字节计数器在状态0011时被清零。
通过字节计数对字符进行计数的程序需要一些小小的改动。
Small changes are needed for programs that count characters by counting the bytes.
我继续将长度值除以256并增加字节计数器，直到除得的值小于1。
I continue dividing the length value by 256 and incrementing the byte counter until the result of division yields a value less than 1.
命令代码和字节计数上面必须发送，但数据是这两个字节被忽略。
The Command code and byte count shown above must be sent, but the data is ignored for those two bytes.
RecipeJAUS信息包序列由6个部分组织成，每个部分前面都是一个字节计数器。
The RecipeJAUS packet sequence consists of 6 sections, each preceded by a byte count for each of the sections. The sections are.
如果是这样，则运行上面所述的racluster命令，并且将把IP地址和该地址的所有连接的关联字节计数记录到%hosts散列中。
If so, the racluster command described above is run, and the IP address and associated byte count for all connections to that address is recorded in the % hosts hash.
偏移指出是否开始读取，而计数指出所读取字节的数量。
The offset indicates where to begin reading, and the count identifies the number of bytes to read.
根据文件系统所属的磁盘分区，此流程将对该分区的所有目录返回相同的磁盘使用量统计数据(以字节为单位)。
Based on the disk partition to which the file system belongs, this routine returns the same disk usage statistics in bytes for all directories in that partition.
单独的admin服务器用来显示实时的压缩统计数据，显示发送和保存的总字节数。
A separate admin server for displaying real-time compression statistics that indicates total bytes sent and saved.
该类别中的系统计数器跟踪如可用字节和缓存字节等数据。
System counters within this category track data such as bytes available and bytes cached.
内存开销非常小：基本上每个接口需要额外4个字节（对象实例数据里虚函数表指针），加上引用计数的4个字节。
Overhead in memory is very small: You basically have a 4- byte overhead per interface (the vtable pointers in the object's instance data) plus 4 bytes for the reference counter.
从N开始的字节，字符或段，从1开始计数。
我试图计数读取的字节，如果读取的字节超过限制（3MB），然后停止加密，只是继续写入正常（未加密的数据）到文件。
I have tried to count readed bytes and if readed bytes are over the limit (3MB) then stop encrypting and just continue to write normal (unecrypted data) to file.
这个结合写入到16个字节里，再加上有充足的空间为简单的计数预留，进而让你(几乎)有绝对空间来让多个CLSID提供出来。
This combination fits into 16 bytes, plus there is plenty of space left over for a simple counter that can give you an (almost) arbitrarily large range of contiguous CLSIDs.
此类别内的系统计数器跟踪内存数据，如可用字节数和缓存的字节数。
System counters within this category track memory data such as the number of bytes available and the number of bytes cached.
此类别内的系统计数器跟踪内存数据，如可用字节数和缓存的字节数。
System counters within this category track memory data such as the number of bytes available and the number of bytes cached.
应用推荐