固相颗粒主要是碎石颗粒，液相则是黏土颗粒和水的混合物。
The solid phase is made of grain, while the liquid phase is a mixture of clay and water.
钻井过程中的油层污染可分为泥浆固相颗粒侵入和滤液侵入2种类型。
The formation damage during drilling are recognized as 2 types: mud solid particles plug and mud filtrate invasion.
双重介质储层受损害的主要原因，是外来液相的侵入或固相颗粒的堵塞。
The invasion of extrinsic liquid phase and the plugging of solid-phase particle are the main factors which damage dual-media reservoirs.
试验机内部固相颗粒的运移规律，对其处理量和处理效果均有很大的影响。
The moving rule of the solids inside the machine all has great influences on its capacity and effect.
按方程模拟计算得到的固相颗粒运移速度与实测值相比，误差小，吻合较好。
By comparing with the actually measured value, the conveyance speed of solid phased particles obtained from simulative calculation of equations has lea errors and a good coincidence.
随炉加热方式所获得的固相颗粒尺寸比热炉加热方式所获得的固相颗粒尺寸大。
The dimension of the solid phase heated from room temperature is bigger than that heated from a higher initial temperature.
针对半固态组织分析中所需的固相率、固相颗粒尺寸和圆整度进行了计算机分析。
The liquid-solid volume rate, grain size, and nodularization of solid particle within the microstructure of semi-solid metal was analyzed.
设计了用于含有固相颗粒的高温碱介质中的新型高铬铸造不锈钢的组织及化学成分。
The microstructure and composition of a high chromium cast stainless steel used in high temperature aqueous alkali with solid grains were designed.
循环流化床内固相颗粒运动特性的研究对于揭示床内气固两相流机理具有重要意义。
Research about solid particle characters in circulating fluidized bed is very important to study the principle of gas-solid two phase flow.
本文提出了利用渗透率测定仪检测泥浆固相颗粒侵入岩芯深度的方法——分段截割法。
A method for determining the depth of invasion by drilling solids from permeability measurement is proposed in this paper.
它可以是一种只包含一定颗粒范围的固相颗粒(盐的晶体和碳酸钙)和聚合物的盐水。
It may be a brine containing only selected solids of appropriate particle size ranges (salt crystals or calcium carbonate) and polymers.
研究表明：适量提高剪切速率或降低温度，半固态组织的固相颗粒会变得细小、均匀和圆整。
The results showed that the solid particle became finer, more homogeneous and rounder with the decrease of temperature or the increase of shearing rate.
采用拉格朗日模型对固相颗粒的轨迹进行了模拟，表明颗粒进口位置对颗粒的轨迹有较大影响。
Lagrangian model is employed to solve the particle momentum. It illustrates that particles with different inlet positions have different separation efficiency.
这种现象经常由过量的固相颗粒含量特别是胶质颗粒引起，或在油基泥浆或合成泥浆中由低温引起。
Often caused by excessive solids content, especially colloidal solids, or, in the case of oil or synthetic muds, by low temperature.
在进料口悬浮液固相颗粒粒级分布相同的情况下，进料口压力和底流口直径的变化同样对分离效率产生影响。
If the grain size distribution of suspending liquid at inlet is identical, the change of inlet pressure and underflow port diameter can influence the separation efficiency.
在该模型中考虑了底排出口面积比，排气固相颗粒质量比，燃料热值，燃气分子量，燃烧室总温，飞行马赫数等因素。
In the model the exit area ratio, solid particle mass ratio, fuel enthalpy of combustion, jet gas molecular weight, chamber stagnation temperature, flight Math number etc. have been considered.
掌握在不同的风速下风力分选流场中不同种类固相颗粒的分布及运动轨迹，对提高城市生活垃圾风力分选效率有很重要的作用。
Grasping the distribution of all kinds of solid grains under the different wind velocities is of great importance in approving the efficiency of garbage separating by wind force.
通过试验，当输送气速和分支管路流量控制阀开度变化时，对分支管路各自的阻力特性和固相颗粒在各分支管路中的流量分配特性进行了研究。
The paper investigated the flow distribution of solid phase and the respective resistance properties of branch pipes when both conveying velocity and the flow valve opening of branch pipe are changed.
实验发现，在液相粘度较高、表面张力大，熔体材料不浸润固相颗粒和基板等因素的影响下，烧结过程中出现了球化现象。球化的出现妨碍了直接金属激光烧结成形的顺利进行。
During the laser sintering, due to the large liquid phase viscosity and surface tension, the balling effect occurred when the molten did not wet the solid metal particle and the underlying substrate.
旋风分离器是一种利用气固两相流体的旋转运动使固体颗粒在离心力的作用下从气流中分离出来的设备。
Cyclone separator is a kind of equipment that USES rotary motion of gas-solid two-phase fluid to make the solid particle separated from the gas flow by centrifugal force.
计算结果表明颗粒间非弹性碰撞和气固间曳力的增大均使气固两相流动的非均匀性增大。
The results show that the stronger the particle-particle collisional dissipation and gas-solid drag force, the more heterogeneous the flow structure.
对稀相区在较高固粒流率下对颗粒运动速度进行了变工况分析和讨论。
Under the high solid flux, in the dilute flow region, the particle velocity is analyzed and discussed with the variation of operating condition.
模拟计算表明气固两相射流速度沿轴向和径向减小，颗粒浓度下降。
Simulation results shown that the jet velocities of gas and particle phases, and concentration decreased along both the radial and axial directions.
在固液相填充复合体系中，采用合理的颗粒级配可使颗粒排列更加紧密，提高堆积密度。
In composite system filled with solid and solid liquid phase, rational particle grade improve particles arrangement closer and increase stacking density.
预热预分解系统的气固两相流中，颗粒、颗粒特征及运动规律是影响预热系统热效率的重要因素。
Particle in the gas and solid two- phase flow of precalcining system, particle characteristic and moving rule are important factors that influence heat system efficiency.
农用硝铵改性后，熔融物料粘度大，含有固相悬浮颗粒，引起生产过程中喷头堵塞现象。
After modification of agricultural ammonium nitrate, the molten material has a high viscosity and contains solid suspended particles, leading to blockage of the prilling basket during production.
颗粒的流动速度是反应气固两相流流动状况的一个重要参数。
Particle velocity is an important parameter describing the flow state of gas-solid two-phase flow.
利用气固两相流颗粒间应力与空隙率之间的定量关系，推导了火工药剂压药压力与装药密度之间的定量关系。
Based on stress and cavity relationship of particles in gas-solid two phase flow field, quantitative correlation of pressure and density of pyrotechnic charges was deduced.
利用气固两相流颗粒间应力与空隙率之间的定量关系，推导了火工药剂压药压力与装药密度之间的定量关系。
Based on stress and cavity relationship of particles in gas-solid two phase flow field, quantitative correlation of pressure and density of pyrotechnic charges was deduced.
应用推荐