随着铸轧速度降低、铸轧区增大与铸轧坯厚度减薄，轧制压力峰值增大；
The results showed that roll casting speed increase with the decrease of the thickness of the strip, and the …
结果表明，半顶角对制件厚度变化起主导作用，其值越小，厚度减薄越严重；
The results show that half-apex angle has a great effect on sheet thickness distribution, the smaller the half-apex angle is, the bigger the sheet thickness thins;
对内螺纹铜管尺寸优化、铝箔厚度减薄前后的空调热交换器进行了单体性能实验和整机性能实验对比。
The performance experiments on separate heat exchanges and integrated air conditioners before and after optimizing the inner grooved copper tube and reducing the thickness of aluminum foil are made.
认为，板料零件数控渐进成形是使板料的厚度减薄，表面积增大，靠逐次的变形累积产生整体的变形。
Sheet thickness is thinned, surface area is increased in the nc incremental sheet metal parts forming process, and sheet forming point by point is to lead to the whole sheet deformation.
第一层滤料的厚度最大，逐层厚度减薄，每一层都允许透过重量的3%，每一层都没有堵死，都有空隙。
The first layer filter material thickness, the thickness of the biggest step by step a thinning, each layer will allow through 3% of the weight of each layer, no change, there is gap.
峰值间的距离随厚度的减薄而增大。
The distance between peaks increases as the thickness is reduced.
同向切应力具有减薄液膜厚度和增大传热系数的作用；
The cocurrent shear plays the roles on thinning film thickness and enhancing heat transfer, and the countercurrent shear has inverse effect.
采用减薄硅片衬底厚度和光陷阱技术可望使转换效率达到29%。
It is possible to get 29% efficiency by reducing wafer thickness and employing light trapping technology.
钎焊过渡层和减薄陶瓷块厚度可降低钎焊复合挺柱中陶瓷块的残余应力。
Residue stress in the ceramic chip of the composite tappet rod may be reduced by intermediate layer of soldered connection and by decreasing thickness of ceramic chip.
减薄镀锡板的镀锡层和合金层的厚度成为目前镀锡板生产的趋势。
It is an inevitable tendency to reduce the thickness of tin coating and alloy layer of tinplate.
退积反射是地层厚度向凹陷中心减薄且其顶部被“削截”的一种反射现象，与一般发生在凹陷边缘地层顶界被削截减薄的情形不同。
Retrogradation reflection is a reflected phenomenon that reflects the thinning strata and truncated its top in toward basin center, which is different from that takes place generally in basin margin.
发现表面高密度缺陷减薄了势垒层厚度，显著增强了热电子隧穿过程。
It is found that the barrier width is thinned by the surface defects with high density to enhance the hot electron tunneling.
盆地内的构造相对简单，断裂以地堑式和阶梯式组合为主，地层仅轻微褶皱且地层厚度及埋深向东及向北减薄、变浅。
Faults styles are mainly graben and step fault. Strata are little folded. Strata thickness and buried depth both decrease eastward and northward.
减薄硅膜厚度和增加铝膜的厚度也能增大泵腔体积变化量。
The stroke volume of the chamber is enlarged when the thickness of aluminum membrane is increased or that of silicon membrane is decreased.
最后，在实验上通过对衬底的研磨和抛光，将其减薄到一定的厚度范围内，从而使得该滤波器的传输性能得到极大改善。
Finally, a remarkably improved transmission performance of the EG-FPF is obtained by thinning the substrate down to a suitable thickness range through well-controlled grinding and polishing.
通过数值模拟得到管壁的最大减薄和增厚部位，并讨论了芯轴的摩擦系数和钢管末端的压力对管壁厚度变化的影响。
The influences of friction coefficient between tube and mandrels and the press force on the end of tube for thickness chang...
板料厚度大，不易起皱，但壁厚减薄率大，因而成形精度不高。
The thick blank is difficulty wrinkled, but the blank thinning is larger and result in a low forming precision.
因此，整体厚度显著减薄，适用于安装空间狭小的场合。
Thus the entire thickness is obviously reduced and the utility model is suitable for the occasion with small installing spaces.
为研究不同氧化层厚度对焊料性能的影响，开发出一种新的焊料表面氧化层减薄工艺。
A unique oxide thinning process is proposed in order to investigate the effect of oxide thickness on soldering properties.
通过对浮环减薄前后实验结果的对比分析，研究了浮环厚度变化对浮环轴承涡动及稳定性的影响，并给出了三维谱图、涡动比与转速图、典型分岔图。
Based on two experiments on floating ring bearing before and after floating ring thickness reduction, the effect of thickness variation of floating ring on whirl and stability was studied.
通过对浮环减薄前后实验结果的对比分析，研究了浮环厚度变化对浮环轴承涡动及稳定性的影响，并给出了三维谱图、涡动比与转速图、典型分岔图。
Based on two experiments on floating ring bearing before and after floating ring thickness reduction, the effect of thickness variation of floating ring on whirl and stability was studied.
应用推荐