方法用吸湿率、防潮性、耐撞击性等进行比较。
METHODS Compared with moisture rate, moisture-proof and the endurance of impact test.
食糖消费量大幅增加，具有吸湿率水平，高达75%。
Sugar consumption rate increased considerably with moisture level, up to 75%.
碱处理后的BTTPF，其吸湿率、吸水高度和上染率比纯涤纶更佳。
After alkali treatment the hygroscopicity, suction lift and dye uptake of BTTPF were better than those of the pure polyester filament.
通过DSC密度法等测定改性聚酯的超分子结构，并测试了改性聚酯的吸湿率。
The super molecular structures are tested by DSC density method and also the moisture pickup are measured.
结果表明，反应介质对聚丙烯酸酯浆料浆膜的强伸性、耐磨性、耐屈曲性、吸湿率和水溶速率性能都有显著影响。
The result shows that the property of the sizing film of polyacrylate size strongly depends on the used mediums.
随着炭化终点温度的升高，竹炭的得率、电阻率、挥发分含量都有不同的降低，竹炭的灰分含量、固定碳含量及吸湿率等都有不同程度的增加。
The yield, the resistivity, and the volatile matters content decreased as the carbonized temperature increased. While the fixed carbon content, absorption rate increased.
结果表明，由于蛋白腹为亲水性膜，受环境湿度的影响，其水分含量、分子间作用力有所不同，从而导致蛋白膜的机械性能、透湿性和吸湿率也随之发生变化。
This result showed that the change of relative humidity led to the variation in mechanical properties, water vapor permeability (WVP), oxygen permeability and moisture absorption of the films.
结果表明：处理材的厚度吸湿回复率为2.68%，具有良好的尺寸稳定性，说明压缩变定效果好。
The result showed that the treated wood had good dimension stability, and the moisture Absorption recovery ratio of thickness was 2.68%, which indicated that the set of compression was almost fixed.
随着接枝率的大幅度提高，纤维织物的吸湿性和染色性有明显的提高，但纤维织物的机械性能将有所下降。
The results show that the hygroscopicity and dyeability improve significantly with the big increase of grafting rate, while the mechanical strength of the fabric lowers somewhat.
方法确定加入辅料最大量，选择处方，制备药粉，测定吸湿量百分率、休止角、堆密度。
Methods To determine the maximum dose of adjuvant, select formula, prepare powder, and detect hygroscopicity, Angle of repose and bulk density.
烟叶是一种吸湿性强的物料，在一定温湿度环境下烟叶保持一定的温度和含水率。
Tobacco leaves are high moisture material, and keep a certain moisture and temperature under certain environment and moisture.
并讨论了各单因素条件对接枝率的影响变化规律，同时分析了接枝产物的结构及吸湿性能。
Moreover, the effect regularity of every condition on grafting percentage was discussed, and the structure and hydrophilicity of grafted nonwoven were analyzed.
通过湿热老化试验，研究了APMOC纤维吸湿性能、拉伸强度、断裂延长率以及弹性模量随老化时间的变化。
The changes of moisture absorption properties, tensile strength, fracture elongation and elastic modulus of APMOC fiber with aging time were investigated through the hygrothermal aging test.
竹浆纤维因其加工方法不同，除吸湿能力优于竹原纤维外，其放湿速度慢、吸湿溶胀率小、耐热性能也比竹原纤维差。
The bamboo pulp fiber has worse properties of swellability, moisture absorption and liberation rate and thermal stability except hygroscopic capacity.
对南水北调中线强膨胀岩重塑样进行了膨胀率试验，分析吸湿条件下膨胀岩膨胀变形规律。
The swelling deformation properties of expansive rock during moisture absorption are studied by means of the expansion ratio tests.
方法：以颗粒吸湿百分率、成型率和溶化率为指标，筛选颗粒最佳辅料与配比。
METHODS: The ratio of main components to excipients was optimized with hygroscopicity, granulation and dissolubility index.
方法：以颗粒吸湿百分率、成型率和溶化率为指标，筛选颗粒最佳辅料与配比。
METHODS: The ratio of main components to excipients was optimized with hygroscopicity, granulation and dissolubility index.
应用推荐