冷冻式空气干燥器的设计应当符合特殊的压缩空气流量、压力、温度条件的需要。
Frozen type air drier shall conform to the special design of compressed air flow rate, pressure, temperature conditions needs.
另外缓冲器可以减缓压缩机与空气系统的压力波动，为空气干燥器和其他设备提供更为稳定的压力和空气流量。
Buffer Another buffer can be slowed down and the air compressor system pressure fluctuations, for air drier and other equipment with more stable pressure and air flow.
倘若进入干燥器的压缩空气流量和压力超出设计范围，分离效果将下降，液态水就会通过分离器使干燥器出来的压缩空气压力凝露点升高。
If into the dryer compressed air flow and pressure beyond design range, separation effect will decline, liquid water would be through the separator make dryer out of compressed air pressure rise.
压缩空气离开冷冻式空气干燥器时的压力凝露点与换热器的效率、分离器或凝结过滤器的效率、以及适度的排水操作有关。
Compressed air from frozen type of dryer air pressure points and the efficiency of the heat exchanger cleansing, separator filter efficiency, or condensation and moderate drainage operation of the.
干燥器中压缩空气的水蒸气含量用压力凝露点表示，即在特定压力的空气管线系统内压缩空气不发生凝结的最低温度。
The compressed air drying of water vapor pressure points with any expressed as the air pressure in particular piping system of compressed air does not occur within the lowest temperature setting.
贮液干燥器，膨胀阀，管路设计，压力开关等。
Receiver Drier , Expansion valves, Pipe(Hose) design, Pressure switches, etc.
实验室用压力喷雾干燥器是目前建筑陶瓷行业所急需的。
Pressure spray dryer for experiment is needed badly by ceramic trade of building recently. Che...
实验室用压力喷雾干燥器是目前建筑陶瓷行业所急需的。
Pressure spray dryer for experiment is needed badly by ceramic trade of building recently. Che...
应用推荐