环式电网的求解一般可直接采用回路电流法，但需要进行繁琐的运算。
The solve of the loop power networks can be got directly through circuit current method, but the complex calculation are also needed.
为了对异步发电机十二相功率绕组带整流负载系统进行仿真计算，采用了基于电路拓扑理论的回路电流法。
By means of circuit topology theory and loop current method, simulation and calculation are performed on the 12-phase power winding of an induction generator with rectifier load system.
以回路电流法为基础，选定某一定子绕组为基准绕组，列写了用矩阵形式表示的、计算回路电流及支路电流的网络方程。
The network equations based on loop current method and expressed in matrix form are established, and the loop currents, then the brance currents, can be calculated by the equations.
同时针对阻尼绕组提出了用多回路法计算阻尼条电流的方法，并提出一种数据传递方式实施对阻尼绕组的监测。
A multi circuit calculation method is suggested for calculation of the current of the damping winding bar and a method of data transfering is offered to monitor damping winding.
同时针对阻尼绕组提出了用多回路法计算阻尼条电流，并提出一种数据传递方式实施对阻尼绕组的监测。
Be directed to damp winding damp bar is calculated though multi circuit method, and a way to transfer data is offence to monitor damping winding.
差动保护电流回路接线是否正确，可通过相量分析法和带负荷检验法进行判断。
The wiring correctness of differential protection current loop can be verified using phasor analyzing method and on load testing method.
但是基本的回路分析法不能用于处理含有电流源支路的回路分析问题。
But fundamental loop analysis method can not be used for approaching the loop analysis problems of the loop containing current source branch.
关于节点分析法中理想电压源的附注同样可以应用到回路分析法中出现理想电流源的情况。
The same remarks for the ideal voltage source in nodal analysis apply to ideal current sources in loop analysis.
应用“多回路分析法”深入、详尽地计算了13 104种短路故障的全部分支电流的大小和相位。
The phase and the size of all branch currents of the 13,104 kinds of fault of short circuit were calculated thoroughly thorough " mufti - bop analysis ".
差动保护电流回路接线是否正确，可通过相量分析法和带负荷测六角图检验法进行判断。简要介绍这两种方法，并介绍了利用潮流方向验证六角图的方法。
The wiring correctness of differential protection current loop can be verified by using phasor analyzing method and on load test method. These two methods were described.
差动保护电流回路接线是否正确，可通过相量分析法和带负荷测六角图检验法进行判断。简要介绍这两种方法，并介绍了利用潮流方向验证六角图的方法。
The wiring correctness of differential protection current loop can be verified by using phasor analyzing method and on load test method. These two methods were described.
应用推荐