FDV受一个设置在设备加热段出口的温度传感器控制。
The FDV is controlled by a temperATure-sensing device locATed AT the exit of the heATing section of the system.
装置的设计关键为加热段与缓冲、分离段之间的隔断结构的设计制造和泵的减振措施。
Shutdown structure posited between heating interval and buffering-separating interval and measures for absorption of vibration of the bump are the designing key.
通过调整双螺杆挤出机的螺杆转速、不同加热段的温度，确定了接枝反应的最佳工艺条件。
By adjusting the screw speed of the twin-screw extruder, temperatures of different heating stages, the optimal processing conditions for grafting reactions are determined.
本文提出了热管换热器加热段和冷却段的三种长度比：流通长度比、经济长度比和许用安全长度比。
Three kinds of length ratio of evaporator to condenser of heat pipe heat exchangers are proposed: the flow length ratio, the saving length ratio, and the allowable safety length ratio.
根据二维piv测试技术的原理，用高速摄像仪对各加热段炉膛进行示踪粒子拍摄和速度分布测量。
Based on the principle of PIV test, with tracing particles, the highspeed camera was adopted to record velocity field.
研究结果表明：在发生静态流量漂移时，系统循环流量下降、加热段的进口温度下降而出口温度上升；
The experimental results show that in the process of flow excursion the mass flow rate and the inlet temperature decreases, while the exit temperature increases smoothly.
当热管起动运行的一瞬间，加热段与绝热段温度出现一不变的温度段，冷凝段出现一大幅度的温度跳跃。
At the instant when heat pipe begins running, the evaporator and adiabatic section temperature have an unchanged region, while condenser temperature increases greatly.
以常压去离子水为工质，对自然循环工况下上升加热段内单相水的摩擦阻力及对流传热特性进行了实验研究。
The friction and convective heat transfer of single phase water flow in a vertical heated tube at natural circulation condition were experimentally investigated.
以常压去离子水为工质，对自然循环工况下上升加热段内单相水的摩擦阻力及对流传热特性进行了实验研究。
The investigation on heat transfer of single phase liquid flow in a tube with natural circulation is performed.
将出无氧化加热段的带钢继续加热到热处理制度要求的温度，并在保护气氛中对带钢表面微弱的氧化膜起还原作用。
The strip is heated here to required temperature and the light oxide film on the strip is reduced by protection atmosphere.
实验结果表明，自然循环工况下上升加热段内工质的物性变化及由浮升力引起的自由流动对对流传热特性有重要影响。
The experimental results indicate that free convection caused by the buoyancy in the heated tube with natural circulation has great influence on the heat transfer characteristics.
每次推钢后通过计算机多次模拟钢坯在加热段和均热段内的加热过程，采用遗传算法选出最优的加热炉炉温和推钢时间。
The heating process inside the furnaces of the billets can be simulated multiply times by computes and best control parameters of the furnaces can be determined.
结果表明：忽略加热段内蒸汽温度的轴向变化及蒸汽流动的径向变化，钠热管声速限与实际误差在10%以内。 理论与实验较为吻合。
When the radial component of the vapour velocity and the axial variation of the vapour temperature were neglected, the error of the sonic limit is within 10 per cent.
每隔一段时间启动引擎和加热器。
把姜、葱切成段，用大火把锅加热，火焰就像炼钢炉里的一样。王师傅演示的就是他一直坚持的正宗做法。
Dicing ginger and chives on a cutting board, then heating his wok on a stove whose intense, shooting flames looked like a furnace blast, Mr. Wang demonstrated what he insisted was the genuine item.
无氧化段由入口密封室，废气预热区，直接加热区，炉喉，废气排放系统组成。
The non-oxidizing zone is consisted of entry sealed room, waste gas preheating zone, direct heating zone, and furnace nozzle and flue gas exhausting system.
首先要将橄榄油在沙锅里加热，后放入肉丝煎炒，再加上调过味的牛尾煎一段时间，注意不要把肉丝煎糊。
First you heat up some olive oil in a casserole, fry some bacon cubes in this, add seasoned oxtail and brown them for a few minutes, taking care not to burn the bacon.
为什么不帮助他们恢复记忆，开始另一阶段的渲染更加热情？
Why not help them revive the memories, and begin another phase of romancing with greater passion?
如果把钢缓慢加热到恰好低于临界温度并且保持较长一段时间，就能得到这种组织结构。
If steel is heated slowly to a temperature just below the critical range and held there for a prolonged period of time, this structure will be obtained.
退火工艺的组成为把钢加热到一定温度并保持一段时间，通常再缓慢冷却。
The process of annealing consists of heating the steel to an elevated temperature for a definite period of time and, usually, cooling it slowly.
采用SQG系列清管机消除一段分解加热器列管中垢层，收到了意想不到的效果，具有显著的经济效益和社会效益。
The use of series SQG tube cleaners for the removal of scale in tube array of heater for first stage decomposition gives unexpected results, with remarkable economic and social benefits.
把陈醋加热，关上门窗，隔一段时间在房间里熏蒸一次，可有效杀除感冒等病毒。
Heat the vinegar, close doors and Windows, fumigate in the room from time to time, which can effectively kill the flu virus.
锻造钢锭多采用热锭加热，其特点是在恒温炉中一段加热和在变温炉中两段或三段加热方式。
Hot ingots are often heated in forging furnaces, the feature of which is one-stage type in a constant temperature furnace and two-or three stage type in a temperature-variable furnace.
方法：壳聚糖的水溶液加入一定量的双氧水，加热搅拌一段时间进行降解。
Method: The hydrogen peroxide was added into the chitosan water solution, heated and stirred for some time.
施加到导电薄膜上的电流脉冲将调制器段及其内部的固定相加热，释放出作为浓度脉冲的保留物质。
An electrical current pulse applied to a thin conductive film heats the modulator section and the stationary phase within it, releasing a certain number of retained substances as concentration pulses.
它易于操作，并提供一条可设置的加热曲线和一段保温时间。
It is very easy to operate and offers one settable heating-up ramp and one holding time.
高压加热器由凝结段组成。
High-pressure heater is composed by the condensate sections.
退火。退火工艺的组成为把钢加热到一定温度并保持一段时间，通常再缓慢冷却。退火是为了产生均匀化从而建立起有一致的特有性质的标准均匀化组织。
Tool steel is generally purchased in the annealed condition. Sometimes it is necessary to rework a tool that has been hardened, and the tool must then be annealed. For.
系统硬件包括按钮开关输入电路、七段数码管输出电路、加热电路、升压电路以及波形控制产生电路。
The system hardware includes switch input circuit, seven segments LED output circuit, heating circuit and boost circuit.
烘箱分三段加热，温度分别自动控制。
The temperature is automatically controllable in the three-section drying oven respectively.
应用推荐