油管路、主机回油过滤器易堵塞;
The oil pipeline, the main engine oil discharge filter easy to stop up;
稳压补张后回油至设计控制应力进行锚固。
Anchorage shall be carried out when the pressure stabilizing and tensioning make up is made.
压缩机并联技术的关键在于解决回油分配问题。
The key technology on compressor parallel is to maintain the safe oil levels.
单孔式回油,模具采用高碳钨合金钢不易破损。
Punch dies made of high carbon tungsten steel and not easy to wear off.
带停机防回油。
皮鞋一般在鞋底回油软垫,可以支撑脚掌的拱形部位。
Mike: They even have special insoles to support the arches of my feet.
扩大氢侧回油腔的容积改进了国产机回油不畅的问题。
Expanding circulating oil cavity on hydrogen side can make circulation free.
压缩机并联运行系统的稳定可靠运行,回油问题是关键。
Oil return is a key problem for stable and reliable operation of compressor parallel operation system.
介绍了装载机双泵合流液压系统的回油冷却机构的原理。
The paper introduces the theory of return oil cooling mechanism for the dual pump converging hydraulic system of loaders.
油气平衡式并联技术平均分配回油,并强调气压和油位的平衡。
Return oil is equally divided, and uniform crankcase pressure and oil level are purposely kept in equilibration parallel system.
测试数据分析表明,回油压力过高是造成液压油散热器爆裂的原因。
Through the analysis of test data, we find that the cause of the blowout of hydraulic oil radiator is the higher return oil pressure.
非平衡并联机技术建立了压缩机回气压力等级,并按等级高低分配回油。
The dynamic technology ranks the compressors according to the crankcase pressure levels, and return oil is not distributed equally but according to the order based on the ranks.
摘要:研究出一种新思路,用于设计制冷系统油分离器回油毛细管的规格。
Abstract:A new idea is studied out for the design of the specification of oil return capillary ofrefrigeration system's oil separator.
本文推导了液控单向阀的控制压力特性方程、进油和回油回路机械特性方程。
This paper derives the characteristic formula of control pressure in hydro-control check valve and the mechanical characteristics formula of inlet and return circuit.
自动回油 试验台原理简单、易制作,而且同样可以应用于其它相关设备上。
The automatic oil return test platform has simple principle and is easy to be produced, and also can be applied to other relevant devices.
对回油口处过滤网进行清洗,清除附着在过滤网上的杂质。注意事项有以下几点。
Three, clean the oil filter at the mouth of the filter, remove impurities attached to the filter.
再一次分离出来的油份,通过填料过滤层外缘的凹槽,亦将由回油管回到底部的油室。
Once again the separated oil share, through the outer packing filtration layer grooves, also will be back to the bottom of the tubing oil room.
本文接下去的设计计算将通过试验验证、修正,为离心回油式喷嘴计算提供一定的借鉴。
The later coming test work will help further validating and correcting. It is significant for the design calculation of a pressure-swirl nozzle with oil returning channel.
介绍了氟里昂制冷系统中,在压缩机和蒸发器的各种使用情况下,制冷管道的回油设计。
Provide oil back design of refrigeration piping under various conditions of evaporator and compressor in freon refrigeration system.
通过对相对偏心率简化计算误差的分析,提出腔内孔式回油静压轴承设计中的几点建议。
Several Suggestions on designing the hydrostatic bearings by using relative eccentric ratio to simplify the calculating error analysis have been proposed.
在低温状态下它可提供良好的溶解度及确保油浴式蒸发器良好的回油情况以及较好的热交换效率。
It may provide the good solubility under the low temperature condition and guarantees the oil bath type evaporator good oil discharge situation as well as the good heat change efficiency.
开式系统是指液压泵从油箱吸油,油经各种控制阀后,驱动液压执行元件,回油再经过换向阀回油箱。
Open system is the pump suction from the tank, the oil through a variety of control valves, the drive hydraulic actuators, valve oil return back for another fuel tank.
泵内有设计合理的泄油和回油槽,是齿轮在工作中承受的扭矩力最小,因此轴承负荷小,磨损小,泵效率高。
There are well-designed pump drain back tank and is exposed in the work gear torque exerted the smallest, so bearing loads of small, wear, pump efficiency.
泵内有设计合理的泄油和回油槽,是齿轮在工作中承受的扭矩力最小,因此轴承负荷小,磨损小,泵效率高。
Pump is the drainage and back into the groove of reasonable design, is a gear in the work under the minimum torque force, so the bearing load is small, wear small, pump with high efficiency.
泵内有设计合理的泄油和回油槽,是齿轮在工作中承受的扭矩力最小,因此轴承负荷小,磨损小,泵效率高。
Pump discharge of oil with reasonable design, gear oil and back at work under minimum torque force bearing load, so small, wear small, pump with high efficiency.
输送皂角泵内有设计合理的泄油和回油槽,是齿轮在工作中承受的扭矩力最小,因此轴承负荷小,磨损小,泵效率高。
Pump is the drainage and back into the groove of reasonable design, is a gear in the work under the minimum torque force, so the bearing load is small, wear small, pump with high efficiency.
非法加工者再将地沟油回卖给餐厅。
Illegal processors may then sell the oil back to restaurants.
为了防止出现这种情况,所产出的湿气通常要脱除凝析油,并将干气再注入储层(干气回注)以保持储层压力。
To prevent this, the wet gas that is produced is often stripped of condensate and the dry gas is reinjected into the reservoir (cycling) to maintain reservoir pressure.
结果表明,羧酸盐类表面活性剂适合曙22块化学驱油用剂,其与回注污水具有较好的配伍性及较好的溶解性和抗盐性。
The result showed that the surfactant was applicable for chemical flooding for She 22 Block, it was compatible well with the recycled produced water and showed good solubility and salt resistance.
结果表明,羧酸盐类表面活性剂适合曙22块化学驱油用剂,其与回注污水具有较好的配伍性及较好的溶解性和抗盐性。
The result showed that the surfactant was applicable for chemical flooding for She 22 Block, it was compatible well with the recycled produced water and showed good solubility and salt resistance.
应用推荐