如果有大的加速度，周期就短，那就是，你们所看到的。
If I have a high acceleration, the period will be short, and that's exactly what you see.
如果加速度减小，振荡周期变大。
If the acceleration goes down, the period of oscillation goes up.
所以现在回复力加倍，物体质量加倍，加速度不变，周期不变。
So now the restoring force doubles and the mass doubles, the acceleration remains the same, the period remains the same.
对于时间周期长于半秒，加速度的均值相对于陀螺仪占得比重更大，这时可能会有漂移。
For time periods longer than half a second, the accelerometer average is given more weighting than the gyroscope, which may have drifted by this point.
该仿真系统不仅可以用于仿真NC程序文件的执行过程，而且实现了以控制周期为单位，对速度、加速度曲线以及加工时间、加工距离的仿真。
The system can simulate the executive process of nc programme files, and realize the simulation of speed and acceleration curve, and process time and distance with the unit of controlling period.
通过单摆装置可以方便地研究单摆的振动周期与摆长关系和测定当地的重力加速度。
Using the single pendulum, we can research the relationship between the period of oscillation of it and the length of it and measure local acceleration of gravity.
利用此套技术可对实时传输的加速度记录同步进行长周期基线校正、积分求速度及积分求位移。
By using this technique, the baseline of transmitting acceleration data in real time is adjusted, and the velocity and the displacement are integrated synchronistically.
通过运动学分析，得出平面变胞机构在一个运动周期中输出杆件的位置、速度和加速度以及平面变胞机构的其他杆件的运动学参数。
Through the kinematic analysis, the positions, speeds and accelerations of the output link as well as the other links of the planar metamorphic mechanisms can be obtained.
对于时间周期小于半秒，陀螺仪的积分将会占优，水平加速度的噪声将会被滤去。
For time periods shorter than half a second, the gyroscope integration takes precedence and the noisy horizontal accelerations are filtered out.
通常检测的机械振动加速度信号，由于信噪比太低，即使存在周期性的冲击分量也往往被淹没在强的背景噪声之中。
However, in respect of a vibration acceleration signal, the signal to noise ratio (SNR) is often so small that the periodic impulse component is submersed in its intense background noises.
本文讨论了利用国际部署加速度仪台网(IDA)的超长周期瑞雷波记录，反演震源参数的有关理论和方法。
In this paper, the method and theory relevant to inversion for source parameters by using long-period Rayleigh waves on IDA accelerograms (International Deployment of Accelerograph) are discussed.
衍化算法通过对剩余航程的估算，周期性更新参考阻力加速度剖面。
Basing on the estimated range-to-go, the reference drag acceleration profile is updated every period.
通过时域波形和频谱等基本分析手段来探测振动加速度信号中的周期性冲击分量往往是困难的。
It is difficult to detect the periodic impulse component in the vibration acceleration signal with conventional analysis methods such as time domain wave and frequency spectrum.
研究结果表明：在简谐地面加速度作用下，高频地震动也可以引起长周期结构产生很大的位移反应，且最大位移反应出现在结构的瞬态自由振动阶段。
It is concluded that the transient response to a high frequency harmonic ground motion can increase greatly the displacement response of structures, particularly for the long period structures.
竖向反应谱及竖向与水平向加速度反应谱比是周期的函数、并与场地条件及震源距相关。
The results show that the V/H peak acceleration ratios are reduced as the distance of site to the fault is increased, and the vertical response spectra and …
所提出的测试方案和辨识方法解决了地球自转角速度对陀螺加速度计的输出造成周期性误差这一重要问题。
The test scheme and identification method were given which solved the problem of periodic error caused by the earth rotation angular velocity.
最后，对插补周期内节点的轨迹进行了规划，以确保运动轨迹满足速度、加速度以及加加速度的平滑约束条件。
At last, a trajectory planning strategy was put forward to guarantee the trajectory in the interpolation process meeting the smoothed constraints of velocity, acceleration and jerk.
因此，加速度搜索对小于50分钟的轨道周期不敏感，而边频带搜索对大于3分钟的轨道周期也不敏感。
Thus, the acceleration search becomes significantly less sensitive for orbital periods shorter than 50 minutes. The sideband search loses sensitivity for orbital periods longer than 3 minutes.
新台币电机有一个非常低的应用需求高的惯性加速度和周期率。
The NT motor has a very low inertia for applications that demand high accel and cycle rates.
对于时间周期长于半秒，加速度的均值相对于陀螺仪占得比重更大，这时可能会有漂移。
The change in position is just the speed of the car multiplied by the time since the last tick, which you can get from the timers on the microcontroller or some other known timer.
对于时间周期长于半秒，加速度的均值相对于陀螺仪占得比重更大，这时可能会有漂移。
The change in position is just the speed of the car multiplied by the time since the last tick, which you can get from the timers on the microcontroller or some other known timer.
应用推荐