2007年版的产品略长(显然主要因为烟杆较长)填充密度较高，不过，水分含量略低。
The 2007 versions of these products were slightly longer (apparently mostly attributed to longer tobacco rods), and had slightly higher packing density, but slightly lower moisture content.
膜分离技术广泛应用于气体分离是因为它的特殊分离效率、低质量和高填充密度。
Membrane separation technology is widely adopted in the gas separation application due to its special separation efficiency, low weight and high pack density.
通过考察体积传质系数，确定了纤维液膜萃取分离器的最佳填充密度和最佳流量比。
By analyzing the volume mass-transfer coefficient, the optimal operating flow-ratio and packed density were obtained.
用时域有限差分法研究了同一材质的颗粒在不同填充密度下的随机介质中光局域化问题。
The problem of light localization in two-dimensional random media with different filling densities of the same material particles is studied by use of the finite difference time domain method.
考察了酸醇投料摩尔比、混合液的进料流量、催化剂的填充密度等因素对反应过程的影响。
The influence of the factors, such as the molar ratio of acetic acid ton-butanol, the feed rate of the reactants and packing density of the catalyst, was investigated.
从理论上分析了单一膜料倾斜入射沉积时的折射率与填充密度的关系，给出了三种不同的表达式；
Relationship between refractive index and packing density of coatings prepared by glancing angle deposition is analyzed and three expressions are given firstly.
本文介绍了用线型低密度聚乙烯(LLDPE)进行填充发泡的试验结果。
This paper deals with the foaming of Linear Low Density polyethylene (LLDPE) with filler.
在固液相填充复合体系中，采用合理的颗粒级配可使颗粒排列更加紧密，提高堆积密度。
In composite system filled with solid and solid liquid phase, rational particle grade improve particles arrangement closer and increase stacking density.
本文从理论上和工艺上论述了高效率硅太阳电池的研制情况，分析了如何提高硅太阳电池的开路电压、填充因子及短路电流密度的措施。
Measures to increase the open circuit voltage, the fill factor and short circuit current density are discussed both theoretically and technologically for an efficient silicon solar cell.
而且结构的稳定性强烈地依赖于对成键态的填充度，与e_f处的状态密度呈相反变化的关系。
Furthermore, it is found that the stability depends strongly upon the band filling of the bonding states and exhibits a inverse relationship with the density of states at E_F.
雷达成像需要获得目标空间谱域一定范围和密度的采样以重建目标图像，目标空间谱域的填充方式与雷达成像的质量有直接关系。
Radar imaging must obtain an extent of target spatial spectral-domain sampling, and the filling of spatial spectral domain is in direct connection with the quality of imaging result.
可调节的肩带有一个符合人体工程学设计，为最终的舒适性和透气网和优越的双密度泡沫填充。
Adjustable shoulder straps have an ergonomic design and superior dual density foam padding for ultimate comfort and breathable mesh.
PL偶联剂改善了HA与HDPE两相界面间的结合性能，提高了HA在高密度聚乙烯基体中的分散度和填充量。
Pl coupling agent could enhance the interface combination between ha and HDPE, and improve the dispersibility and fill content of ha in the HDPE basis.
测定其水溶性浸出物和吸湿性，及其堆密度、休止角，考察其填充性和流动性状况。
Measure water soluble extract and humidity-absorption, pile concentration and dormant Angle, investigate its fill and flow.
因此，作者认为采用常规机械混熔法得到纳米氢氧化铝填充高密度聚乙烯并不是严格意义上的纳米复合材料。
Therefore, the author argued that the HDPE filled with ATH obtained by way of conventional mechanical mixed melting, strictly speaking, was by no means compounded nano materials.
该设备填充系数大，可达90%以上，对密度差别大、配比悬殊(可达1：24 00)、粒度不等的粉料的混合也同样适用。
It is used for a wide range of powder material with high density difference (up to 1:2400) with charging coefficient up to 90%.
物料在失重和同质状态下仍不受纯度、密度和填充系数的影响，混合速时间短，均匀度高。
High mixing speed and homogeneity. Materials can be mixed under the state of weightlessness and homogeneity and are not affected by the factors such as fineness, density and fill-up coefficient.
附胶体填充，超声焊接，高密度abs外壳。
Enclosure Gel filled, ultrasonically welded, high density ABS housing.
采用模塑成型和嵌入成型两种方法，通过改变体积填充系数、质量填充系数和芯体尺寸，制备了梯度密度聚氨酯泡沫塑料。
Gradient-density PUF was produced in two ways : mould shaping and embed shaping, through changing volume filling coefficient, mass filling coefficient, and the size of foam core.
对DD密度计法和自然堆积法两种测试膨胀梗丝填充值的方法进行了实验分析对比。
The relation between DD density meter method and natural stacking method for determining filling value of cut stem was discussed .
主要提高活性物质的填充空间，可以减少电池容量和重量，它能明显地促进电池能量密度和放电功率。
Mainly enhances the active material the packing space, May reduce the battery capacity and the weight, it can obviously promote the battery energy density and the electric discharge power.
建立了由微小颗粒(无定形的或结晶的)和填充空气或水的小孔构成的模型，在此基础上分析了质量密度与折射率的相关性。
The correlation between mass density and refractive index is analysed on the basis of a model comprising compact grains (i. e., amorphous or crystalline) and pores filled with air or water.
利用高级流变扩展系统（ARES）研究了碳黑（CB）填充的高密度聚乙烯—乙烯和醋酸乙烯共聚物（HDPE/EVA）体系的流变学行为。
The rheological property of HDPE/EVA system filled with carbon black(CB) is studied with Advanced Rheology Expand System(ARES).
烟丝膨胀是将烟丝的细胞结构给予增大，减小烟丝密度，增加烟丝的填充值。
The detination of tobacco inflation is to enlarge the structure of cell, and lower down the density of tobacco, and improve the filling value of tobacco.
高密度太空记忆海绵填充，促进血液循环。
测定了不同混合比例的陶瓷颗粒和小麦秸秆粉混合物含气堆密度、填充堆密度。
Bulk densities of mixture of wheat stalk powder and ceramic micro-beads with various ratios were measured by experiment for designing biomass pyrolysis equipment.
研究结果表明磁光电导谱的峰值和强度强烈依赖于填充因子和态密度。
The peak position and intensity of the magneto-optical conductivity depend strongly on the filling factor and the broadened DOS.
结果表明：随着烧结温度的升高和保温时间的延长，气孔率和吸水率减小，体积密度和弯曲强度升高；晶粒长大填充气孔，使多孔材料孔隙率下降而强度增加。
The results show that the porosity and water absorption decrease and the bulk density and bending strength increase, along with the sintering temperature raising and the time prolonging.
随着移动电子产品的密度越来越高，底层填充技术逐步提高，越来越多的底层填充材料被研发。
As the density for mobile electronic product becomes higher and higher and underfill technology improved, more and more underfill material have been developed.
随着移动电子产品的密度越来越高，底层填充技术逐步提高，越来越多的底层填充材料被研发。
As the density for mobile electronic product becomes higher and higher and underfill technology improved, more and more underfill material have been developed.
应用推荐