• 氮气空气退火时,退火温度升高前者表现为红移而后者表现为蓝移,归属量子尺寸效应

    The optical absorption edges red-shift along with the increase of annealing temperature under nitrogen and blue-shift under air were observed, which can be attributed to the quantum size effect.

    youdao

  • 此外,随退火温度升高电薄膜自发极化强度先增强减弱

    The spontaneous polarization of ferroelectric films was strengthened and then weakened with the increasing of annealing temperature.

    youdao

  • 试验结果表明随着退火温度升高药型显微硬度明显降低内部晶粒呈现等轴晶形态

    Experimental results indicate that the micro-hardness of electroformed nickel shaped charge liner decreases obviously as the annealing temperature rising and the grains show equiaxed in shape.

    youdao

  • 同时随着退火温度升高光致发光光谱峰值能量位置低能

    At the same time, the peak energy positions of PL spectra shift toward lower energies with the increase of the annealing temperature.

    youdao

  • 纳米发光退火温度升高量子尺寸效应

    As the annealing temperature increases the red shift of PL peak from nc si shows the quantum size effect.

    youdao

  • 实验表明发光峰值能量退火温度升高低能

    The experimental results shows that PL peak energy positions shift towards the lower energy with annealing temperature increasing.

    youdao

  • 退火温度升高,合金丝电阻下降热电升高

    As the annealing temperature rises, the resistivity of alloyed wire reduced and thermal potential raised.

    youdao

  • 退火温度进一步升高前者韧性急剧下降,而后者变化不大

    When annealing temperature increase further toughness of the former will be greatly decreased toughness of the latter will be changed little.

    youdao

  • 结果表明:纳米氧化铝扩散率退火温度升高而减小

    The results show that the thermal diffusivity decrease with annealing temperature elevating.

    youdao

  • 合金最佳中间退火温度随碳含量增加而升高

    The optimal middle annealing temperature increases with the increase of the carbon content.

    youdao

  • 随着退火温度升高电阻减小

    With increasing the annealing temperature, electrical resistivity decreases.

    youdao

  • 饱和磁化强度随退火温度升高逐渐增大

    Special saturation magnetization increases gradually with the increase of annealing temperature.

    youdao

  • 溅射工艺制备出场接触电阻退火温度升高下降趋势且溅射工艺的接触电阻比印刷工艺更小

    The back ohmic contact resistance of Al-BSF by DC magnetron sputtering is downtrend with the annealing temperature increasing, and less than that by the screen printing process.

    youdao

  • 受非马氏体组织的影响及可动位错密度降低的作用,屈服强度屈强比随退火温度升高升高

    The yield strength, yield ratio increase with the increase of annealing temperature, due to the impact of non-martensite and the decrease of movable dislocation density.

    youdao

  • 薄膜表面的粗糙度内部结晶度随着退火温度升高增大。

    The roughness and crystallinity of the films actually became lager with the increasing in annealing temperatures.

    youdao

  • 最终退火温度升高立方织构占有率快速增长

    The occupancy of cube-texture increases fast with the increase of final annealing temperature.

    youdao

  • 韧性——脆性转变温度铸态退火含量的增加而升高

    The ductile-embrittlement transition temperature of vermicular graphite cast iron increased with increasing phosphorus content both in the as-cast and annealed condition.

    youdao

  • 覆层材料体积增加、扩散退火温度升高扩散退火时间的延长而升高

    Conductivity was increased with the increase of volume ratio, annealing temperature and annealing time.

    youdao

  • 退火温度升高保温时间增长,衍射峰增强

    The higher the annealed temperature and the longer the annealed time, the stronger the new diffraction peaks.

    youdao

  • 结果表明退火温度升高时间延长,残余应力明显下降趋势。

    The results show that the residual stress obviously decreases with the increase of annealing temperatures and time.

    youdao

  • 退火后薄膜中的晶粒尺寸密度都有所提高退火温度升高退火时间延长都有助于结晶状态改善。

    High anneal temperature and long anneal time do good on increasing the size and density of silicon nano-crystals.

    youdao

  • 程度退火温度升高

    The extent of crystallization increased with the annealing temperature.

    youdao

  • 结果表明退火状态的钛合金固熔时效态的试样应力难于松弛这种差异温度升高而减小。

    The result shows that the stress is more difficult to relax in ti alloy under annealing than in solution and aging, but this difference decreases, depending on the temperature increase.

    youdao

  • 退火温度升高镀层摩擦系数呈现出降低升高变化趋势,磨损逐渐增大

    Although the specific wear rates of the coatings increase obviously as the annealed temperature increase, the coefficient of friction exhibits decrease first and then increase.

    youdao

  • 结果随着变性温度的降低退火温度升高PCR扩增效率降低,产物量明显减少。

    Change the temperatures for denaturalization and annealing and observe their effect on PCR result.

    youdao

  • 结果随着变性温度的降低退火温度升高PCR扩增效率降低,产物量明显减少。

    Change the temperatures for denaturalization and annealing and observe their effect on PCR result.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定