组合影响系数表示发动机抗组合畸变的能力以及压力畸变和温度畸变之间的相互影响。
Combined effective coefficient shows engine's capability to resist the combined distortion and the interaction between pressure and temperature distortions.
对燃料喷入时的燃烧室温度、压力及推进剂余氧系数等工作参数进行了试验研究。
The effect of the combustor temperature, pressure and coefficient of residual oxygen was experimentally investigated when the fuel was injected into the combustor.
发现，与原硅铁还原剂相比，此高效还原剂具有还原温度低、还原速度快、过量系数小、制团压力低等优点。
We find out that the reducing agent has the advantages such as lower reduction temperature, quicker reduction, smaller excessive factor and lower pressure briquette.
结果显示在不同的循环方式中，平行流系统产生最大的热力系数而逆串联系统的最高发生温度和压力比其他系统都低。
The results show that the parallel-flow cycle yields the highest coefficient of performance among the cycles while the maximum pressure and temperature in the reverse-flow cycle are lowest.
论述了钛设备在国内的应用，介绍了现行的钛容器制造技术标准及各种钛材的最高设计压力、设计温度和安全系数。
The application of titanium vessel in domestic, the active manufacture standard and the titanium's design pressure, design temperature and safety factor were discussed.
摩擦阻力系数随着流速增大而增大，随着温度的升高而减小，而其随着压力的变化特别复杂。
The frictional resistance factor increases with the increase of the flow velocity, decreases with the increase of temperature and its variation law with the pressure is complicated.
根据分析结果，对铜柱静压实验数据进行分析，提出了基于压力的温度修正系数。
According to the analysis of experimental data, this paper gives temperature correction coefficients based on pressure.
着重分析影响精密分度装置寿命的接触表面压力，基本动载荷，温度系数等因素。
This article mainly analyses the factors that affect the precise indexer life, touching surface pressure, basic motion load and temperature factor for example.
结果本法在萃取川芎挥发油得到的传质系数随着温度的升高略为增大，随着流量的增大而增大，随着压力的增大而减少。
RESULTS: Coefficient of mass transfer was slowly increased as the extraction temperature elevated, and was in accord with flow and in contrast with pressure.
对多喷嘴引射混合式加热器的加热性能进行了试验研究，分析了工作流体压力和引射孔结构对引射混合式加热器的出口温度、引射系数以及加热效率的影响。
The influence of the working fluid pressure and the structure of ejecting nozzle on the outlet temperature, ejecting coefficient and heating efficiency of the ejecting-mixing heater were analyzed.
研究了某些无机铅盐和氧化铝对燃速压力指数及温度敏感系数的影响。
Effect of some inorganic lead salt and aluminium oxide on burning rate pressure exponent and temperature sensitive coefficient of polyurethane composite solid propellant have been investigated.
校正系数表始于第767页。查看压力和温度范围。
Correction factor tables begin on page 767. Review pressure temperature limits.
降低冷却水进口温度和提高其质量流量不仅有利于提高制冷性能系数，而且能降低最佳高压侧压力。
Reducing the inlet temperature of cooling water and increasing its mass flow are favorable to increase refrigerant performance coefficient, and can decrease optimal pressure at high pressure side.
研究了两个不同温度的圆柱体在相互热压时，其间的接触热传导系数与热工件的初始温度及压力之间的关系。
The purpose of this article is to study the relation of the interface heat transfer coefficient with initial temperature of specimen and pressure as two non-isothermal cylinders contact each other.
给出了理想二元混合液自由程压力系数与温度系数的表达式。
The expression of the pressure coefficient and temperature coefficient of the free length in liquid binary mixtures is obtained.
讨论了聚氨酯软泡沫塑料的隔热机理和导热系数计算模型，对影响隔热性能的因素，如温度、密度、挤压、吸水率、环境压力等进行了分析。
The mechanism of transmit heat and the calculation model of the thermal conductivity of the soft polyurethane foam have been discussed and the affect factors of the thermal conductivity.
研究表明，该催化剂有效导热系数较大，温度、压力影响明显，组成影响较小。
It is shown that the thermal conductivity of the catalyst is high, which is much influenced by temperature and pressure, and less influenced by composition of gas.
在经典岩石力学和弹性力学基础上，考虑压裂液渗滤、井壁岩石温度降低及围岩系数等影响，建立了水平井破裂压力计算模型。
Considering fracturing fluid filtration, wall temperature drops and coefficient-wall rock, established the fracturing pressure model based on classic rock mechanics and elastic.
在经典岩石力学和弹性力学基础上，考虑压裂液渗滤、井壁岩石温度降低及围岩系数等影响，建立了水平井破裂压力计算模型。
Considering fracturing fluid filtration, wall temperature drops and coefficient-wall rock, established the fracturing pressure model based on classic rock mechanics and elastic.
应用推荐