在此基础上，完成变送器的在温度补偿区间内的压力标定采样和数据存储。
On this basis, we can carry out calibrating sampling and data storage in the temperature compensation range of the transmitter.
实验系统的标定主要包括三个方面的内容：位移标定、温度标定和压力标定。
The experimental system calibration includes three aspects: displacement calibration, temperature calibration and pressure calibration.
准动态压力标定系统是用于膛压测量器材进行准动态标定的动态压力发生器。
The Quasi dynamic pressure calibration system is a dynamic pressure generator, used in calibrating measuring device for the pressure in bore.
第二章主要介绍400吨四柱双缸液压机的历史、维修、调试、压力标定和样品测量等内容。
The second chapter introduces the history of 400-t high-pressure machine, repair, debugging, pressure calibration and application.
该系统通过对气缸内的动态压力信号、压力标定信号及活塞止点信号进行数据采样，并对实测采样数据分析处理，得到示功图；
Based on the analysis of the data obtained from the data sampling to the dynamic pressure, rating pressure and pressure of the stopping point, the indicated chart could be achieved.
同时对稀薄燃烧、增压中冷发动机做了ECUI/O标定、怠速标定、冷启动标定、对电控系统进行全工况内点火提前角的标定、内空燃比的标定、发动机增压压力标定。
Then basic calibration such as ECU I/O calibration, idle speed calibration, cold start calibration, ignition advance calibration, air fuel ratio calibration, boost pressure calibration are conducted.
介绍了冲击波压力存储测试系统的原理、体系结构，对研制的测试系统进行了标定、应用试验。
The principle, systematic structure of the storage and measurement system of shock-wave pressure and the calibration and application measurement of the system are introduced.
介绍了发动机进气歧管压力传感器的标定系统和传感器静、动态标定方法。
This paper introduces the calibration system and static and dynamic calibration method of an engine intake manifold pressure sensor.
然后，增加采样的压力，直到读显示标定刻度气体值。
Then increase the sample pressure until the reading displays span gas value.
如实时设定的实际采样率和压力传感器零点、对传感器校准与标定的正确性等诸因素均可影响实测数据的精度。
Important factors include the sampling rate, the zero point of pressure sensor, and the correct calibration of sensor, the revised program and algorism may improve the precision of measurement.
标定加压旋转流变仪，用于测试压力对流变性的影响。
Calibrating the rheometer to test the influence of the pressure for rheological property.
该系统以菜单形式实现地质探头的系数标定、土层压力的测量。
This system implemented factor demarcation of geological sensor, data measurement of earth pressure in the menu form.
使用此方法标定零点和量程在一个背景气情况下，在需要改变背景气时改变压力。
With this method, the operator will have to calibrate zero and span on one background Air and need to change the pressure when backgrounds are changed.
亚临界压力的汽包锅炉在启动调试时应进行水位标定试验，以确定就地水位表的基准零位。
Water line demarcation test should be carried out when starting up and adjusting the subcritical drum boiler, to certify the zero benchmark of the local water gauge.
论文详细描述了用压力罐进行浮标压载重量标定的方法，并通过一台浮标的压载实验给出浮标配重计算方法。
Also, a method of ballasting using high pressure tank is described in detail, and calculation of ballasting weight is explained by giving an example.
这一修正方法及修正公式可广泛应用于凡是用瞬态激励法(阶跃函数输入和斜坡函数输入)对压力传感器、力传感器以及其它各种传感器的动态和准静态标定中。
The correction methods and equations can be used for dynamic and quasi-static calibrations of pres - sure, force and other transducers in transient excited methods of step or ramp function inputs.
在用自然电位或微电极测井曲线标定泥岩段的基础上，利用声波测井数据预测地层孔隙压力，并以樊11-1井为例进行计算。
The method of predicting formation pressure using sonic logging data is presented. The self-potential and micro electric logs are used to calibrate the shale interval in F11 Well of Dongying sag.
介绍了国外土压力盒标定的几种新方法，提交了土压力盒的室内砂标结果并进行了分析。
Several new ways to calibrate the earth pressure cell were introduced, and the result of laboratory calibration was presented and analyzed in this paper.
对压力传感器进行了结构设计、标定、密封与防护，标定的应变随压力的变化规律符合生产实际的规律。
Construction design, demarcate, seal and defend is proceeded, and the strain change principle along with the pressure is matched basically with the real practice.
本文研究的主要内容如下：首先，在自行设计的歧管绝对压力(map)传感器标定实验台上，对传感器进行了静、动态标定。
This dissertation mainly about: Firstly, the static and dynamic calibration experiment of MAP sensor was completed on a calibration experiment stage which was designed by us.
负载传感及指示装置(IMCO)作为锻压力指示和锻压机保护的装置，对它进行适时标定，尤为重要。
It is very important to calibrate the load sensing and indicating devices (IMCO) which are used as the forging force indicating and forging machine protecting devices.
具有集成的温度补偿和标定，低成本，高容量，微型压力传感器封装可以用作任一个子模块组件或作为一次性单元。
Featuring integrated-temperature compensation and calibration, the low-cost, high-volume, miniature pressure-sensor package can be used as either a sub-module component or as a disposable unit.
因此，必须经过标定。在用红宝石荧光法测量压力时，存在着杂光干扰的问题。
There exists an interference from miscellaneous light in using the ruby R1 fluorescence technique to measure the pressure.
压差和相对压力，6个标定点分布在（>0.6%满量程）范围内。
Differential and positive pressure; 6 measuring points distributed over meas. range (> 0.6% of fsv)
本文介绍一种标定光学高温计的方法和讨论在杂光干扰区如何估计压力。
In this paper, we introduce a method of temperature calibration for optical pyrometer and discuss how to...
本文介绍一种标定光学高温计的方法和讨论在杂光干扰区如何估计压力。
In this paper, we introduce a method of temperature calibration for optical pyrometer and discuss how to...
应用推荐