报导了单体电池模拟工况测试和模拟电池寿命测试；
The simulated operating condition test of cells and the simulated battery life test were reported.
系统通过直流放电法测量单体电池内阻，保证了在线监测的可靠性。
The battery inner resistance is measured by DC discharge, which guaranteed the reliability of online monitoring.
在有些应用中，则可能希望测量每一单体电池的电压，包括负载和空载。
In some applications, it may be desirable to measure each cell voltage, both with and without a load.
单体电池性能的均匀性是影响电动自行车用铅蓄电池组使用寿命的重要因素。
The performance uniformity between single cells was the important factor that affect the service life of VRLA batteries for EBs.
本实用新型涉及一种单体电池或子电池组保护电路及电池组均衡放电控制装置。
The utility model relates to a single battery or a sub-battery protection circuit and the battery balanced discharge control device.
进行测量检查每个单体电池的电压、内阻，发现超出范围的电池进行确认、及时更换。
Measurement check each monomer battery voltage, resistance, found beyond the scope of the battery for confirmation, timely replacement.
而利用电池内阻预测单体电池故障是非常有效的，该方法可以替代电池容量试验方法。
The predictive method for cell failure by monitoring the cell impedance is very effective method which can replace the frequently battery capacity test.
通常采用的电池容量试验和通过监测电池电压预测单体电池故障的方法不是理想的方法。
But the normal method of cell failure prediction which depend on the battery capacity test and cell voltage is not ideal method.
不仅可以对整组电池进行维护，而且可以针对落后的单体电池进行充电、放电、活化等。
Not only it can maintain whole group batteries, but also can charge, discharge, activate disabled single cell battery.
由于单体电池的内阻、容量、浮充电压一致性好，因此电池在浮充使用状态下无需均衡充电。
With the good coherence of internal resistance, capacity and floating charge , there is no equalizing charge required during use.
作为电池维护设备，需要输出电压、电流范围宽，满足单体电池或整组电池测试维护的要求。
The battery test and maintain equipments should have the ability of output voltage and current with wide span, in order to satisfy the requirements of both single cell and battery-pack.
电压、电流显示值的校准修正功能：可对电池组总电压、单体电池电压、电流进行校准、修正。
The adjustment and correction of current and voltage function: It can adjust and correct to battery total voltage, single cell battery voltage and current.
本论文工作的突出之处：在系统硬件设计方面采用了一种新的测量蓄电池组中单体电池电压的采样电路；
The outstanding of this study is: for system hardware design, a new voltage measuring circuit, which is used to measure the voltage of the individual battery of batteries is designed;
文中论述了镉镍单体电池中陶瓷金属封接技术、响电池比能量的因素、膜的选择和镉电极对电池性能的影响。
This paper discusses the main problems of ni-cd cell such as leakage at ceramic-metal seal factors effecting on the specific energy density choice of separator and the cadmium electrode.
文中论述了镉镍单体电池中陶瓷金属封接技术、影响电池比能量的因素、隔膜的选择和镉电极对电池性能的影响。
This paper discusses the main problems of Ni-Cd cell, such as leakage at ceramic-metal seal, factors effecting on the specific energy density, choice of separator and the cadmium electrode.
对新的单体电池制作方法，单体电池底部的胶封和电池组的密封以及12v电池的短路电流问题进行详细地介绍和讨论。
The method of flat cell making, the glue sealing for the bottom and the sealing of the battery as well as the problems of the short current of 12v battery were mainly discussed.
在部分荷电状态（PSOC）下采用不同的充电模式，进行了100%放电深度的对比试验，同时对失效单体电池进行了容量恢复实验。
Under the partial state of charge (PSOC) condition, the experiments for 100% depth of discharge were carried out by using different charging algorithms.
在周围街区的每一座建筑单体顶部，类似的太阳能电池组赫然在目。
On top of every single building for blocks around a similar solar array sprouted.
在线测量蓄电池组中各个单体的内阻，分析蓄电池组的一致性，实现蓄电池组健康度的实时监测。
Online measurement of battery internal resistance of each monomer, analysis of the consistency of the battery, battery health degree of real-time monitoring.
提升落后单体容量，预防其进一步加速落后殃及正常电池，提高电池组寿命。
It can increase disabled single cell capacity and battery life so that prevent battery broken further hurt normal battery.
电池隔膜的制备方法有许多种，其中聚合物膜辐射引发接枝功能型单体是电池隔膜制备的重要手段之一。
Radiation induced graft copolymerization of functional monomers onto polymeric membrane is an important method for battery separator preparation.
在单体VRLA蓄电池可靠性指标过低的情况下，可通过多种冗余连接方式来提高电池组的可靠性。
Reliability of battery can be improved by kinds of redundant connection approaches when VRLA battery cell's reliability index is too small.
阀控式铅酸蓄电池的电极和隔膜被紧装配在单体槽中。
The electrodes and the separators in VRLA battery closely assembled against the cell wall.
在确定单体VRLA蓄电池可靠性参数时，可通过现场使用调查或加速寿命试验的办法来求得。
Reliability parameters of VRLA battery cell may be gotten by on-the-spot application investigation and accelerated life testing.
在此基础上进一步得到被遮挡单体光伏电池电压随光伏组件工作电压的变化曲线。
Further more, the voltage curve of shaded cell changing with PV module operation voltage has been gotten.
通过试验，观察了在重力作用下液态水对PEM燃料电池性能及其内部传质的影响，分析了PEM燃料电池单体电极的不同摆放位置对其性能的影响。
In this paper, liquid water on the performance of a PEM fuel cell and mass transport is observed on different electrode relative position under gravity effect by experiment.
采用低温等离子体辉光放电技术，用含氟有机单体在硅太阳电池表面聚合成膜。
This paper describes the polymerization of monomer containing fluorine by the low-temperature plasma glow discharge to produce the antireflective films which deposited on textured solar cells.
根据所选用的单体镍氢电池的特点，以及荷电状态SOC均衡方法来确定电池包参数测量点的数量。
According to feature of individual battery and equalization method for state of charge (SOC), the number of measuring points is determined.
根据所选用的单体镍氢电池的特点，以及荷电状态SOC均衡方法来确定电池包参数测量点的数量。
According to feature of individual battery and equalization method for state of charge (SOC), the number of measuring points is determined.
应用推荐