分析了电路波形及实验数据、对实验研究过程中的多频率峰值、谐波干扰和幅值干扰等进行了分析和处理。
A detailed analysis about the circuit waveform and experimental data is also given the multi-frequency peak value and the frequency interference during the experiment are all analysed and processed.
根据多卜勒频偏检测原理，该探测器由发射机、转换电路、接收机和信号处理电路构成，发射信号是设计的关键。
According to the principle of view the Doppler frequency detection, the detector makes up of the transmitter, the transfer circuit, receiver and signal processing circuit.
同时利用CMOS多谐振荡电路产生窄脉冲电流序列对前面处理过的非晶带进行激励，制作成灵敏度高、稳定性好、功耗低的弱磁场传感器。
A sensitive, stable and low power consumption magnetic sensor is constructed using a CMOS multivibrator circuit, in which a sharp pulse train current is applied to the treated amorphous ribbon.
从电路板上拆除多引脚的通孔元件和大热容量的通孔元件比较麻烦，比如变压器、接插件。
Removed from the circuit board through-hole components via multi pin component and the large heat capacity is quite troublesome, such as transformer, connector.
由于IR测量往往涉及到多芯导线，所以通常需要一套切换系统来将皮安计和源切换至测试电路中的所有导线。
Ir measurements often involve multiple conductors, so a switching system is often required to switch the picoammeter and the source to all the conductors in the test circuit.
本文提出了模拟电路多频故障诊断的一种新方法。
A new method of multifrequency fault diagnosis for analog circuit is presented in this paper.
本文介绍了一种多探头输入利用无线数据进行传输的湿度控制仪，给出了单元电路图和程序流程图。
In this paper, we introduce a humidity controller using wireless data transmission system with multi-probe, and present the unit circuit and the program flow chart.
介绍了在电阻式传感器测量电路中采用多基准源进行实时自校正的技术。
The technology of real time auto-correction by using multiple reference sources in measuring circuit in resistance transducer is introduced.
分析表明，当开关的上电极为多支撑梁结构时，需要对传统的开关等效电路加以改进。
Analysis shows that the traditional RLC series circuit model is incomplete when capacitive switch has multiple support beams.
然而，生产某些电路需要这么多的体力劳动，只有30件放大器都不能作。
However the production of certain circuits required so much manual Labour that only 30 pieces of the amplifier could ever be made.
基于电路基本理论知识，推导出多馈入交、直流并联的高压直流输电系统耦合导纳和换相电压关系表达式。
Based on electrical circuit theory, the formulation of the relation between mutual admittance and converter commutation voltage of the multi-infeed HVDC system was given.
在分析现有模拟电路多频灵敏度故障诊断方法的基础上，提出一种新的测试频率范围的选择方法，即灵敏度矩阵分析方法。
After analyzing current fault diagnosis methods based on multi-frequency sensitivity in analog circuits, a new sensitivity matrix analysis approach is presented to select testing frequency.
文章从硬件电路和软件实现上对本系统的串口通信机制以及多电机协调策略等几个关键问题作了较为深入的阐述。
In this paper, several key issues such as the communication mechanism and the coordinated control strategy are expounded from the view of hardware and software realization.
利用光学和电子学结合的方法，建立了基于多光束光学传感器和光电检测电路的检测薄膜特性装置。
With a new combining method of optics and electronics, a device based on a multi-beam optical sensor and a photoelectric sensing circuit was setup.
构造了一些新的基于电流反馈放大器的电压模式双二阶滤波器，多滤波功能和参数可调是这些电路的主要优点。
Some new voltage-mode second-order filters based on current feedback amplifier are proposed. The major merits of these circuits are multiple filtering function and adjustable parameter.
分析了网络协议测试仪的串行通信接口功能，设计了一种可编程多协议串行接口电路。
The function of serial communication port in protocol tester was analyzed and a programmable multi-protocol serial communication interface circuit was designed.
描述了一种核探测器二线制电路的原理和性能，并应用于核料位计中，与传统的多线制探测器相比有明显的优越性。
The principle and function of a kind of two lines system circuit in nuclear detector has been described, and it has been applied in nuclear level gauge.
最后对用于实现信号多场累积和象差处理的帧处理器及其逻辑控制电路作了简要说明。
Finally, the frame processor used for carrying out multiple-field cumulation and image-difference processing and its logical control circuits are briefly treated.
本文介绍了几种新颖的低寄生、紧缩型、多模式射频集成电路ESD保护结构，讨论了其工作原理及设计中应注意的问题。
This paper presents some new ESD protection structures for RF ICs, including dual-direction and all-mode ESD protection structures, and key aspects on ESD protection design are discussed.
该方案的系统组成包括PC机软件、LXI接口电路、控制模块、多通道dds系统和加法器。
This system could include the PC software, LXI interface circuit, control module, multi-channel DDS system, and the Adder module.
设计一种基于反激式同轴多绕组输出均衡电路，实现对多个串联单体的快速有效均衡。
One kind of equalization circuit based on CWT (coaxial windings transformer) was designed to achieve the destination of fast equalization on series connected ultra capacitors.
在高压大容量应用场合，多电平逆变电路具有显着的优势，比如输出谐波少、开关频率低等。
In high voltage and high power fields, multilevel inverter has significant advantages, such as less distorted output, lower switching frequency, etc.
主要介绍多频彩色显示器的行S校正原理及新型专用集成电路WT8045的特点与应用电路。
S-compensation circuit of multi-frequency color monitor is introduced, and the characteristics and applications of new special IC WT8045 are proposed.
研究了CMOS电路中多双曲正切法则的应用对线性度产生的影响。
The nonlinear behavior of the multi-tanh principle used in CMOS IC design is investigated.
给出了双音多频发送电路的分立元件实现方法。
The realization of the DTMF circuit using discrete components was presented in this paper.
研究了一种易于在实时诊断系统中实现的多脉波可控整流电路故障诊断方法。
This paper studies a kind of the multi-wave controlled rectifier circuit fault diagnosis method easy to achieve in the real-time diagnosis system.
本文运用有限元方法对多热源条件下集成电路封装的热场进行了模拟和分析。
In this paper, the temperature distribution of a package with multiple heat resources was simulated and analyzed.
那个设计方案描述了一个简单而有效的多通道电路。
That Design Idea described a simple and efficient multichannel circuit.
设计并制作了一种基于LTCC技术的系统级封装多通道射频前端电路。
A system in package(SIP) RF front-end based on LTCC technology was designed, fabricated and tested.
设计并制作了一种基于LTCC技术的系统级封装多通道射频前端电路。
A system in package(SIP) RF front-end based on LTCC technology was designed, fabricated and tested.
应用推荐