如何在虚拟系统中传输和运行脚本包。
How to transfer and run a script package in a virtual system.
例如，- d选项将显示您的通信子系统所接收的、传输的和丢弃的数据包的总数。
For example, the -d option shows the overall number of packets received, transmitted, and dropped in your communication subsystem.
网络流量由IP信息包(或，简称信息包)—以流的形式从源系统传输到目的地系统的一些小块数据—组成。
Network traffic is made up of IP packets or simply packets — small chunks of data traveling in streams from a source system to a destination system.
数据包越大，所需要传输的数据包就越少，从而提高系统的带宽使用率。
Larger packets require less packet transfers, which result in higher bandwidth utilization on your system.
报警系统。报警传输系统和设备。第1 - 5部分：包交换网络PS N用要求。
Alarm systems - Alarm transmission systems and equipment - Part 1-5: requirements for Packet Switched Network PSN.
针对网络化控制系统(ncs)具有不确定性的传输迟延与数据丢包特性，设计了一个分布式的网络化控制系统模型。
With regards to the characteristics of uncertain transmission delay and packet dropout of networked control system (NCS), a distributed model is proposed in this paper.
对时变时延多包传输网络控制系统的指数稳定性和控制器设计问题进行研究。
Exponential stability and controller design problems for networked control system (NCS) with time-varying delay and multiple-packet transmission were studied.
针对网络带宽的限制，在网络控制系统中需要采用多包传输。
Considering the constraints of network bandwidth, multiple-packet transmission was adopted here in the networked control system.
经过实验证明，本系统能够有效拦截、监控及处理所有网络数据包，保证信息传输的合法性及安全性。
The experiments prove that the system can capture and monitor all network packets effectively, and achieve the validity and security of information transmission.
在考虑系统噪声和网络诱导延时大于一个采样周期的情况下，给出了多包传输的网络控制系统模型。
The model of NCS with multiple-packet transmission is presented considering system noise and network-induced delay longer than one sampling period.
其次，在考虑系统噪声和延时可以大于一个采样周期的情况下，提出了单包传输和多包传输的网络控制系统的模型。
Secondly, the model of NCS with single-packet and multiple-packet transmission under considering system noise and network-induced delay longer than one sampling are proposed.
以基于CANBUS现场总线技术的FBCAN 2ct隔离型脉冲测量智能节点为例，介绍系统构成、数据包传输格式、软件设计。
This paper introduces the system structure, the transfers format of the data package and the software design of the FBCAN-2CT isolated pulses measurement node based on CANBUS.
卫星传输大震速报系统的软件包由数据采集和检测定位两个模块组成。
The software package of large earthquake rapid alerting system of satellite transmission is composed of two modules: data collection and test location.
针对短时延的多包传输网络控制系统，研究了数据包传输次序不确定情况下系统的建模及控制问题。
For the networked control systems with multi-packet transmission and uncertain short time delay, system modeling and control problem are studied in the case of uncertain packet transmission sequence.
在考虑了单包传输、多包传输、数据包丢失、延时、随机干扰等情况下，用一种统一的形式，建立网络控制系统的模型。
An uniform model is developed to describe the augmented plant considering single-packet transmission, multiple-packet transmission, packets dropout, network-induced delay and noise etc.
文章分析了基于RTP的MPEG - 4视频传输框架，给出了MPEG - 4视频流的RTP组包算法，实现了一个基本的实时视频传输系统。
The article analyzed the MPEG-4 video transmission based on the RTP framework, given the MPEG-4 video stream RTP Group packages algorithms to achieve a basic real-time video transmission system.
但由于通讯网络的引入，使得网络化控制系统中存在如网络时延、调度的优化、数据的多包传输及丢失等新问题。
However, some new issues such as network-induced time delay, network scheduling, multiple-packet transmission and dropping packets also appear.
TLI通过对传输层数据包进行分析并结合P 2 P系统所表现出来的流量特征，来识别某个网络流是否属于P 2 P。
By analyzing packets of the transport layer and the traffic characteristic in the P2P system, TLI can identify whether or not the network data flow belongs to the P2P system.
然后在这个模型的基础上，分别得到了系统的平均下行传输速率和数据包呼叫请求阻塞概率。
Based on this model, the average downlink transmission rate and the call blocking probability of packets can be obtained.
由于网络带宽的限制以及网络的不可靠传输等特点，不可避免的使系统中存在数据包丢失的现象。
Due to the bandwidth constraint and the unreliable transmission of network, data-packet dropout exists inevitably in networked control system.
针对网络控制系统中数据包传输的时序错乱问题，本文用附加缓冲器方法加以克服。
For the wrong order of data packets in NCS, The additional buffer method is put forward to deal with the problem in this report.
把多包传输网络控制系统建模为具有一定切换规则的线性切换系统模型。
The NCS is modelled as models of linear switched control systems under certain switching sequences.
把多包传输网络控制系统建模为具有一定切换规则的线性切换系统模型。
The NCS is modelled as models of linear switched control systems under certain switching sequences.
应用推荐