低惯量的直流传动电动机由快速可控硅装置供电。
The low inertia DC drive motor is supplied by a quick thyristor unit.
中频大功率感应加热装置，多年来一直采用可控硅做为开关器件。
Medium frequency high power induction heating apparatus, for many years has adopted silicon controlled as switching devices.
本文论述了可控硅逆变器逆变角影响串级调速装置功率因数的基本原理。
This paper discusses the basic principle which the inverted firing angle of thyristor inverter has the influence on power factor of a cascade connected device.
最终查出造成机组事故的根本原因是可控硅励磁装置供电电源无工作状态监视信号及故障报警信号；
The final basic cause that resulted in the failure is no working state monitoring signal and failure warning signal of power supply source of controlled silicon excitation device.
直流电机驱动采用全数字可控硅变流装置控制。
Adopting digital control silicon deflector device when AC motor driving.
设计并研制出了工作频率为2.5千赫，输出电流从60到250安连续可调的可控硅斩波器及其栅控装置。
A 2.5 KHZ SCR chopper, with the output current controlled continuously from 60a to 250a, and its grid-control device has been designed and built.
本文对用微型计算机取代传统的可控硅驱动控制装置作了初步的探讨。
Using a microcomputer in the wind tunnel instead of conventional SCR drive controlling equipment has been studed in this paper.
该设备采用可控硅励磁直流发电机——直流电动机系统，具有取决于负载的弱磁调节装置。因此操作起来极为方便。
This equipment adopts a thyristor excitation DC generator-motor set with a field weakening regulation device working in step with loading.
文中重点介绍可控硅整流装置中限流保护方案的工作原理。
This paper focuses on the working principle of limiting current and over current protection method in a silicon controlled rectifier.
本文对起重装置适用的绕线电动机转子可控硅调速各种方案进行了综述。
This paper features a comprehensive survey of all the plans, which are applicable to crane hoists, of the speed control of wound motor rotor thyristor.
利用 与控制装置（例如可控硅元件）连接的传感器来控制温度。
The temperature is controlled by a sensor connected to a control devise such as a thyristor.
该装置用真有效值电路检测非正弦焊接电流值，用中断和定时计数器实现了可控硅的精确触发。
The measuring circuit for RMS of non-Sin welding current and the precise triggers of SCR using interrupt controllers and timers in AduC812 MCU are also described.
对于控制装置故障，主要表现为电源缺相，而导致电源缺相的子事件主要有：可控硅失效、可控硅触发电路失效、三相电源开关失效、电感线圈失效；
One is power failure, mainly on AC phase-loss consisting of SCR failure, the failure of SCR's trigger circuit , there phases AC switches'failure and the failure of CRDM coil;
对于控制装置故障，主要表现为电源缺相，而导致电源缺相的子事件主要有：可控硅失效、可控硅触发电路失效、三相电源开关失效、电感线圈失效；
One is power failure, mainly on AC phase-loss consisting of SCR failure, the failure of SCR's trigger circuit , there phases AC switches'failure and the failure of CRDM coil;
应用推荐