通过实例，介绍了单片机串行口的异步多机通信的应用。
With some examples it introduced the use of single chip microcomputer serial interface in asynchronous multitude machines communication.
通过实例，介绍了单片机串行口的异步多机通信的应用。
With some examples it introduced the use of single chip microcomputer serial interface I...
介绍分支拓扑结构在主从式多机通信中的实现方法，电路结构及工作原理。
The implementation method and circuit structure as well as principle of branch topological structure in master slave communication are introduced in this paper.
在主从式多机通信中，由于从机完全处于从属地位，因此不能主动请求与主机通信。
In the master -slave multi -computers communication system, slave computer is merely in the position of slave, so it can't initiatively request to communication.
我们分析了RS - 485主从式多机通信的缺点，提出了对等式多机通信网络控制。
After researching the defects of RS485 in master-slave mode, control network of equivalent mode in multiple computer's communication is put forward in this paper.
第五章对设计成功的基于多机通信的无线数字通信系统和全自动测控软件进行了实验研究。
In chapter 5, some experiments were taken on the wireless digital communication system based on multi-processor communication and the fully automatic measurement and control software.
文章着重介绍了该操作系统的资源管理、多机通信、过程控制以及状态监视与故障处理等技术。
The paper discusses the resource management, interprocessor communication, process control, state monitor and error processing, which are important technical problems for RCDOS.
针对自行开发的基于多cpu数字化埋弧自动焊系统进行了多机通信系统的设计，具体讨论了多机通信的实现。
A multiprocessor communication system is designed in this paper based on the multi-CPU digital submerged arc welding system, and the realization of communication is discussed in detail.
选择的通信接口芯片允许多达128个同样的接口芯片接在同一总线上，为多机通信的实现提供了极大的方便。
It allows 128 interface ICs to connect with each other on one bus, which makes it easy to use the card in multi-computer system.
讨论了PC主机与多台不同类型的从机进行多机通信的通信原理以及通信协议，解决了不同类型从机的地址识别问题。
The principle and protocol of the multicomputer communication between the PC master and the different slaves are discussed, and it solves the address identification between different slaves.
本文对RS- 485控制网络进行了改进，并提出RS - 485动态延时控制方式：对等式多机通信网络控制。
An improvement of RS-485 control network has been put forward and held up RS-485 coequal dynamic time control multiple computers communication in this paper.
介绍了基于RS-485总线的单片机多机通信系统，重点介绍了MAX-487芯片和通信系统的组成，并给出了流程图。
The essay introduces multi-chip calculator communication system based on RS-485 bus, especially MAX-487 chip and the components of the communication system and gives the flow diagram.
为了解决以上存在的问题，提出了采用集散控制系统(DCS)的方法，给出了在试验机中多机通信的系统结构及相关程序。
The paper using Distribute Control system (DCS) method compensates the above problems and offers the system construction of DCS and relative program.
介绍了硫化过程微机集散控制系统中PC总线工业控制计算机与多台MCS-51单片机为核心的硫化控制仪之间的多机通信的方法与实现。
The method of data communication between PC bus industrial computer and MCS-51single chip computers in rubber vulcanization distributed control system is introduced.
然而，随着多机系统的应用，数据通信可靠性成为整个应用系统的关键。
However, along with the application of multi computer, the reliability of data communication is vital in the whole application system.
传统的多通道通信记录设备是由模拟磁带机或数字磁带机构成，设备庞大复杂，价格高昂。
Conventional multi channel speech communication recording systems consist of analog or digital tape recorder with large size and costs.
通过对PC机与单片机多机串行通信协议中常见问题进行分析，提出了一种通信协议的制定策略。
It is analyzed that the usual problem in multi computer serial communication protocol between PC and single chip microcomputer, put forward that a kind of communication protocol strategy.
最后给出一个实用超立方体多微处理机系统的设计，着重讨论了其通信控制板的设计。
A practicable hypercube multi-microprocessor system design is presented with more details of its communication control board.
最后给出了跳频通信发信机、接收机以及干扰机成员的仿真模型，分析了频率偏移对多频连续波干扰性能的影响。
Finally, simulation models of FH transmitter, receiver and jammer are presented. The influence of frequency excursion on performance of multi-tone continuous wave jamming is analyzed.
系统硬件电路包括音频数字信号源实现声音信号产生、数字声强级控制、多机数据通信、液晶显示和电源等模块单元。
System hardware circuit audio digital signal source achieve this functions: sound signals, sound intensity level control, data communications, liquid crystal display, alarm and power.
本文阐述了主从式多机通讯的原理，提出了一种基于RS-422串行通信接口的方案和软件设计方法。
This paper describes the principle of multicomputer communication, and also the hardware and software implementation method based on RS-422 bus is given.
提出了一种在分布式单片机控制系统中，多机间进行高性能串行通信的方案。
The scheme of the serial communication of high performance among multi-processor is provided in the control system of the single chip processor of distributing type.
介绍了两种多单片机系统的直接并行通信方法，即主从方法和多主方法。
This paper deals with two types of direct parallel communication of multi-SCP system, the pricipal and subordinate method and poly-pricipal method.
文中给出双单片机系统和多单片机系统的通信接口设计方法。
The design method of the communication interface of double monolithic computer system and numerous monolithic computer system are put forward in it.
SHD - A型多通道固态调频发射机系统主要应用于航空通信系统一点对多点的声音、振动、测控等基带信号的发射与传输。
SHD-A model transmitter is applied to emit and convey baseband signal of sound, vibration and measure-control in aeronautical communication system from one point to multi-point.
本文讨论电机内部采集转子温度信号的特殊方法和转子测温原理，并对多机远程通信、实时监测及系统控制作了具体介绍。
This paper discusses the special method for sampling temperature signal of rotor within the electrical machine and the principle of measuring the rotor temperature. Finally, a detail illustratio…
本文讨论电机内部采集转子温度信号的特殊方法和转子测温原理，并对多机远程通信、实时监测及系统控制作了具体介绍。
This paper discusses the special method for sampling temperature signal of rotor within the electrical machine and the principle of measuring the rotor temperature. Finally, a detail illustratio…
应用推荐