没杯熟扁豆中含有大约16克腹部填充纤维。
Boiled lentils have about 16 grams of belly-filling fiber in every cup.
研究了填充纤维、阻燃剂种类及用量对EPDM绝热层耐烧蚀性能的影响。
The effects of filler fiber and flame retardant on ablative performance of EPDM insulation are studied.
通过这种方法，不仅可以填充纤维束之间的大孔隙，而且可以填充纤维之间的小孔隙。
By this method, not only the large pores between bundles but also the small pores between fibers in a bundle can be filled.
它有着柔软的，低致敏性的纤维，填充在水袋里。
It has a soft, hypoallergenic fibre filling supported by a water pouch.
像多数的高级比赛用帆一样，船帆由双层聚酯纤维膜组成，内部填充碳纤维以增加强度。
Like most advanced racing sails, they are a sandwich of polyester film sheets with a filling of carbon fibers providing strength.
其玻璃纤维填充量可以很方便地达到40%的程度。
They can conveniently be filled with glass fibre to the extent of 40%.
天花板上可能会有木制反射面，或者有一些用环保玻璃纤维填充的小盒子悬挂在天花板上以防止由于天花板带来的任何响声。
The ceiling may have wood reflectors, or a few boxes filled with environmentally-safe fiberglass material may hang from the ceiling to stop any ringing caused by the ceiling.
加上它充满纤维，因此它会填充你。
棉被褥一套多种设计，可与天然羽绒，也合成纤维填充。
Cotton bedding set of many designs, available with natural down feather and also synthetic fiber filling.
本文论述了新型陶瓷材料的范围、种类和特性，以及新型陶瓷微粉填充聚合物后，赋予纤维材料功能性的研究与开发。
This article deals with the range, kind and properties of new ceramic materials, and the study and development on the materials to render fibre a specific function after they are filled with polymer.
本文从纤维增强PEEK、颗粒填充PEEK、PEEK表面改性、与聚合物共混等方面综述了PEEK改性研究的进展情况。
Enhancement of PEEK by adding continuous fibre and short fibre, particle fillers, surface modification and blend with polymers were reviewed.
填充采用进口超细纤维，触感柔和，透气性强，尤其适合办公、旅行和家居使用。
Filler adopts imported superfine fibber, mild, permeability is strong, especially suitable for office, travel and household use.
一个是粉红的，另一个是淡紫色。这些枕头100%全棉，填充物是聚酯纤维。
One in pink, the other in lavender, these pillows are 100% cotton with polyester fiberfill inserts.
实验结果证明在相对低温的情况下，制备以锰锌铁氧体为填充物的磁性纸用纤维是可行的。
The test results show that the preparation of magnetized paper fiber filled by manganese zinc ferrite is feasible at relatively low temperature.
随着纺丝液温度的上升和填充液的压力增加，中空纤维膜的水通量上升。
Water flux increases with increasing temperature of the casting solution and the pressure of the filling solution.
聚氨酯合成革生产中，为了降低成本，改善性能，经常在涂层浆中添加填充剂纤维素粉末等。
The materials, such as calcium carbonate, cellulose powder, are often used as additives in manufacture of polyurethane leather for reducing the cost and improving the properties of products.
泡沫颗粒或者纤维因它们的绝缘性能和重量轻常用作填充物。
Foam particles or fiberfill usually make up the filler due to their insulating properties, without weight.
不同填充液与溶剂之间的相互扩散速率不同，得到了具有不同结构的聚醚砜中空纤维膜。
PES hollow fiber membrane was obtained with different structure owing to the different dispersing rate between different internal quench medium and solution.
以玻纤填充质量分数为30%玻纤增强尼龙6为例，分析和研究了玻璃纤维长度及其分布对增强尼龙6主要性能的影响。
Using 30% glass fiber reinforced nylon 6 as a sample, the influences of the length and its distribution of the glass fiber on properties of the reinforced nylon were analyzed and studied.
利用非木材纤维填充热塑性树脂来开发仿木塑料产品越来越受到人们的重视。
People pay more and more attention to develop the simulated wood plastic products which utilize the non - timber fiber to pack hot plasticity resin.
对炭黑、无机物质、纤维填充聚合物的流变行为分别进行了讨论。
The rheological behaviors of the polymers filled respectively with carbon black, inorganic substance and fibers were reviewed.
研究了单螺杆挤出机挤出温度及螺杆转速对沥青炭纤维填充abs树脂复合材料导电性及力学性能的影响。
It is investigated that the influence of barrel temperature and rotation speed of screw rod of extruder on conductivity and strength of the ABS resin composites filled with carbon fibers.
一般上，绝缘介质是由环氧树脂。环氧填充玻璃纤维。聚酰亚胺，或其他介质材料制成。
Traditionally, this insulator is made of epoxy, epoxy filled glass fiber, polyimide, or other dielectric materials.
利用植物纤维填充热塑性树脂来开发仿木塑料产品越来越受到人们的重视。
Much attention was paid on thermoplastics filled with plant-fibers to produce wood-like plastics.
所述的填充层为棉、毛、丝绸、化学纤维中的一种或组合制成。
The filling layer is one or the combination of cotton, wool, silk cloth and chemical fiber.
采用空间回路网法计算得到填充吸波泡沫的碳纤维复合材料格栅结构的电磁散射性能。
The spatial network method is used to calculate the electromagnetic wave scattering characteristic of carbon fiber composite grid structures filled with Absorbing foams.
研究了预处理短纤维用量对乙炔炭黑填充甲基乙烯基硅橡胶（VMQ）／EPDM共混硫化胶拉伸、撕裂、耐屈挠疲劳和导电性能的影响。
The influence of the level of the pretreated short fibre on tensile strength, tear strength, flex fatigue and conductivity of the acetylene black filled VMQ/EPDM blend vulcanizate was studied.
研究了预处理短纤维用量对乙炔炭黑填充甲基乙烯基硅橡胶（VMQ）／EPDM共混硫化胶拉伸、撕裂、耐屈挠疲劳和导电性能的影响。
The influence of the level of the pretreated short fibre on tensile strength, tear strength, flex fatigue and conductivity of the acetylene black filled VMQ/EPDM blend vulcanizate was studied.
应用推荐