双极设计是为了减少髋臼磨损，减轻疼痛，并使活动最大化。
The bipolar design was created to reduce acetabular wear as wellas to minimize pain and maximize mobility.
设计了一种称之为多晶硅覆盖树技状结构的双极型微波功率晶体管。
A new device structure of silicon bipolar microwave power transistors with so called tree overlay geometry polysilicon emitter has been designed.
在引入了跨导线性原理后，利用混合跨导线性回路完成了对电压跟随器的设计，进而得到了双极管型电流控制传送器。
After introduction of the tranlinear loop principal, the BJT current controlled conveyor has been designed by using mixed tranlinear loop voltage follower.
这种新型的无刷双馈电机转子采用变极原理设计。
This new type of brushless double-feed machines rotor is designed by pole-changing method.
本文叙述了一种变形双棱镜的加固设计方法，它能够完全消除温度变化与激光波长漂移对光束输出方向的影响，适于对二极管激光束进行变形。
A ruggedized design method for shaping diode laser beams, which can totally eliminate the effects caused by the temperature change or laser wavelength shift on output beam direction, is described.
本文论述双极型功率开关电路和CMOS音频功率放大器电路设计。
The paper focuses on circuit design of power switch with bipolar technology and audio amplifier with CMOS techn.
分析了LDO中过温保护电路的设计，主要介绍了LDO中双极型过温保护电路和CMOS过温保护电路。
This paper analyses the design of thermal protect for LDO, then gives a bipolar thermal protect circuit for LDO and a CMOS thermal protect circuit for LDO.
介绍了一种用大功率绝缘栅极双极型晶体管(IGBT)模块SKM75GA L 123d和驱动模块EXB840设计的直流升压斩波器。
A design of boost converter using high-power insulated bipolar transistor IGBT module named SKM75GAL123D and driver module named EXB840 is introduced.
该文提出设计单相交流电机变极绕组的基于双极对槽号相位图的设计方法。
Based on the two pole-pair slot-number phase graph, the method for designing pole-changing windings of single phase a. c. machines is proposed.
框架设计成至少部分地包围在双极型电池组中安装的双片，并包含允许气体传输通过密封垫的装置。
The frame is designed to at least partially encompass a biplate when mounted in a bipolar battery, and include means to permit gas passage through the gasket.
本文叙述采用双栅砷化镓场效应晶体管和高优值硅外延变容二极管实现UHF电子调谐器低噪声化的有关设计和实验结果。
This paper reports the design and experiments of the low noise UHF electronic tuner consisting of a low noise dual-gate FET and a high merit silicon epitaxial varactor.
结合双极工艺和开关稳压电源的优点，本文设计了一款高效率开关稳压电源XD 6912。
Combined with the advantages of bipolar process and SMPS, a high efficient SMPS XD6912 is designed.
基于H型双极模式P WM控制原理，设计了一种直流微电机正反转调速功率放大电路。
A power amplification of H-bridge bipolar PWM control is designed for controlling DC micro-motor of positive rotation, reverse rotation and speed regulation.
大多数传统的音频功率放大器是用双极型工艺设计和制造，其基础在于良好的双极型三极管特性。
Majority of conventional power amplifiers are designed using bipolar technology on the basis of well-known merits of bipolar transistors.
本文将4／6极和8／12极两种不同结构双凸极永磁电机进行详细比较，从而为该电机的优化设计进一步深入研究提供理论依据。
This paper will compare 8/12 DSPM with 4/6 DSPM in detail, and provide theoretic basis for design and research deeply of DSPM.
本文主要完成了一种基于双极工艺实现的电流型PWM控制器芯片的设计。
This paper research the design to current mode PWM controller IC, it is achieved by bipolar process.
此设计利用晶闸管、二极管等器件设计了一个转速、电流双闭环直流晶闸管调速系统。
The design uses thyristors, diodes and other devices designs a speed, current double-loop SCR DC converter system.
这已被设计与Intersil的高频双极电介质隔离工艺构造和特点，从一个以前从未真正差速器可用的动态参数。
It has been designed and constructed with the Intersil High Frequency Bipolar Dielectric Isolation process and features dynamic parameters never before available from a truly differential device.
绝缘栅双极型晶体管(IGBT)是应用广泛的功率半导体器件，驱动器的合理设计对于IGBT的有效使用极为重要。
Isolated gate bipolar transistors (IGBTs) are widely used power semiconductor devices. Properly designed drivers are extremely important for the effective use of IGBTs.
本文对霍尔传感器作了一些研究，对一款开关型双极霍尔传感器作了设计与分析。
Some research on hall sensor has been made in the thesis, a switch-type bipolar hall sensor has been designed and analyzed.
该模型可供优化设计双极型高频、高压、低饱和压降功率器件参考。
This model will provide assistance to the optimal design of bipolar power transistor with high frequency and high…
该模型可供优化设计双极型高频、高压、低饱和压降功率器件参考。
This model will provide assistance to the optimal design of bipolar power transistor with high frequency and high…
应用推荐