在库仑计中反馈电路为电容器。
共模反馈电路由开关电容共模反馈电路实现。
Auxiliary feedback amplifiers and switched capacitor common mode feedback circuit are employed.
图2 -37示出连至源阻抗的一般反馈电路。
Figure 2-37 shows a generalized feedback circuit connected to a source impedance.
一个确定的反馈电路在引发递推的系统上有深远的反应。
A positive feedback loop has far-reaching repercussions on the system that triggered the recursion.
介绍了基于FPGA器件的角度位置反馈电路的具体实现方法。
The realization of an angular position feedback circuit based on FPGA is presented in this paper.
对传感器信号处理采用的二次谐波反馈电路，电路为闭环系统。
Adopting the reactive circuit of twice harmonic to process the sensor signal, the system is closed loop.
介绍一种新型电压负反馈电路，并研制了成本低、体积小的装置。
This paper introduces a newtyped voltage negative feedback circuit, and develops a low-cost and a small sized system.
利用“虚短”和“虚断”的概念来估算深度负反馈电路的电压增益。
Using the concept of virtual short circuit and virtual open circuit, the voltage gain of depth negative feedback circuit can be estimated.
本文所涉及的是可控硅的整流电路、控制电路及反馈电路的设计方法。
This article concerns about the design for commutating circuit, controlling circuit, and feedback circuit of controllable silicon.
该模块集气路、控制电路、监测电路、反馈电路于一体的模块化设置。
The module assembly gas path. Control circuit. Monitoring Circuit. Feedback circuit in one of the modular setting.
其电机加上电子反馈电路增加强度可以在所有的速度水平相一致的性能。
The increased strength of its motor plus electronic feedback circuitry enables consistent performance at all speed levels.
主放大器采用开关电容共模反馈电路在获得大输出摆幅的同时降低了功耗。
Used the switched capacitor Common Mode Feedback circuit(CMFB) in main amplifier to achieve a large output voltage swing and decrease the static power consumption at the same time.
在差分输入端，采用正反馈电路结构，以提高开启和关断速度，并降低功耗。
In the differential input, positive feedback circuit was used to increase the switching speed and attain low power.
本发明公开了一种电源系统，包括开关电路、谐振回路、反馈电路和控制电路。
The present invention discloses a power system, including a switching circuit, a resonant tank, a feedback circuit, and controller circuitry.
通过分析电流串联负反馈对电路的噪声影响，给出该反馈电路的低噪声化条件。
By analyzing the series electric circuit negative feedback conditions to reduce its noise effect are proposed.
这一关系式在微波电路分析与设计，特别是微波反馈电路分析与设计中甚为有用。
These formulas are useful in analyses and designs of microwave circuits, especially of microwave feedback circuits.
那些以Stella为基础的模型，比如说“增长的极限”模型，显而易见过量拥有反馈电路。
Stella-based models such as Limits to Growth possess a remarkable surfeit of feedback circuits.
借助输出电压采样和霍尔元件，设计了电流、电压反馈电路，形成了闭环控制系统。
A closed loop control system is formed by current and Voltage feedback system by means of HALL sensor and potentiometer.
每个传感器单元包含了积极的反馈电路敏感电容的存在，生活接近皮肤表面的传感器。
Each sensor cell contains an active capacitive feedback circuit sensitive to the presence of live skin close to the surface of the sensor.
从而，一次双改正发生：前馈作为依次，装入修正的生产的一个改变的反馈电路返回。
Consequently, a dual correction occurs: the feed forward returns as an altered feedback loop which, in turn, feeds into a revised output.
正如诺伯特·维纳在1952年所指出的，具备各类组合变化的反馈电路，是控制和自我管理的根源。
As Norbert Wiener showed in 1952, feedback circuits, in all their combinatorial variety, are the fountainhead of control and self-governance.
对三相逆变电源的逆变电路、驱动电路、工作电源、保护电路和稳压反馈电路进行了设计研究；
Then the article designs and researches inverter circuit, driver circuit, working power supply, voltage regulator feedback circuit protection circuit of three-phase inverter power.
这种方法利用最新型的编码反馈电路技术（并非正反馈技术），进行各种阶梯波发生器的设计。
The method which is presented can be also used for design of square wave generator.
设计了基于TL 431和电阻网络的精密反馈电路，以满足电源输出电压幅值高，精度高的要求。
And a precise feedback circuit based on TL431 and resistors network is devised to meet the requirements of high voltage and high precision of the power supply.
信号衰减器用于衰减积分信号以输出一衰减信号，而本地反馈电路用于将衰减信号反馈至积分模块中。
The fader is used for fading the integrated signal and outputting a fading signal, and the local feedback circuit is used for feeding the fading signal to the integrator module.
具体介绍了老化台的单元反馈电路，用PIC单片机实现对电源自动控制、960位器件老化的实现方法；
The power is controlled by PIC microcontroller. The aging method for the 960 pcs components is presented and realized.
研究中讨论了脉宽调制电路、驱动电路、恒值采样反馈电路、保护电路、参数预置与显示电路的组成及工作原理。
The pulse width modulate circuit, drive circuit, sample circuit, protecting circuit and parameters preset and display circuit are respectively analyzed.
将静电计置于电压模式，然后打开外部反馈，就把反馈电路从内部网络切换到连在前置放大器输出端的外部反馈网络上。
Placing the electrometer in the volts mode and then enabling external feedback switches the feedback circuit from an internal network to a feedback circuit connected to the preamp output.
将静电计置于电压模式，然后打开外部反馈，就把反馈电路从内部网络切换到连在前置放大器输出端的外部反馈网络上。
Placing the electrometer in the volts mode and then enabling external feedback switches the feedback circuit from an internal network to a feedback circuit connected to the preamp output.
应用推荐