回火钢柄支持和稳定你的整个身体，减少脚和身体的疲劳。
Tempered steel shank supports and stabilizes your entire body, reducing foot and body fatigue.
阐述了超高强度的淬火回火钢（调制钢）在深海半潜式钻井平台中的应用。
This paper describes the application of high strength quenched and tempered steel in semi-submersible drilling platform.
国产新型塑料模具钢主要有预硬钢、时效硬化钢、淬火——回火钢、冷挤压成型模具钢、耐蚀钢等类型。
The new domestic - developed plastic mould steels include prehardening steel . age hardening steel, quenching-tempering steel, cold -forming steel, and anti - corrosion steel, etc.
钢的热处理操作主要有三种，即：淬火、回火和退火。
There are three main operations in the heat treatment of steel: hardening tempering and annealing.
钢的热处理操作主要有三种，即：淬火，回火和退火。
There are three main operations in the heat treatment of steel: hardening, tempering and annealing.
回火完全淬硬钢得到的最终组织结构被称为回火马氏体。
The final structure obtained from tempering a fully hardened steel is called tempered martensite.
与经普通淬火和高温回火的相比，经磁场淬火和高温回火的T10钢的抗拉强度提高了28%，断后伸长率提高了8。
The tensile strength, elongation and hardness of T10 steel subjected to magnetic field quenching and to high temperature tempering were separately increased by 28%, by 8.
采用焊接热模拟技术和显微分析方法，研究了回火焊道热处理对X80级管线钢焊接热影响区韧性的影响规律。
The effects of tempering weld-pass treatment on toughness of HAZ of X80 pipeline steel were studied by the technique of welding thermal simulation and the method of microscope analysis.
经过回火之后，钢的强度增大，因为其晶粒变细了。
After having been tempered, the steel becomes stronger because its grains get finer.
由于马氏体这一淬硬钢主要成分的不稳定性，使得回火成为可能。
Tempering is possible because of the instability of the martensite, the principal constituent of hardened steel.
钢是通过加热再放进冷水里回火炼成的。
Steel is tempered by heating it and then putting it into cold water.
钢的热处理工序包括硬化、回火、退火和表面硬化。
The procedures of heat treatment of steel include hardening tempering annealing and case hardening.
钢板应为全镇静钢且经奥氏体精细粒度处理。规格化的，规格化及回火的或淬火及回火。(译文请指正)。
The plates shall be fully killed and shall be fine austenitic grain treated. They shall be normalized, normalized and tempered or quenched and tempered.
本文介绍国产A508-3钢在不同的淬火、回火和退火条件下的热处理实验的某些结果。
This paper presents some results of heat treatment experiments of A508-3 steel at different quenching, tempering and annealing conditions.
试验结果表明H13钢在最佳完全退火温度、淬火温度、回火温度下可得到最优综合性能。
The test results show that the surface of H13 steel can obtain the optimum performance at temperature of complete annealing, quenching and tempering.
磨削热导致回火引起淬硬钢磨削后表面硬度变化。
Tempering resulting from grinding heat caused surface hardness changes of hardened steels after grinding.
研究了T10钢在低温盐浴渗铬后直接淬火并回火工艺。
Immediate quenching and tempering process of steel T10 after low temperature salt bath chromizing was studied.
铬钒钢盘条金属丝和弹簧。高负荷地线。淬火和回火。规范。
Chromium - vanadium steel wire rod, wire and springs - high duty ground wire - hardened and tempered - specification.
关于钢的淬火和回火有两个要点需要注意。
Two important points are to be noted in connection with the quenching and tempering of steel.
研究了新型碳化物贝氏体耐磨钢不同回火温度下的组织与力学性能。
The authors researched on the microstructure of a new non-carbide bainite abrasion resisting steel under the different tempering temperatures and its dynamic performance.
同时，提出了一种确定淬火钢回火工艺的新方法。
And, a new method of determining the technology of tempering of the hardened steel is also advanced.
弹簧为低应力、油回火、螺旋缠绕在整体钢轴上扭力型弹簧。
Springs shall be low-stress, oil tempered, helical wound, torsion type on continuous shaft, Solid CRS or tubular as required.
钢是通过先加热后冷却来回火的。
结果表明：回火索氏体是最佳的组织形态；微观硬度的不均匀性显著影响钢的表面加工质量。
The results indicated that the tempered sorbite was the optimum microstructure, the inhomogeneous distribution of micro hardness affected markedly the finish quality of the steel surface.
研究了试验载荷、滑动速度、对不同温度回火的45钢耐磨性的影响。
Effect of different experimental load and velocity on the wear resistance of 45 steel tempered at different temperatures has been studied.
另一方面，为了评估回火温度对疲劳性能的影响，将MIM钢试样于不同温度下进行了回火。
On the other hand, the MIM steel specimens were tempered at various temperatures in order to evaluate effect of tempering temperature on fatigue property.
MIM钢试样的疲劳强度随着回火温度升高而减低。
Fatigue strength of the MIM specimens declined with increasing tempering temperature.
通过高温抗氧化、盐雾腐蚀和应力腐蚀试验研究了07X16H6沉淀硬化不锈钢在使用状态（回火态）时的耐蚀性能。
The corrosion resistance of 07X16H6 precipitation hardening stainless steel in tempered state was studied using high temperature oxidation, salt-spray test and stress corrosion test.
通过高温抗氧化、盐雾腐蚀和应力腐蚀试验研究了07X16H6沉淀硬化不锈钢在使用状态（回火态）时的耐蚀性能。
The corrosion resistance of 07X16H6 precipitation hardening stainless steel in tempered state was studied using high temperature oxidation, salt-spray test and stress corrosion test.
应用推荐