比较了这几种接地电极的性能和可能的用途。
The characteristics and applications of those electrodes are compared.
首次确定了接地电极转动对介质阻挡放电的影响。
The effect of the rotating grounding electrode on dielectric barrier discharge is determined.
当保护一幢建筑时，允许给特殊的设备安装一个分开的接地电极吗？
When protecting a building it is permitted to install a separate grounding electrode for special equipment?
实验的结果表明：接地电极静止或转动介质阻挡放电将呈现不同的放电形式和电流波形。
The experimental results indicate that the dielectric barrier discharge will show different forms and discharge current waveforms by fixing or rotating the grounding electrode.
EMF5000电磁流量计采用四电极，内置接地电极，用于非导电管道无需另加接电环。
EMF5000 electromagnetic flowmeter with four electrodes, The built-in grounding electrode, For non conductive pipe without additional power connection ring.
每个接地电极的顶部应得到保护，免受损坏，放置在一个轻量级的检查室，类似弗斯目录号PT205。
The top of each earth electrode shall be protected from damage by placing it in a lightweight inspection chamber similar to Furse Catalogue No. PT205.
通过计算发现，随着中间电极角度和地电极角度增加，有效折射率、特征阻抗同时减小，导体损耗系数也随之减小。
The calculation results have shown that when the angles of the center electrode and the grounds decrease, the effective index, the characteristic impedance, and the conductor loss all decrease.
图4 -16示出6485型皮安计从离子收集电极测量电流的情况，这时仪器工作在地电位。
Figure 4-16 shows a Model 6485 Picoammeter measuring the current from the ion collector, which is operating at ground potential.
如果离子源偏离地电位，那么离子收集电极多半处在地电位。
If the source of ions is biased off ground, then the ion collector will most likely be at ground potential.
通过理论分析和有限元计算可以看出，电容近炸引信对地电容方程可以用等效球电极的电容方程来建立。
The formulation of the capacitance vs ground of the capacitance proximity fuze can be set up by the equivalent spheroid electrode.
分析了布极方式对稳态接地电阻测量带来的测量误差，提出了多电极法的新型布极方式。
This paper present a new electrode arrangement by analyzing errors in grounding resistance measurement under steady voltage.
着重评述多电极地电探测、地面穿透雷达、地面核磁共振三种先进的地球物理探测方法。
It comments emphatically on three advanced geophysical exploration methods of multi-electrode geoelectric measurement, ground penetrating radar and SNMR.
在其他步骤中把该第二电极(113)与该工作电位断开并且把该地电位(120)施加到该第二电极上。
In further steps, the second electrode (113) is disconnected from the load potential, and the ground potential (120) is applied to the second electrode.
在其他步骤中把该第二电极(113)与该工作电位断开并且把该地电位(120)施加到该第二电极上。
In further steps, the second electrode (113) is disconnected from the load potential, and the ground potential (120) is applied to the second electrode.
应用推荐