二次回火后硬度变化不大，三次回火后，硬度反而降低。
Two times temper has little effect on the hardness, three times temper will decrease the hardness.
在应变疲劳曲线上，弹性线和塑性线的交点随弹簧钢回火后硬度的升高而向低循环寿命移动；
The point of intersection of elastic line and plastic line moves toward the low cycle life with the hardness of the spring steel raised after tempering from the strain fatigue curve.
通过合并磨削热模型和回火效应可以预测工件磨削后的表面硬度变化。
Combining the tempering behavior with the grinding thermal model, the change in surface hardness due to grinding heat could be predicted.
通过合并磨削热模型和回火效应，可以预测工件磨削后的表面硬度变化。
Combining the tempering behaviour with the thermal model of grinding, the change in surface hardness due to grinding heat can be predicted.
磨削热导致回火引起淬硬钢磨削后表面硬度变化。
Tempering resulting from grinding heat caused surface hardness changes of hardened steels after grinding.
多次回火后，高钒高速钢硬度降低，耐磨粒磨损性能下降。
The hardness and the wear resistance decrease after multiple tempering.
结果表明，P2 0钢回火后的硬度越高，粗糙度越低，抛光性能越好；
The results showed that the hardness of tempered P20 steel higher, the roughness lower and the polishing performance better;
研究了1.2311塑模钢扁钢尺寸、终轧温度、回火温度等主要工艺参数对其轧后硬度、回火硬度及组织均匀性的影响。
The influence of processing parameters, such as finishing rolling and temper temperatures, on the hardness and microstructure of 1.2311 plastic die flat steel were studied.
硬度能做到61——65hrc成熟工艺是：铸造后软化退火，便于加工，加工后空冷淬火加低温去应力回火。
Hardness can do 61 — 65hrc maturation process is: annealing, softening after casting machining, machining of air cooling after quenching and low temperature stress tempering.
经焊后回火热处理后，主要合金元素沿焊合区的扩散区宽度增大；焊合区钛合金侧硬度值显著提高。
The diffusion zone width of main alloying elements increases and hardness of the friction weld zone near TC4 titanium alloy side improves after post-weld heat treatment.
经焊后回火热处理后，主要合金元素沿焊合区的扩散区宽度增大；焊合区钛合金侧硬度值显著提高。
The diffusion zone width of main alloying elements increases and hardness of the friction weld zone near TC4 titanium alloy side improves after post-weld heat treatment.
应用推荐