本文根据铅的刚塑性本构关系，利用均匀塑性变形能法，推导了铅挤压阻尼器的阻尼力滞回模型。
Based on the rigid plastic constitutive equation of lead, the damping force model of lead extrusion damper was deduced from the even plastic deformation energy method.
弹孔周围的绝热剪切带沿主剪应力方向形成，与静态塑性变形滑移线方向接近，绝热剪切带上不均匀的变形将产生微裂纹和微孔洞。
An adiabatic shear band formed along the main shear stress around the penetrated hole is approximately consistent with the direction of plastic deformation slip lines in static state.
筒形件强旋时，由于不均匀的塑性变形，在旋压件内产生残余应力。
Because of the nonuniform plastic deformation, residual stresses occur in spun parts.
研究了银氧化锡电触头材料的反应合成制备以及制备的银氧化锡电触头材料在大塑性变形加工条件下的组织均匀化过程。
The fabrication of silver tin oxide by reactive synthesis and the microstructure homogenization of reactive synthesis silver tin oxide in the severe plastic deformation were researched.
组元金属之间不均匀的塑性变形是导致组元金属在拉延过程中产生缺陷的主要根源。
The defects of the component metal during drawing results from the inhomogeneous plastic flow between the two component metals.
采用金相方法，分析晶粒尺寸和变形程度对塑性变形不均匀性的影响规律，并从晶粒的各向异性角度研究其产生的机理。
Using the metallography, the effect of grain size and strain on deformation ununiformity are investigated, and the mechanism is analyzed from the viewpoint of the anisotropy of grain.
采用金相方法，分析晶粒尺寸和变形程度对塑性变形不均匀性的影响规律，并从晶粒的各向异性角度研究其产生的机理。
Using the metallography, the effect of grain size and strain on deformation ununiformity are investigated, and the mechanism is analyzed from the viewpoint of the anisotropy of grain.
应用推荐