一旦终止或重新启动实例或数据库，计数器便会复位。
Counters are reset when you stop and restart an instance or database.
通常情况下没有进行复位而收集的数据不是很有用，因为计数器的时间跨度较长，包括随着负荷起伏跌宕截然不同的工作负载。
Typically the data collected without a reset is not very useful because the counters span a longer period of time, including drastically different workloads along peaks and valleys in load.
这不会使高水位的计数器复位。
多数监控器的计数器是累计的，反映从您的会话(您从中发布db 2命令)中最后一次快照监控器复位起的具体活动的总数。
Most of the monitor counters are cumulative, reflecting the total count of a particular activity since the last snapshot monitor reset within your session from which you are issuing your db2 command.
“延迟读取操作总数”是指自上次计数器复位后，所执行的延迟读取操作的总数。
Total late Reads is the total number of late read operations since the last time the counter was reset.
在计数阶段的最后，主控门关闭，然后计数器复位，开始下一个采样阶段。
At the end of the counting period, the main gate is closed and counter reset for the next sampling period.
有手动复位和电气输出信号的脉冲计数器。
“延迟发送操作总数”是指自上次计数器复位后，所执行的延迟发送操作的总数。
Total late Sends is the total number of late send operations since the last time the counter was reset.
“流错误总数”是指自上次计数器复位后，由于删除包而造成的流错误的总数。
Total stream errors is the total number of stream errors due to dropped packets since the last time the counter was reset.
电路使用IC4的CD4069反相器作为复位延时使能，在每个计数器开始计数前引入几毫秒的延时。
The circuit uses IC4, a CD4069 inverter, as a reset-delay enable to cause a few milliseconds of delay before each counter can begin to count.
复位按钮，前面板使用了5秒的重置计数器显示只。
Reset using front panel button held for 5 seconds which resets displayed counter only.
通过对计数器和钟控传输门绝热逻辑电路工作原理及结构的研究，提出一种带复位功能的低功耗十进制计数器设计方案。
Based on the working principle, counter structure and Clocked Transmission Gate Adiabatic Logic circuits, a design scheme of decimal counter with reset is proposed.
通过对计数器和钟控传输门绝热逻辑电路工作原理及结构的研究，提出一种带复位功能的低功耗十进制计数器设计方案。
Based on the working principle, counter structure and Clocked Transmission Gate Adiabatic Logic circuits, a design scheme of decimal counter with reset is proposed.
应用推荐