此模型判断如何选取轧机速度曲线图，首次提出根据轧制变形区各参数来计算不同压下量下的最大轧制速度以及咬入速度。
This model firstly judges how to choose a right curve of rolling speed, then calculate the Max rolling speed and entering speed according to the parameters in deformation zone.
详细介绍了圆盘式飞剪各主要参数的确定，包括交角、咬入条件、剪刃重叠量、摩擦系数、轧制速度等。
Setting main parameters of disc flying shears are presented in detail. including cut Angle, bite conditions, amount of scissors overlapping, friction coefficient and rolling speed etc.
工作辊磨损后，粗糙度递减导致在较高轧制速度下进料(咬入带卷)时产生滑移。
When work rolls become worn the roughness is diminishing creating slippage in the roll bite at higher speeds.
咬入阶段AGC系统不投入的影响可通过减小咬钢速度的方法进行部分消除。
The influence of biting without AGC can be partly reduced by slowing the biting speed.
咬入阶段AGC系统不投入的影响可通过减小咬钢速度的方法进行部分消除。
The influence of biting without AGC can be partly reduced by slowing the biting speed.
应用推荐