本文对以18号热轧工字钢为轴心受压杆件的承载能力进行了试验和理论研究。
This paper presents the experimental investigation and theoretical analysis for the ultimate load-carrying capacity of axially loaded compression member of No. 18 rolled I-section.
基于能量法原理建立了受压节点承载能力的理论表达式，得到了其极限载荷的上限理论解。
The bearing capacity formulas of the joints under compression were also found out by the energy method and experimental method.
打入桩，桩径较小，水平承载能力很低，人们一般只用它承担垂直荷载，这样可近似按轴向受压构件计算。
Having shorter diameter and lower lateral bearing capacity, driven piles are usually used to carry vertical load and can be calculated as axial compressed member.
本文通过3组9个抗压试件，了解开槽砌块灌孔砌体的受压开裂荷载、极限承载力、破坏形态和变形能力。
In this paper, 9 compressive specimens of 3 groups were tested to investigate the cracking resistant load, ultimate load, failure modes and deformation capacity of the grouted slotted block masonry.
本文通过3组9个抗压试件，了解开槽砌块灌孔砌体的受压开裂荷载、极限承载力、破坏形态和变形能力。
In this paper, 9 compressive specimens of 3 groups were tested to investigate the cracking resistant load, ultimate load, failure modes and deformation capacity of the grouted slotted block masonry.
应用推荐