微 热量 计 对硝酸锌与组氨酸在水中的固液反应进行了热动力学研究。
The thermokinetics of solid liquid reaction of zinc sulfate with histidine are studied using a microcalorimeter.
在固液反应球磨过程中，三元合金产物的元素摩尔比接近于二元母合金中的元素摩尔比；
The atom ratio of the ternary alloy was close to that of the binary alloy.
采用固液反应球磨技术在高温下可以形成粒度很小，甚至达到纳米级的金属间化合物粉末。
The particle size of the powder from solid-liquid reaction milling is fine, even though reaches to nanoscale.
这一形式简单、使用极方便的数学模型在非瞬间反应系统的成功应用，更有力地证明其对某些类固液反应的适用性。
This success in simulating non-instantaneous reaction strongly manifests the capability of the model in describing the behavior of some solid-liquid reactions.
氨水与硫酸(SO3)进行中和反应，反应液经过真空蒸发、浓缩、结晶，再进行液固分离、干燥等工序制得产品。
Ammonia and sulfuric acid (SO3) in and the reaction liquid after vacuum evaporation, concentration, crystallization, and then to liquid-solid separation processes obtained dry product.
磷矿粉(浆)与硫酸反应，反应料浆进行液固分离，得到湿法稀磷酸。
Phosphate rock (plasma) and sulfuric acid reaction, the reaction slurry to liquid-solid separation, dilute phosphoric acid to be wet.
固相交换样品的比表面、孔容变化和异丙醇分解反应活性都与液相交换样品相同，只是交换度的函数，与交换方法无关。
The surface area, the pore volume and the activity of isopropanol decomposition reaction are only a function of exchange degree and are not affected by the exchange methods.
用新型磷酸铝分子筛和硅磷酸铝分子筛作催化剂，对丙酸和正戊醇液—固相酯化反应进行了研究。
The esterification reaction of propionic acid with n-pentanol was studied by using novel aluminophosphate and silicoaluminophosphate molecular sieves as catalysts.
理想的射孔液应是洁净的而且无固相(经过过滤)，与储层接触时不会反应产生损害性副产物。
The ideal fluid is clean and solids-free (filtered), and will not react to cause damaging by-products on contact with the reservoir formation.
苯酚直接羟化制备苯二酚为液固相的强放热快反应，催化剂的活性衰减很快。
The hydroxylation of phenol to produce dihydric phenol is a rapid and strongly exothermal reaction, the activity of the complex-oxide catalyst decreased rapidly.
本文研究探讨了微电解反应过程中硝基苯降解的情况，这是固液界面过程。
This paper has studied and discussed the reducing of nitrobenzene in the microelectrolysis reaction course, which is a solid-liquid interface course.
本文针对目前湿法炼锑工艺过程研究的需要，对类似于辉锑矿浸出过程的液-固间歇式多相反应动力学模型进行了推导。
A model was developed for the kinetics of the liquid-solid phase reactions in a intermittent reactor, such as the leaching process of stibnite in the antimony hydrometallurgy.
低温反应的优点是所得物料便于固液分离，节省加热蒸汽，减少氨挥发。
Low reaction temperature has the advantages of easy separation of solid from liquid for the obtained material, saving heating steam and reducing ammonia volatilization.
同时根据非等温变体积条件下的动态法，液-固相反应的特点，导出了反应速率方程。
According to the catalytic characteristic of dynamic method, the equation of reaction rate has be deduced under the non-isothermal and volume-varying condition.
同时根据非等温变体积条件下的动态法液-固相反应的特点，导出了反应速率方程。
According to the catalytic characteristic of dynamic method, the equation of reaction rate has be deduced under the non isothermal and volume varying conditions by kinetic calculation.
介绍了固相反应法、液相反应原位喷雾干燥法等加工纳米结构喷涂粉材的新方法。
Some new methods, solid state reaction by mechanical milling and liquid state reaction followed by spray drying, of synthesizing nanostructured feedstock are proposed.
介绍了环流反应器流体力学参数的测定方法，这些参数包括气含率、循环液速、固含率、气泡大小及速度。
Determination methods of parameters which involved gas holdup, liquid circulation velocity, solid holdup, bubble behaviors etc in the loop reactor were introduced.
研究了固载液相铂催化剂的制备及其在3-氯丙烯与甲基二氯硅烷硅氢加成反应中的催化性能；
The preparation of supported liquid-phase platinum catalyst, and its catalytic property for hydro-(silylation) reaction of 3-chloropropene were studied.
在不同的导流筒直径、喷嘴直径和喷嘴位置对液固环流反应器中固体流动行为进行考察。
The solid flow behavior in liquid-solid loop reactor was studied with draft tubes, and nozzles of different size and with different nozzle location.
设计了一种涡旋脉冲式反应装置，分析了气-液或气-液-固多相体系在涡旋脉冲式反应装置中的流动状态及特点。
Vortex and Pulsed Reaction Equipment (VPRE) was presented. The flow pattern and characteristics for gas-liquid or gas-liquid-solid system in VPRE were analyzed.
伴之以酒厂废水厌氧处理的可行性探讨，我们设计和试验了一种设有新型固、气、液三相分离器的UASB反应器。
A modified UASB system with a new type of gas-liquid-solid separator was investigated with regard to its feasibility for the anaerobic treatment of brewery waste.
固含率分布和液相返混系数是液固磁稳定反应器放大与优化所必需的基础数据。
Solids holdup distribution and liquid backmixing coefficients are fundamental to the scale-up design and optimization of liquid-solid magnetically stabilized reactors.
本研究拓宽了反应分离过程的适用范围，对气-液-固三相反应生产过程具有重要的参考价值。
Applicable range of reactive separation process is extended to other processes using gas-liquid-solid phases for reference.
详细介绍了作为锂离子筛前驱体的锂锰氧化物和锂钛氧化物的制备方法，包括固相烧结法和液相反应法等。
Various preparation methods of lithium-manganese oxide and lithium-titanium oxide which act as precursors of lithium ion-sieves were introduced, respectively.
根据在反应体系中的不同存在形态和催化过程，把非均相化含钨催化剂分为液-液两相催化剂和固载化催化剂两大类。
According to the different patterns and catalytic processes, the heterogeneous catalysts are classified into two types, namely liquid-liquid biphasic catalyst and immobilized catalyst.
综述了近五年冷态气液固三相搅拌反应器的研究成果，阐明近期研究热点已转为热态多相流搅拌反应器的流体力学行为。
The progress of the research on hydrodynamics in gas-liquid-solid three phase stirred reactors in the last five years is reviewed.
反应过程包括：固固反应、液固反应、铁浴反应和液液反应。
The reduction processes consist of solid-solid reaction, liquid-solid reaction, reaction in molten steel and liquid-liquid reaction.
研究了反应时间、液固比、酸煤比、超声波四个因素对硫酸法提取效果的影响。
The four effect factors of Sulfuric acid method, including reaction time, solvent-to-solid ratio, acid-to-coal ratio, and ultrasonic, were investigated.
实践表明，该技术结晶速度快、反应器容积小、固液分离快，具有较好的应用前景。
The practice shows that the technology has advantages of rapid crystallization rate, small reactor volume, and rapid solid-liquid separation. It shows a broad prospect for application.
研究反应时间、液固比、酸煤比、提取液含水量四个因素对硫酸丙酮法提取效果的影响。
The effect of four factors, reaction time, solvent-to-solid ratio, acid-to-coal ratio and the water content in extraction mixture, were studied on the extraction rate of acetone-sulfuric acid method.
应用推荐