尝试利用微波加热法合成抗菌沸石。
The microwave heating method to synthesize antibacterial zeolites was tested.
证明脉冲加热法氮释放完全。
It has been demonstrated that nitrogen release in pulse heat is quantitative.
方法：微波快速加热法。
应用微波加热法对土壤中有机质含量进行测定。
Organics in soil was determined by microwave heating with analyzing determining conditions.
方法：微波加热法。
为了熔化进料，可用射频感应加热或电阻加热法。
To melt the charge radio frequency induction heating or resistance heating have been used.
为了熔化进料，可用射频（感应加热）或电阻加热法。
To melt the charge, radio frequency(induction heating)or resistance heating have been used .
初步研究了加热法处理船舶压载水对外来生物存活的影响。
This paper discusses the effect of heat on the survival of non indigenous organisms in ballast water.
常规加热法合成样品的晶形较为圆滑，而微波合成样品为块状。
The crystal form of the product gained by conventional heating is smooth, while it is lumpish for the product gained by microwave heating.
本文介绍了纺程加热一步法制取充分结晶纤维中的远红外加热法。
One of the heating tube process-far infrared heating process was investigated for producing fully crystallized PET fiber.
用分步加热法分析了注入气体释放模式及岩石对氩气的保留能力。
The release modes of implanted gases, and the retention of rocks to argon were investigated by stepwise heating.
与催化加热法的接枝效果相比，微波等离子体法得到的接枝率更高。
Compared with the method of heatcatalysis initiation, graft yield by MWP initiation is higher than that of heatcatalysis method.
电镀后用加热法除内应力或电镀时与1%的铅共沉积可避免这一特性。
After plating with heating except with 1% of the internal stress or plating of sedimentary can avoid this lead a characteristics.
用烘箱加热法、油浴法、沸水浴法测定橡胶树不同器官的有机碳含量。
Three methods including oven-heating, oil bath, and boiling water bath were used to determine organic carbon content in different organs of rubber trees.
在天然气处理厂内对设备和管道系统焊缝的热处理一般采用电阻加热法。
In natural gas treatment plant, generally used is resistance heating method for heat treatment in welding lines of equipment and pipeline systems.
以炭黑和二氧化硅微粉为原料，对双重加热法合成碳化硅晶须进行了研究。
The synthesis of silicon carbide whiskers by double-heating method using carbon black and SiO_2 powder as raw materials is studied.
根据试验结果和钢包化学加热法的特点对硅系合金作非铝发热剂进行了评价。
Evaluation on silicon alloy as non aluminothermic was carried out according to the experimental results and the characteristics of chemical heating.
该系统利用电加热法对热电偶的时间常数进行在线校验，同时还可进行温度测量。
Time constant of thermocouple is checked on line with an electric heating method, and with the same thermocouple temperature is measured.
目的：探讨微波加热法处理聚甲基丙烯酸甲酯(pmma)基托材料的力学性能。
Objective: To study the mechanical properties of microwave cured polymethylmethacrylate (PMMA) denture base resins.
研究了以膨润土提铝残渣为原料，采用低温加热法直接合成有机硅化合物新方法。
A new method is presented for the synthesis of pentacoordinate silicon complexes directly from residues left behind extracting of aluminum from bentonite by the low-temperature heating method.
通过误差分析及湿度探针的校验表明双区加热法测量蒸汽湿度能够满足测量的要求。
The double region heating method is suitable for monitoring wetness fraction of steam turbine exhaust on line, which is proved by the error analysis and the calibration of wetness probe.
其常用的方法有真空低温加热法、液氮法、胶囊法、风味配对法、泡沫法、分解法等。
The commonly employed approaches include vacuum low-temperature heating, liquid nitrogen method, capsule method, flavor pairing method, bubble method, decomposition method, and so on.
研究了用电加热法解决用于动态气流温度测量的小惯性热电偶时间常数的实验测定问题。
This paper studies the method of measuring the time constant of the fast thermocouples which are used to measure a dynamic temperature in air flows.
文中给出了用真空加热法测得的6110型柴油机微粒的可溶有机物和干烟的排放特性。
Soluble organic fraction and dry soot emissions from 6110 type diesel engine under different operating conditions are measured by vaccum volatilization and presented in the paper.
采用分步加热法收集慢源岩流体包裹体中的气态物质，并用质谱计分析了这些气态物质的组成。
Gases from mantle xenoliths have been collected by step-heating method and have been analysed by MS.
在此条件下，肉桂酸的产率能达到67.17%，高于传统加热法的产率(40- 50%)。
Under the optimum condition the yield of cinnamic acid was 67.17%, which was higher than the yield (40-50%) obtained under traditional heating method.
高压釜采用红外线加热法和独特的结构设计，高压釜能在较短时间内达到设定的温度，开始蒸压。
Autoclave using infrared heating and the unique structural design, high pressure reactor can be achieved within a few minutes to set the temperature, started autoclaved.
采用电加热法加热时，需注意热电偶及加热圈的安装要尽可能靠近坡口，但不得妨碍焊工接近接头。
When an electric heating method is used for heating, thermal couple and heating coil should be installed closest to the bevel while should not hinder the access of welder to the joint.
探讨了直接加热法、直接水蒸汽法、间接水蒸汽法、减压蒸馏、酒精沉淀等五种回收方法的优缺点。
The advantage and disadvantage of the five recycling methods, direct heating, direct aqueous vapor, indirect aqueous vapor, reduced pressure distillation, precipitation method, is discussed.
探讨了直接加热法、直接水蒸汽法、间接水蒸汽法、减压蒸馏、酒精沉淀等五种回收方法的优缺点。
The advantage and disadvantage of the five recycling methods, direct heating, direct aqueous vapor, indirect aqueous vapor, reduced pressure distillation, precipitation method, is discussed.
应用推荐