同时，利用反变换法(代数法)进行运动学反解。
Meanwhile, utilizing algebra law, inverse kinematics equation is solved.
并用d - H方法建立了机械手的运动学模型，用反变换法对其进行了运动学反解。
The kinematics model is established by using the D-H method, and solved by using the counter transformation method.
因此，计算地震仪的时间特性应该从地震仪的传递函数出发，通过拉普拉斯反变换求得。
Therefore, in the computation of the time response of a seismograph it is better to use the transfer function, from which the time response may be obtained by the inverse Laplace transformation.
本文提出了一种利用离散付立叶反变换(IDFT)技术完成天线的时域近场测量的方法。
This paper describes a new method which USES IDFT (Inverse Discrete Fourier Transform) technique to do time domain near field measurement for antenna.
本文讨论了现有的置乱加密方式，并结合该方式的周期性，提出了一种置乱反变换恢复的方式。
This text discuss that place confusion to encrypt a method existingly, and combine the periodic of that method, put forward a kind of method that places confusion and anti- transformation to recover.
然后对解码器进行复杂度分析，找出解码耗时的关键部分分别为运动补偿、反变换、环路滤波等模块。
Then analyses the complexity of AVS decoder and finds out the the critical modules are motion compensation, integer transform, quantization and loop filter.
当激励信号是常见信号时，本文提出的方法与求有理分式的拉氏反变换的部分分式展开法在形式上完全相同。
Under the ordinary exciting signal, this method of calculation is just in the same form as that for inverse Laplace transformation of rational fraction by partial fraction expansion.
将这种滤波器放置在傅里叶反变换产生相关输出之前的联合功率谱面上，该技术可以应用在具有不同灰度图像的模式识别中。
The filter is put on the power spectrum before applying the inverse Fourier transform to yield the correlation output. This technique can be used in pattern recognition of grey level input image.
最后，对小波重构得到的新亮度成分和原始多谱图像的色度和饱和度成分进行IHS反变换，从而得到最终的融合结果图像。
Finally, perform inverse IHS transform to the wavelet reconstructed new intensity component and the hue and saturation components from the original MS image to get the fused image.
第四章是本文的主要部分，开始分模块说明对字节处理部分的研究：数据格式反变换、解扰、RS译码、去交织和同步头搜索。
The fourth chapter is this paper's emphasis , focuses on the byte processing part(outer code) module by module: data reverse transformer, de-randomizer, RS decoder, de-interleaver and synchronization.
硬开关和准谐振反激变换器之间的差异在于一次侧开关的开启时间点。
The difference between a hard switching and quasi resonant flyback converter is the turn on time point of the primary switch.
文章研究了一种新型单级单开关PF C反激变换器。
This study presents a new single - stage single - switch PFC flyback DC converter.
提出了“利用反双曲正弦函数变换提高数据列光滑程度”的新结论，获得了递增时间序列改善的自回归预测新方法。
A new conclusion is put forward, in which the smooth degree of the data row can be enhanced by means of the arc-hyperbolic sine function transformation.
定义了集合上的反部分映射，并由此给出了集合上的变换半群的对偶半群的一个新刻划。
This paper defined anti-part mapping on set and has given a new deseription of dual semigroup of transformation semigroup on set.
最后比较了逆模型控制和反s变换控制，逆模型控制有更好的效果，可以很好控制酸性到弱酸和碱性到弱碱的情况。
At last, compared with anti-S transform control, the inverse control has a better effect on the process changing from strong acid to weak acid or from strong base to weak base.
电感电流断续工作的反激式变换器一次侧开关可工作于硬开关或准谐振(或谷值开关或零电压开关)模式。
The flyback converter running in discontinuous conduction mode can be operated in hard switching or quasi resonant (or valley switching, or ZVS) mode regarding the primary side switch.
和600伏特设计比较，800伏特准谐振反激变换器的电压频谱在1兆赫兹以下更高一点，在1兆赫兹以上开始变小。
As it can be seen the voltage spectrum of the 800v quasi resonant flyback is higher at frequencies below 1 MHz, and is getting lower above 1 MHz compared to both 600v designs.
本文将新的赋初值方法与旧的赋初值方法作了详细的比较，仿真实验结果表明，利用反算得到的仿射变换系数进行赋初值，可以提高效率和测量精度。
Comparison of the new methods with the old ones by simulated images revealed that higher efficient and accuracy could be achieved by introducing affine transform into initial parameter vector.
在此基础上运用数值反拉普拉斯变换(nilt)法分析互连电路的时域响应。
Then the numerical inversion of Laplace transform (NILT) is employed for the time domain response of the interconnect circuits.
比较现有的三种反激变换器。
Comparison of three different flyback solutions has been made.
介绍了采用基于ROM查找表的全数字反离散余弦变换(IDCT)电路的算法原理及其并行架构的大规模集成电路实现。
This paper presented an ROM look-up table (LUT) based inverse discrete cosine transform (IDCT) algorithm and its LSI implementation having parallel architecture.
利用积分变换技术，得到不同压电介质界面上的反平面运动裂纹问题的分析解。
The problem of an anti plane Griffith crack moving along the interface of dissimilar piezoelectric materials is solved by using the integral transform technique.
根据HVS函数的特点，对频域中HVS函数进行反傅立叶变换，将空间域中该函数的部分函数值作为特定的模板参数，并与原图像进行卷积来实现边缘检测。
The HVS function, HVS function is inversely Fourier transformed in frequency domain, and the method is realized by calculating some value of the function in spacial domain as convolve nucleus.
建立了角台机构的反解方程，通过确定结构约束和齐次变换矩阵，解得角台机构的三个移动副输入参数。
Then it builds the equations for inverse problem and obtains the three input parameters according to the structure constraints and homogeneous transforming matrixes.
对反激变换器的各种开关应力抑制技术进行了分析研究，指出了它们各自的优缺点和应用场合。
This paper analyzes and studies on the switch stress suppression techniques of flyback converters, points out the advantages, disadvantages and application of the techniques.
运用解析几何中的坐标变换和投影，得出一种有效求解位置反解的新方法，通过MATLAB软件对该方法进行了仿真和验证。
It put forward an effective new method to resolve the inverse position by using the conversion of coordinates and projection in analytic geometry, the method was simulated and verified by MATLAB.
反激式变换器有两种工作模式，一种是不连续导通工作模式（DCM），另一种是连续导通工作模式（CCM）。
There are two modes in flyback converter, one is the discontinuous Conduction conduction mode(DCM), and the other is the continuous conduction mode(CCM).
说明：MF C实现灰度图像的各种点运算，如图像反色，窗口变换，线性变换，阈值变换，灰度均衡等。
MFC to achieve a variety of gray-scale image point operations, such as anti-color images, the window transform, linear transformation, threshold transform, gray balance, etc.
提出一种具有零电流关断(ZCS)的反激式单级功率因数校正(PFC)变换器。
A flyback converter with zero current switching (ZCS) resonant and power factor correct (PFC) is proposed.
提出一种具有零电流关断(ZCS)的反激式单级功率因数校正(PFC)变换器。
A flyback converter with zero current switching (ZCS) resonant and power factor correct (PFC) is proposed.
应用推荐