基于TMS32 0C5 4X的电力系统二次回路测量系统具有体积小、稳定性高等优点，电力领域应用广泛。
The system can test the secondary load of electric power based on TMS320C54X has has extensive applications in electric power etc.
一般而言，在测量系统中应该只有一个点被连接到接地，以避免形成接地回路。
In general, only one point in the measurement system should be connected to earth ground to avoid ground loops.
研究了某厂丁二烯精馏塔塔底控制回路目前存在的问题，提出了基于软测量的推断控制方案。
The existing problems in bottom tower control of butadiene rectifying tower in certain plant are investigated. The inference control strategy based on soft measurement is stated.
必须具有测量环节，以指示被测回路所控制的变量当前值。
Measurement must be made to indicate the current value of the variable controlled by the loop.
本文针对核电站二回路管道测厚部件、测厚方法、测量参数选择及测量步骤等进行探讨。
According to the two loop nuclear power plant pipeline thickness measurement component, thickness measurement, measurement parameters and measuring steps, etc. are discussed.
泄漏电流将在此回路中流动，但是不影响测量。
A leakage current will flow around this loop, but won't affect the measurement.
这需要比例调节阀和流量测量形成的回路控制。
Flow is measured via an orifice plate metering run with a differential pressure transmitter providing feedback to the control loop.
如果信号源或测量装置的回路侧被连接到相同点，干扰将最小。
If the return side of the signal source or the measuring device is connected to this same point, there will be a minimum of interference.
本文以测量回路中的接触电阻为例，讨论微小电阻的测量方法。
We regard the contact electric resistance of measuring in the circuit as an example in the text, and discuss method of measurement of small electric resistance.
先检查变频器的主回路，测量整流模块和逆变模块特性良好。
Check the main loop and measurement frequency inverter modules and rectifying module properties is good.
测量装置主要包括高温环境实验箱、加热供电回路、两套高速高温计及一套激光扫描系统构成。
The apparatus mainly consists of a high temperature environmental chamber, a power circuit of heating, two high-speed pyrometers , and a laser scanning system.
测量了这三组线圈中的放电电流，并将测量结果与回路计算结果作了比较。
The discharge currents for these three coils were measured and compared with the circuit calculations.
对电气回路中因谐波造成的电力线路中性线过载和测量仪表出现较大误差的原因进行了分析，探讨了抑制谐波的措施。
The paper analyses the causes of overload of neutral line and great errors of measuring instrument by harmonics electrical line.
介绍了钳形接地电阻测试仪的测试原理，即在测量时必须要有一个供电流流过的有效的闭合回路。
It describes the measure principle of the clamp grounded resister tester, that is, a effective close loop for current flow is necessary when doing the test.
本文研究了在液态金属回路中环形流道的电磁流量测量问题。
The electromagnetic flow-measurement in the annular channel of the liquid-metal loops was investigated.
电容的微小变化可通过对高频谐振回路调制的方法进行测量。
Any subtle change of capacitance can be measured through the method of modulation on high-frequency harmonic oscillation return circuit.
本文应用以传输线方程为基础的在线测量法对同杆并架双回路输电线路的工频参数在线测量方法进行研究和探讨。
In this thesis, we use an on-line measurement method to study the parameters measurement for the double-circuit transmission lines which is based on the transmission line Equation.
针对俯仰回路，利用测量的俯仰角实现了俯仰回路姿态控制；
The pitch control is attained by the measurement of the pitch angle.
由于回路之间互感作用的存在，给多回路输电线路参数的测量带来了很大的困难。
And it gives a huge challenge for the parameters measurement due to the mutual inductance effects between different lines.
由于回路之间互感作用的存在，给多回路输电线路参数的测量带来了很大的困难。
And it gives a huge challenge for the parameters measurement due to the mutual inductance effects between different lines.
应用推荐