推导了时间域分析定量计算的公式，并给出了一些关键参数的选择方法。
Formula of quantitative calculation of time domain analysis are derived, and selection method for some key parameters is introduced.
储集岩石的真实突破压力是油气勘探开发中一项定量计算的关键参数。
The real entrance pressure of reservoir rocks is a key quantitative parameter calculated during the exploration and exploitation of oil and gas.
实践表明，经过参数修正后，公式定量计算的结果令人满意。
The practice shows that the results of the quantitative calculation are satisfactory after the formula parameters are corrected.
本文在煤储层性能参数单因素评价基础上，提出了进行储层特征综合评价的重要性和定量计算方法。
On the basis of single factor evaluation, the importance and quantity calculation method for the integrated evaluation on coal reservoir property is presented in this paper.
泥石流泥痕深度是一个通过勘测调查获取的重要参数，它直接关系到泥石流运动流速、冲击力等特征参数的定量计算。
As an important parameter usually decided by field survey, mud depth of debris flow is directly related to quantitative calculation of velocity and impact forces.
本文用一种新的理论方法，对各种形式的电动机断相运行时的参数进行原理分析和定量计算，并由此给出不同接法的电动机所应采用的保护方案。
This pape. applying a new methods analyses and computes the parameters to phase failure of varies motors and gives protective schemes for motors with different connections.
各参数对能级压力移位率的影响也被定量计算，得出了R 1线压力移位的物理根源。
The contributions to the rates of pressure induced shift from various parameters are calculated. The physical origins of R1 line have been clearly and quantitatively shown.
迄今为止，地球轨道参数的变化是地质尺度上惟一可以精确定量计算的周期现象，可以用作地质计时的标尺。
Up to now, the Earth's orbital parameters remain the only periodicities in geology subject to precise calculations and, therefore, may provide new scales for geochronology.
并给出了所提出的组合方式下相关参数的定量计算公式。
Then the formulae to quantitatively calculate the parameters involved in the criteria are derived.
通过岩心刻度测井的方法，开展了岩性识别、定量计算裂缝参数等基础研究。
With the help of core scale logging method, the basic study is conducted to identify the lithologic character and quantitatively calculate the parameters of fractures.
文中对检测参数的选取以及参数间的关系进行了分析和讨论，提出了对缺陷信号识别、缺陷定位和半定量计算的方法。
The selection of the testing parameters and the relations among them are analyzed and discussed. The methods of recognition, location and evaluation of the defect signal are proposed.
目前，运用火灾模拟程序进行定量计算，分析失火隧道内的温度、烟气生成量等参数时，都是以火灾热释放率(HRR)为基础的。
At present, in order to analyse the temperature and smoke in the tunnel fire, we use numerical simulation to calculate the variable, which are all based on the fire heat release rate (HRR).
该方法以威胁发生可能性和威胁产生后果损失为参数计算安全风险值，采用模糊评判法对参数进行定量计算。
The method used the possibility of thread occurrence and consequence that cause thread as parameters to compute security risk.
该方法以威胁发生可能性和威胁产生后果损失为参数计算安全风险值，采用模糊评判法对参数进行定量计算。
The method used the possibility of thread occurrence and consequence that cause thread as parameters to compute security risk.
应用推荐