本文对单稳态触发器的设计原理进行了研究。
The design principle of monostable flip flops is investigated in this paper.
在二值单稳态触发器设计的基础上，提出了四值单稳态触发器的设计方案。
Based on the binary mono-stable flip-flops, this paper proposes the design of quaternary mono-stable flip-flops.
提出了采用单稳态触发器对采集的PW M波形进行占空比门限处理的方法。
This paper brings forward a method of threshold processing PWM signals duty cycle by employing monostable multivibrator.
应用CD4098单稳态触发器组成了三相过零触发电路，达到了较为理想的调功效果。
The three-phase zero-detection trigger made up of CD4098 single side stale trigger can produce ideal effect.
使用单稳态触发电路作“延时”或“定时”用，由于受到元件和器件的影响，其精度不会太高。
The accuracy of delay or timing is not sensitive with monostable trigger circuit since electrical elements have influence on it.
以单稳态触发器为核心，针对电液运动平台计算机控制系统的特点，设计了电液运动平台的监控保护系统。
According to characteristic of computer control system of electrohydraulic motion platform, the paper designs a surveillance protection system by the monostable trigger.
以555定时器构成的单稳态触发器这一典型电路为基础自制一种实用测试器，较详细的分析了该器件的工作原理、耦合方式、使用方法。
A tester is made based on the typical circuit of the monostable trigger made of 555 timers. It operation principle, coupling way and usage are analysed in great detail.
介绍了用555定时器构成的单稳态触发器的工作原理，对其功能作了进一步探讨，在此基础上设计了一种具有实用价值的定时-非定时两用开关。
The working principle and the functions of the monostability multivibrator composed of 555 timer are introduced in the paper, and the time switches are designed.
使用单稳态触发器74ls221对送给MC 1311CMOS摄像机的同步信号进行整形。使用AT 24 C02对数据进行存储，实现了数据的掉电保护。
The synchronous signal of MC1311 CMOS camera is shaped by monostable trigger 74ls221. The data are stored in AT24C02, protected in the case of electricity loss.
最简单的接口使用可重触发的单稳态多谐振荡器。
The simplest interface uses a retriggerable monoflop multivibrator.
变送器触发源电路保证产生的脉冲串具有改善的波形，单稳态电路实现输出波形的稳定。
Pulse train produced by clock circuit of the transducer has improved waveform and output waveform is stable implemented by mono-stability circuit.
其中开关电路由射极耦合触发电器、积分延时电路、单稳态电路三单元构成。
The switch circuit is composed of an emitter-coupled trigger circuit, an integral delay circuit and a monostable circuit.
其中开关电路由射极耦合触发电器、积分延时电路、单稳态电路三单元构成。
The switch circuit is composed of an emitter-coupled trigger circuit, an integral delay circuit and a monostable circuit.
应用推荐