子的电磁力矩作用的同步驱动过程。
The frequency changing start up process of generating unit actually is a synchronous driving process under the action of electromagnetic moment of the stator and rotor of motor.
旋转血泵磁浮轴承的定子和转子之间没有机械接触，所以其内部不会发生机械磨损或产生血栓。
Magnetic bearing has no mechanical contact between the rotor and stator, and a rotary pump with magnetic bearing has therefore no mechanical wear and thrombosis.
介绍了无涂层电工钢冲片叠片成型后的电机定子和转子在罩式炉内进行退火和发蓝处理一次完成的新工艺及装置。
A new technology and equipment of annealing and bluing for finished stator and rotor of uncoated cold-rolled electric steel lamination in bell-type hytrogen furnace was introduced.
介绍了无涂层电工钢冲片迭片成型后的电机定子和转子在罩式炉内进行退火和发蓝处理一次完成的新工艺及装置。
A new technology and equipment of annealing and bluing for finished stator and rotor of uncoated cold-rolled electric steel lamination in bell-type hydrogen furnace was introduced.
同步迟滞电动机由一个多相缠绕的定子和一个硬磁转子所组成。
The synchronous hysteresis motor consists of a polyphase-wound stator and a magnetically hard rotor .
在这种情况下，始终存在一个磁耦合转子和定子。
In this case there is always a magnetic coupling between the rotor and the stator.
采用高分辨率的增量式光电编码器和相应的硬件接口电路，实现了变磁阻电机转子在定子两个齿之间位移的检测。
Using an optical incremental encoder and hardware interface, the position of the motor rotor between the two teeth of the motor stator is measured.
槽楔松动脱落可能划伤转子绝缘和定子绝缘，造成定子线棒主绝缘击穿。
The loosening and dropping out of slot wedges may damage insulation of rotor and stator to cause stator insulation breakthrough.
转子和定子采用优质磁性材料制成，转子和磁极之间留有一定的空气间隙，工作时无任何磨损。
The rotor and the stator are made of high quality magnetic material. There is a gap between rotor and magnetic pole, so no wear occurs during operation.
铁芯用于使放置在转子和定子中的线圈（由导体构成）之间的耦合最大，以增加电机的磁通密度以及减小电机尺寸。
The iron core is used to maximize the coupling between the coils (formed by conductors) placed on the stator and rotor, to increase the flux density in the machine and to decrease the size of machine.
一种节流阀控制装置，包括一个带螺线管的定子铁芯和一个带节流阀的转子。
A throttle valve control device is composed of a stator core with a solenoid and a rotor carrying a throttle valve.
同步磁带电动机由一个多相缠绕的定子和一个硬磁转子所组成。
The synchronous hysteresis motor consists of a polyphase - wound stator and a magnetically hard rotor.
通过研究列车所在位置处的定子与转子总的磁导率函数分布和励磁曲线分布，得出列车运行过程中所有悬浮力的大小。
All levitation forces of the running train were obtained according to the distributions of overall magnetic conductance function and current charge curve for stator and rotor.
同步磁带电动机由一个多相缠绕的定子和一个硬磁转子所组成。
The synchronous hysteresis motor consists of a polyphase-wound stator and a magnetically hard rotor.
方法：装置由径向驱动，仅包含一个定子和一个转子。
METHODS: The device is radially driven and has a stator and a rotor.
探讨了其定子绕组和转子绕组的设计方法。
The designing methods of its stator winding and rotor winding are also discussed.
本文介绍了二滩机组的主要焊接部件定子机座和转子支架的制造工艺。
This paper describes technology process of stator frame and rotor spider for Ertan power station.
介绍了定子齿面加辅助凹槽和转子磁极分段移位两种抑制磁阻转矩的方法。
Two methods of reducing cogging torque, namely, the stator tooth notching and the two rotor pole stacks shifting are presented.
由于环境恶劣及电流过载，造成了电机内部起火烧损了定子线圈和转子过热变形及轴承损坏等情况造成电机无法使用。
The firing inside the motor that caused by bad environment and current overload made the stator coils overburned, overheated rotor deformed and bearing damaged, which led to the motor out of service.
在低速范围内，对无传感器感应电动机进行矢量控制时用定子电压和电流推算转子磁通是比较困难的。
The sensorless of induction motor field-oriented control employing stator voltages and currents has difficulty in estimating rotor flux in the low-speed range.
装置包括一个转子和一个定子。
转子和定子成品然后装配进中央电机壳装置内。随后电机总成需经过高电压测试。
The finished rotor and stator unit is then assembled into a central motor housing unit. The motor assembly is then subjected to a High-Potential (Hi-Pot) Test.
转子和定子成品然后装配进中央电机壳装置内。随后电机总成需经过高电压测试。
The finished rotor and stator unit is then assembled into a central motor housing unit. The motor assembly is then subjected to a High-Potential (Hi-Pot) Test.
应用推荐