您不能将多播地址用作子网地址，或者同时用作源地址和目标地址。
You cannot use a multicast address for a subnet or for both the source address and the destination address.
这之后每一个单元的地址池会将子网地址分配到每一个控制器，比如电灯开关，插销座等等。
The allocation of sub groups then to controllers such as light switches, mains sockets and similar is then done from each pool.
由于IP地址资源有限，本文介绍IP地址的格式，并且说明怎样进行IP地址的分配和子网地址的划分。
But the IP address have limited resource, this paper introduces the formers of IP address and sub-net address.
因此，尽管可以在物理接口上修改介质速度和双工模式，但是要在逻辑接口上设置IP地址和子网。
So, although you can change the media speed and duplex on the physical interface, you set up the IP address and subnet on the logical interface.
因此，这些地址的安排不会产生重复的子网路由，这是由引导、服务和持久化标签的子网规则决定的。
Therefore the subnetting rules for boot, service and persistent labels are such that there will never be a duplicate subnet route created by the placement of these addresses.
您无法预测IP地址，甚至无法肯定两个服务器在同一个子网上。
You can't predict IP addresses or even ensure that two servers will be on the same subnet.
当远程服务器位于同一子网时，路由地址与服务器地址相同。
When remote servers reside on the same subnet, the router address is the same as the server address.
您可能还希望使用您特定的网络数据(如，IP地址、子网掩码和DNS)来定制客户网络。
You also may want to customize the customer network with your specific networking data (such as IP address, netmask, and DNS).
网络设计包括：IP地址范围、子网配置、计算机命名规范等等。
Network design including IP address ranges, subnet configuration, computer naming conventions, and so on.
基于IP的位置识别利用了用户的网络信息，包括子网、网络掩码和路由器的mac地址。
IP-based location awareness USES the user's network information, including subnet, net mask, and the Mac address of the router.
网络VLANs、子网和地址应该以相同的方式连接。
The network VLANs, subnets, and addresses should be hooked up in the same fashion.
在Linux和Solaris 系统上，可以在一块物理以太网卡上创建多个虚拟接口，让它们连接到不同子网上的IP地址。
On both Linux and Solaris, you can create multiple virtual interfaces to IP addresses on different subnets on one physical ethernet card.
对于本例来说，可以将IP地址设置为192.168.128.1，将子网掩码设置为255.255.255.0。
For this example, set the IP address to 192.168.128.1 and the subnet mask to 255.255.255.0.
如果查找路由表显示包的目的地不在本地子网，路由器就利用下一跳路由器的MAC地址把包转发给下一跳路由器。
If the route table lookup shows that the packet is destined for a non-local subnet, the router forwards the packet to the next-hop router using the next-hop router's MAC address.
一定要注意，您提供的IP地址和主机名必须对于所选ip组(WASIPs)的相关子网是有效的。
It is important to point out that the IP address and hostname you provide must be valid values for the subnet associated with the IP group you select (WASIPs).
DHCP（DynamicHostConfigurationProtocol）可以用来确定网络参数，例如IP地址和子网掩码。
The Dynamic Host Configuration Protocol (or DHCP) can be used to identify network parameters such as IP address and subnet mask.
CiscoCatalyst网络交换机会自动在IP地址末端填充子网掩码。
The Cisco Catalyst Network Switch automatically fills in the subnet mask at the end of the IP address.
每个netserver实例监听一个专用端口和IP地址；每个以太网适配器的IP地址属于单独的子网以确保专用的通信流。
Each instance of netserver listened on a dedicated port and IP address; each Ethernet adapter's IP address was on a separate subnet to ensure dedicated traffic.
必须为引导服务器配置一个IP地址，这个地址必须在DHCP服务器配置文件中定义的子网内。
You must configure the boot server machine with an IP address, which is in one of the subnets defined in the DHCP server configuration file.
这个IP地址规范支持各种不同的格式，包括IP地址和子网掩码、网络规范、甚至IP地址范围。
The IP address specification supports a number of different formats, including the IP address and netmask, network specification, and even IP address ranges.
如果希望给接口添加同一子网中的另一个IP地址，可以用ip别名轻松地实现。
If you want to add another IP address from the same subnet to an interface, it's simple and can be done with IP aliasing.
使用命令 netCfgShow显示控制器的当前IP地址设置，使用命令 netCfgSet 来设置所需连接的 IP 地址、子网掩码和网关。
Use the command netCfgShow to show the current IP settings of the controller, and use the command netCfgSet to set the desired IP address, subnet mask, and gateway.
子网掩码由四个字节组成，它的值为255时表示IP地址中网络地址的部分，值为0时则识别IP地址中表示主机号的部分。
The subnet mask is an octet that USES the number 255 to represent the network address portion of the IP address and a zero to identify the host portion of the address.
注意您必须修改Internet地址和子网掩码。
此外，如果要指明用于确定IP地址所属的子网掩码，也可在该页面中完成。
Additionally, if you want to indicate a mask used to determine the subnet an IP address belongs to, you can do so on this page.
此外，可输入掩码以指定地址范围所属的子网。
Additionally, you can enter a mask to specify the subnet to which an address range belongs.
找不到指定的ip地址的匹配网络。请指定子网掩码和群集网络。
A matching network for the specified IP address could not be found. Please also specify a subnet mask and a cluster network.
这是一个获取、修改计算机的IP地址及子网掩码。
This is an acquisition, changes to the computer's IP address and subnet mask .
方案中还提出了以SIP地址域的分级方式进行组织管理的用户数据库系统，定义了为子网中移动终端服务的区域代理。
The scheme also defines a user database system organized by hierarchical domains of SIP address, and a domain agent managing mobile nodes in subnetwork.
方案中还提出了以SIP地址域的分级方式进行组织管理的用户数据库系统，定义了为子网中移动终端服务的区域代理。
The scheme also defines a user database system organized by hierarchical domains of SIP address, and a domain agent managing mobile nodes in subnetwork.
应用推荐