这个波形可以被看作是下列原理的叠加(图22和平台5)。全部这些波形的叠加整合结果变成图21所示的典型漏极电流。
This waveform can be presented as a superposition of the following elements (Fig. 22 and Tab. 5). The superposition of all these elements results in a typical drain current shown in Fig. 21.
主要用途是将叠加在直流电流上的交流分量限定在某一规定值。
The main purpose is to direct current superimposed on the exchange of a specified weight limit value.
采用基于叠加原理的短路电流计算方法，克服了传统的对称分量法应用于配电网短路电流计算时所遇到的困难。
Furthermore, the superposition theorem is then adopted in the approach, which overcomes the difficulties when applying the symmetrical components to the short circuit calculation.
对粉末供应一个较低的电压，然后通过放置在喷枪中的叠加增效器逐步增加电流到一个高的电压。
A powder gun that has a low voltage single supply to it, and steps up the current to high voltage via a cascade multiplier located in the gun barrel.
运用磁场的叠加原理及第二类完全椭圆积分，给出了椭圆形稳定电流环垂直轴上的磁感应强度。
According to the superposition principle and the second kind of complete ellipse integral, the magnetic field current circle was calculated.
摘要电流密度矢量场也满足叠加原理，给出了一些应用电流密度场叠加原理的例子。
The electric current density vector field also satisfies superposition principle some applications thereof are introduced.
该芯片的判决电路采用SCFL(源级耦合晶体管逻辑)的D触发器结构，根据矢量叠加原理设计，采用差动电流放大器构成可调移相器。
The decision circuit of the chip is applied with a DFF using SCFL structure and its tuned phase shifter with differential current amplifiers according to the principle of vector addition.
着重评述了交直流叠加，脉冲电流和交流电源在硬质阳极氧化研究中的进展情况。
The progress of hard anodizing investigation employing A. C. superimposed on D. C. , pulse current and alternating cu…
基于故障电流叠加原理，构造了电压跌落状态估计可观性分析的数学模型，合理地解决了部分故障路段不可观的问题。
Sag state estimation observability analysis is modeled and correlative modification method is proposed from the point of fault current superimposing firstly.
在传统正负温度系数电流叠加的基础上，通过增加一条电流支路，对温度特性进行优化，使用简单的结构得到了很好的温度特性和电源电压调整率。
Compared with the typical current superposition with positive/negative temperature coefficient, the third current branch was added to optimize the temperature features by curvature compensation.
同时，为了使转速估计和转子电阻的辨识解耦，在励磁电流处叠加了小幅交流分量。
Meanwhile, a slight AC component was added to excitation current to decoupling speed estimation and rotor resistance.
脉冲化学镀是指在化学镀上叠加脉冲电流。
The superposition of pulsed current on the electroless reaction is referred to the pulsed electroless plating.
首先介绍了由“直流分量法”、“交流叠加法”和“损耗电流测量法”三者结合起来的综合判断方法，然后重点论述了交流叠加法的具体实现方案。
In this paper, a comprehensive method combined by DC component method, AC superposition method and loss current measurement method are described at first.
此方案中的电源系统由数字控制电路、电流叠加开关和恒流源组成。
In this plan, the power source system was make up of by the digital control circuit part and current adding switch part and constant current source part.
将任意分布的电流源产生的电磁场看作是电偶极子产生的电磁场的叠加，利用镜像法推导了上半空间中的垂直直流电偶极子在两层媒质中产生电磁场的解析解。
The analytical expressions of the electromagnetic field generated by the DC electric dipole in the upper space for the two-layer mode were obtained by using the method of mirror image.
将如何得到高重频、稳定的电流脉冲作为一个研究重点，提出电流叠加开关的概念。
How to get high frequency and high stability current pulse is the emphasis of this section. The paper put forward the concept of current adding switch.
因此，考虑平衡节点的电流叠加法较考虑平衡节点的灵敏度算法更优越。
Therefore, a slack bus consideration of the current superposition arithmetic is superior to a slack bus consideration of the algorithm based on the sensitivity theory.
在脉冲射线束测量中，射线以束流形式作用在探测器上，输出电流是许多射线粒子同时作用的叠加效果。
When the waveform of a radiation pulse is measured, a large number of radiation particles interact with the detector simultaneously.
在脉冲射线束测量中，射线以束流形式作用在探测器上，输出电流是许多射线粒子同时作用的叠加效果。
When the waveform of a radiation pulse is measured, a large number of radiation particles interact with the detector simultaneously.
应用推荐