研究了有轨电车运行条件下的交叉口信号控制基本参数确定方法。包括黄灯时间、绿灯间隔时间。
Then, the calculation method of the basic elements of intersection signal control is proposed which included amber time and inter green time.
给定参考椭球体的四个基本参数，椭球体产生的外部正常重力位场可利用传统方法确定。
Given four basic parameters of a reference ellipsoid, the normal potential field generated by the ellipsoid could be determined by using conventional method.
储层孔隙度是容积法储量计算的基本参数，而准确确定地层条件下的孔隙度值是提高储量计算精度的基础。
Since porosity is a basic parameter for the calculation of gas reservoir reserves, determining the porosity under the reservoir condition is the only way to enhance the precision of the calculation.
确定了非圆齿轮的基本参数：基础圆半径、偏心率、变形距和中心距比例系数。
The basic parameters of non-circular gear are determined, such as primary circle, eccentricity ratio, eccentricity throw and proportional coefficient of center distance.
用文中方法可给出时滞不确定控制系统稳定程度的可靠性度量和为保证稳定性所要求的基本参数的最大容许变异范围。
By the method, robust reliability measure of robust stability degree of interval delay-independent control systems and the maximum allowable ranges of the basic parameters can be given.
这种严格的要求只能通过最优确定各个处理阶段的基本参数以及通过全面的检测数据来实现。
Such demanding requirements can only be satisfied by means of optimally determining the essential parameters of the individual process stages and by comprehensively monitoring these parameters.
用优化设计方法确定了各级齿轮的基本参数，解决了该型传动设计中的一大主要问题。
Basic parameters of all gears are determined by optimal design. This is a major problem in design of this transmission.
首先确定了车轮零件的类型和相关基本参数，然后运用UG软件对车轮零件进行三维建模。
First the type of wheel parts and related basic parameters are determined, and then using UG software to build the model of the wheel parts.
根据山西省多年的灌溉试验资料和研究成果，确定了棉花优化灌溉制度的基本参数。
According to the irrigation experiment data and research achievements of Shanxi Province, this paper determines the basic parameters of optimized irrigation system for cotton.
该设计方法包括两个种类：一类是已知锥形齿轮基本参数，需确定共轭齿轮副及机构安装参数的直接设计法；
The former is a method to determine the mounting dimensions when the basic dimensions of a pair of gears are given first.
公路建设场地类型决定于自然地理条件和岩层的地质条件，表征这些条件的基本参数存在很大的模糊性和不确定性。
The types of highway construction site lie on the physical geography condition and the geological condition of terrane whose basic parameters are fuzzy and uncertainty.
以高斯波束理论为基础，根据天线基本参数要求，分析确定出波束波导系统中各反射面尺寸、反射面彼此间距及各部件相对位置。
Based on Gaussian beam theory and the antenna parameters, the size of the reflectors of the beam waveguide, the distance between them and their relative locations can be determined.
本文介绍了常州工业技术学院电教中心给水排水与消防工程概况、设计意图、基本参数的确定、卫生设备和管材的选用原则。
The intention of the design, the affirming of the fundamental coefficients and the principle elect for the sanitary equipment and the pipe materials was also.
依据新型滚柱活齿传动的数学模型和活齿传动原理，确定了新型滚柱活齿传动基本参数设计准则，建立了新型滚柱活齿传动的基本设计步骤。
According to mathematic model and the principle of movable tooth drive, elementary design principles and design procedures of new-type roller movable tooth drive are decided.
在进行经济技术性分析后，最终确定风机的设计方案，进而确定通风机适当的级型式、叶轮尺寸、轮毂比、转速和叶片数等基本参数。
Final design scheme is confirmed after economic and technical analyse. Then, axial fan 's stage type, impeller diameter, hub ratio , specific speed and the number of blades are decided.
现场考察了淮南矿区掘进巷道瓦斯排放的基本参数，确定了巷帮钻孔的有效布置范围和合理抽放时间。
On-the-spot investigation was made on the basic parameters of gas drainage in drivage roadway in Huainan Coal Mining Area, and reasonable arrangement range of rib bore-holes an...
对装置的基本流程和配置，以及基本参数的确定做了详细阐述。
This article states what basic flow chart and configuration of the polymer injection station are, and how to define the basic parameter in detail.
本文通过GN-6型手扶拖拉机的基本参数的分析与确定，进行了额定牵引力、扭矩、速度、牵引力和动力输出轴转速等验算；
Through analyzing and checking the parameters of rated force, tractor's speed, pull force and real force, a clutch of double dried frictional flake is chosen and designed in the paper.
车流密度、行车速度和交通流量是反映交通流特征的三个基本参数，三者关系的确定和模型的建立是交通工程理论研究的基础。
The models of traffic density under the conditions of different levels of service are established according to the basic relationship among the velocity, volume and density.
车流密度、行车速度和交通流量是反映交通流特征的三个基本参数，三者关系的确定和模型的建立是交通工程理论研究的基础。
The models of traffic density under the conditions of different levels of service are established according to the basic relationship among the velocity, volume and density.
应用推荐