因此，在被动式测量时，要密切注意发射源温度以及发射源发射信号大小，以便获得最佳仪器响应函数校正结果。
So, during passive FTIR measurement, the temperature and the emission signal amplitude of the source must be observed carefully in order to get satisfactory instrument response function.
典型的测量流量、水位、温度、压力、流量往往是最困难的，因此最受不正确的设备的选择。
Of the typical measurements of flow, level, temperature and pressure, flow tends to be the most difficult and therefore the most subject to incorrect device selection.
因此，对硅光电池温度特性的测量非常重要。
Therefore, it is very important to measure the temperature characteristic of the silicon photocell.
目前突变型PTC元件电阻温度系数的测量方法各种各样，因此测试结果缺乏唯一性和可比性。
Resistance temperature coefficient (RTC) of step function PTC thermistor depends on it's measurement methods, therefor the obtained results are not unique and comparable.
因此，建立一个合理的温度补偿系统已成为克服测量误差的必要手段。
So, set up a reasonable temperature compensation system is important to get over the error.
因此第零定律，使你可以定义温度的概念，以及通过温度计，测量温度的方法。
So, zeroth law, then, allows you to define the concept of temperature and the measurement of temperature through a thermometer.
因此 ，在热电偶测温时 ，可接入测量仪表 ，测得热电动势后 ， 即可知道被测介质的温度。
Therefore, the temperature at the thermocouple can access measurement instruments, thermal electromotive force measured, you can know the temperature of the measured medium.
因此测量样品光谱的同时测量样品温度，结合温度修正模型可以有效的提高近红外光谱定量分析精度。
It suggested that the temperature of the samples should be measured and the temperature correctional model improved the analysis precision.
因此，可测量该轴承的所需位置的温度。
As a result, the temperature of a desired position of the bearing can be measured.
液压油温度变化是对测量精度影响的主要因素之一，因此深入研究了液压油温度控制技术。
Hydraulic oil temperature is one of main influence factors for measuring, so this dissertation researches the hydraulic oil temperature control technology in detail.
温度传感器安装到所述密封装置，并且因此与环形轮接触的密封装置的温度可以被直接测量。
Because a temperature sensor is attached to the seal, the temperature of the seal directly in contact with a rotating ring can be directly measured.
温度传感器安装到所述密封装置，并且因此与环形轮接触的密封装置的温度可以被直接测量。
Because a temperature sensor is attached to the seal, the temperature of the seal directly in contact with a rotating ring can be directly measured.
应用推荐